- 您現在的位置：買賣IC網 > PDF目錄381306 > AS1706-T (AUSTRIAMICROSYSTEMS AG) 1.6W Audio Power Amplifiers; Package Type: MSOP-8; Shutdown: Active Low PDF資料下載
參數資料
| 型號： | AS1706-T |
| 廠商： | AUSTRIAMICROSYSTEMS AG |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 1.6W Audio Power Amplifiers; Package Type: MSOP-8; Shutdown: Active Low |
| 中文描述： | 1.6 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| 封裝： | MSOP-8 |
| 文件頁數： | 11/18頁 |
| 文件大?。?/td> | 433K |
| 代理商： | AS1706-T |
11 - 18
AS1701, AS1706
Datasheet - Application Information
9 Application Information
BTL Amplifier
The AS1701/AS1706 are designed to drive loads differentially in a bridge-tied load (BTL) configuration.
Figure 30. Bridge-Tied Load Configuration
Driving the load differentially doubles the output voltage (illustrated in
Figure30
) compared to a single-ended amplifier under simlar conditions.
Thus, the differential gain of the device is twice the closed-loop gain of the input amplifier. The effective gain is calculated by:
Substituting 2 x V
OUT(P-P)
into (EQ 3) and (EQ 4) yields four times the output power due to doubling of the output voltage.
Since the differential outputs are biased at md-supply, there is no net DC voltage across the load, elimnating the need for the large, expensive,
performance degrading DC-blocking capacitors required by single-ended amplifiers.
Power Dissipation and Heat Sinking
Normally, the devices dissipate a significant amount of power. The maximumpower dissipation is given in
Table 2
as Continuous Power Dissipa-
tion, or it can be calculated by:
where T
J(MAX)
is +150°C, T
AMB
(see
Table 2
) is the ambient temperature, and
Θ
JA
is the reciprocal of the derating factor in °C/W.
The increased power delivered by a BTL configuration normally results in increased internal power dissipation versus a single-ended configura-
tion. The maximuminternal power dissipation for a given V
DD
and load is calculated by:
If the internal power dissipation exceeds the maximumallowed for a given package, power dissipation can be reduced by increasing the ground
plane heat-sinking capabilities and increasing the size of the traces to the device
(see Layout and Grounding Considerations on page 14)
. Addi-
tionally, reducing V
DD
, increasing load impedance, and decreasing ambient temperature can reduce device power dissipation.
+1
-1
V
OUT(P-P)
V
OUT(P-P)
2 x V
OUT(P-P)
A
VD
= 2 x
R
IN
(EQ 2)
R
F
V
RMS
=
2 2
(EQ 3)
V
OUT(P-P)
P
OUT
=
R
L
(EQ 4)
V
RMS
2
P
DISSPKF(MAX)
=
Θ
JA
(EQ 5)
T
J(MAX)
-T
A
P
DISSPKF(MAX)
=
π
2
R
L
(EQ 6)
2V
DD
2
相關PDF資料 |
PDF描述 |
|---|---|
| AS1702-T | 1.8W diff audio amp mono, adj.; Package Type: MSOP-10; Miscellaneous: adj. Gain |
| AS1702V-T | 1.8W diff audio amp mono, adj.; Package Type: DFN(3x3)-10; Miscellaneous: adj. Gain |
| AS1704 | 1.6W Single-Channel Audio Power Amplifiers |
| AS1702 | 1.6W Single-Channel Audio Power Amplifiers |
| AS1703 | 1.6W Single-Channel Audio Power Amplifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AS1708-SC | 功能描述:SPEAKER 8OHM .3W 88DB 13MM RoHS:否 類別:音頻產品 >> 揚聲器 系列:AS 產品目錄繪圖:PSR-40(F08S02,N08A05,N08A)-JQ Top PSR-4(0,5)N08A-JQ Side 特色產品:Miniature Speaker Series of Audible Alarms 標準包裝:1 系列:- 類型:磁性 頻率范圍:500Hz ~ 6kHz 阻抗:8 歐姆 聲壓級:87dB 功率 - 額定:0.25W 功率 - 最大:0.5W 高度:4.80mm 尺寸/尺寸:40.00mm 直徑 形狀:圓形 端子:焊盤 材料 - 錐體:聚酯薄膜 材料 - 磁體:鐵氧體 產品目錄頁面:2656 (CN2011-ZH PDF) 其它名稱:458-1132 |
| AS170-92 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SPDT RF Reflective Switch |
| AS-170M | 功能描述:3M VISOR SURROUND ASSEMBLY A 制造商:3m 系列:* 零件狀態:在售 標準包裝:1 |
| AS1710 | 制造商:AMSCO 制造商全稱:austriamicrosystems AG 功能描述:High-Output-Drive, 10MHz, 10V/us, Rail-to-Rail I/O Op Amps with Shutdown |
| AS1710_04 | 制造商:AMSCO 制造商全稱:austriamicrosystems AG 功能描述:High-Output-Drive, 10MHz, 10V/??s, Rail-to-Rail I/O Op Amps with Shutdown |
發布緊急采購，3分鐘左右您將得到回復。