- 您現在的位置：買賣IC網 > PDF目錄381304 > AS1361-BTTT-45 (AUSTRIAMICROSYSTEMS AG) 150mA 9μVrms, 92dB, POK; Package Type: TSOT23-6; Output Range: 4.5V PDF資料下載
參數資料
| 型號： | AS1361-BTTT-45 |
| 廠商： | AUSTRIAMICROSYSTEMS AG |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 150mA 9μVrms, 92dB, POK; Package Type: TSOT23-6; Output Range: 4.5V |
| 中文描述： | 無電容，NMOS管，150mA的低壓差穩壓器的反向電流保護 |
| 封裝： | TSOT23-6 |
| 文件頁數： | 12/15頁 |
| 文件大?。?/td> | 730K |
| 代理商： | AS1361-BTTT-45 |
www.austriamicrosystems.com
Revision 1.03
12 - 15
AS1361/AS1362
Datasheet - Application Information
9 Application Information
Capacitor Selection and Regulator Stability
For normal operation, use a 1μF capacitor at pin IN and a 1μF capacitor at pin OUT. Larger input capacitor values and
lower ESR provide better noise rejection and line-transient response. Reduce output noise and improve load-transient
response, stability, and power-supply rejection by using large output capacitors.
Note:
Some ceramic dielectrics exhibit large capacitance and ESR variation with temperature. With dielectrics such
as Z5U and Y5V, it may be necessary to use a 2.2μF or larger output capacitor to ensure stability at tempera-
tures below -10°C. With X7R or X5R dielectrics, 1μF is sufficient at all operating temperatures.
Bypass Capacitor
Use a 0.01μF bypass capacitor at pin BYPASS for low-output voltage noise reduction. The leakage current going into
pin BYPASS should be less than 10nA. Increasing the capacitance slightly decreases the output noise. Values above
0.1μF and below 0.001μF are not recommended.
Noise, PSRR, and Transient Response
The AS1361/AS1362 are designed to deliver ultra-low noise and high PSRR, as well as low dropout and low quiescent
currents in battery-powered systems. The power-supply rejection is 92dB at 1kHz and 62dB at 100kHz.
(see PSRR vs.
Frequency; IOUT = 10mA on page 7)
.
When operating from sources other than batteries, improved supply-noise rejection and transient response can be
achieved by increasing the values of the input and output capacitors, and through passive filtering techniques.
The
Figure 16
and
Figure 14 on page 8
show the AS1361/AS1362 line- and load-transient responses.
Dropout Voltage
The AS1361/AS1362 minimum dropout voltage determines the lowest usable supply voltage. In battery-powered sys-
tems, this determines the useful end-of-life battery voltage.
Since the AS1361/AS1362 use a P-channel MOSFET pass transistor, the dropout voltage is a function of drain-to-
source on-resistance (R
DS(ON)
) multiplied by I
LOAD
(see Figure 6 on page 6)
.
相關PDF資料 |
PDF描述 |
|---|---|
| AS1362-BTTT-15 | 300mA 9μVrms, 92dB, POK; Package Type: TSOT23-6; Output Current: 300; Output Range: 1.5V |
| AS1362-BTTT-18 | 300mA 9μVrms, 92dB, POK; Package Type: TSOT23-6; Output Current: 300; Output Range: 1.8 |
| AS1362-BTTT-25 | 300mA 9μVrms, 92dB, POK; Package Type: TSOT23-6; Output Range: 2.5V |
| AS1362-BTTT-26 | 300mA 9μVrms, 92dB, POK; Package Type: TSOT23-6; Output Current: 300; Output Range: 2.6 |
| AS1362-BTTT-27 | 300mA 9μVrms, 92dB, POK; Package Type: TSOT23-6; Output Range: 2.7V |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AS1362 | 制造商:AMSCO 制造商全稱:austriamicrosystems AG 功能描述:150mA/300mA, Ultra-Low-Noise, High-PSRR Low Dropout Regulators, with POK |
| AS1362-15 EB | 制造商:ams 功能描述:BOARD EVAL FOR AS1362-15 |
| AS1362-18 EB | 制造商:AMS 功能描述:BOARD EVAL FOR AS1362-18 |
| AS1362-18-EB | 制造商:ams 功能描述:AS1362 Evaluation Board |
| AS1362-25 EB | 制造商:AMS 功能描述:BOARD EVAL FOR AS1362-25 |
發布緊急采購，3分鐘左右您將得到回復。