- 您現在的位置：買賣IC網 > PDF目錄381303 > AS1341-BTDT (AUSTRIAMICROSYSTEMS AG) 20V, Hyst.600mA Buck Converter; Package Type: TDFN(3x3)-8 PDF資料下載
參數資料
| 型號： | AS1341-BTDT |
| 廠商： | AUSTRIAMICROSYSTEMS AG |
| 元件分類： | DC/DC變換器 |
| 英文描述： | 20V, Hyst.600mA Buck Converter; Package Type: TDFN(3x3)-8 |
| 中文描述： | 20V的，600毫安，100％占空比，降壓型轉換器 |
| 封裝： | TDFN(3x3)-8 |
| 文件頁數： | 11/18頁 |
| 文件大?。?/td> | 599K |
| 代理商： | AS1341-BTDT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
wwwaustriamcrosystems.com/DC-DC_Step-Down/AS1341
Revision 1.08
11 - 18
AS1341
Datasheet - Application Information
9.3 Setting Current Limit
The AS1341 adjustable peak current limt is set by connecting
ILIMIT as shown in
Table 4
.
The current limt chosen should reflect the maximumload current. The maximumoutput current is half of the peak current limt. Choosing a lower
current limt allows using an inductor with a lower current rating, however, it requires a higher inductance
(see Inductor Selection)
and does not
allow for reduced inductor package size.
9.4 Inductor Selection
The AS1341 operates with a wide range of inductance values. For most applications, values between 10μH and 47μH work best with the
controller’s high switching frequency. Larger inductor values will reduce the switching frequency and thereby improve efficiency and EMI.
Note:
The four key factors in inductor selection are inductance value, saturation rating, series resistance, and size.
The trade-off for improved efficiency is a higher output ripple and slower transient response. On the other hand, low-value inductors respond
faster to transients, improve output ripple, offer smaller physical size, and mnimze cost. If the inductor value is too small, the peak inductor
current exceeds the current limt due to current-sense comparator propagation delay, potentially exceeding the inductor’s current rating.
Calculate the mnimuminductance value as follows:
L
MIN
= ((V
INMAX
- V
OUTPUT
) x t
ONMIN
/I
LXPEAK
(EQ 3)
Where:
t
ONMIN
= 1μs
The inductor saturation current rating must be greater than the peak switch current limt, plus the overshoot due to the 250ns current-sense
comparator propagation delay. Saturation occurs when the magnetic flux density of the inductor reaches the maximumlevel the core can support
and the inductance starts to fall. Choose an inductor with a saturation rating greater than IPEAK in the following equation:
I
PEAK
= (I
LXPEAK
+ (V
IN
- V
OUTPUT
) x 250ns)/L
(EQ 4)
Inductor series resistance affects both efficiency and dropout voltage
(see Dropout Voltage on page 9)
. High series resistance limts the
maximumcurrent available at lower input voltages, and increases the dropout voltage. For optimumperformance, select an inductor with the
lowest possible DC resistance that fits in the allotted dimensions.
Table 4. Setting Peak Current Limt
Current Limit
ILIMIT Connected To
700mA
GND
1400mA
IN
Table 5. Recommended Inductors
Part Number
L
DCR
85m
Ω
125m
Ω
345m
Ω
360m
Ω
62m
Ω
57m
Ω
176m
Ω
215m
Ω
36m
Ω
150m
Ω
170m
Ω
400m
Ω
Current Rating
Manufacturer
MSS6132-103ML
10μH
1.4A
wwwcoilcraft.comLPS4018-472ML
4.7μH
1.8A
MSS6132-393ML
39μH
0.8A
LPS4018-223ML
22μH
0.7A
CDRH6D28NP-150
15μH
1.4A
Sumda
wwwsumda.com
CDRH5D18NP-4R1
4.1μH
1.95A
CDRH6D28NP-470
47μH
0.8A
CDRH5D18NP-220
22μH
0.8A
LQH66SN-100M03
10μH
1.6A
Murata
wwwmurata.com
LQH55DN-150M03
15μH
1.4A
LQH66SN-470M03
47μH
0.8A
LQH55DN-470M03
47μH
0.8A
相關PDF資料 |
PDF描述 |
|---|---|
| AS1343A-BTDT-10 | 42V, 1MHz, Single Cell, Boost; Package Type: TDFN(3x3)-10; Temperature Range: -40 - +85 °C; Dimension: 3 x 3 mm; Shutdown: Yes; Output Current: 140mA; Output Range: 5.5 to 42V; Supply Voltage: 0,90-3,60 |
| AS1344-BTDT | 42V DCDC for OLED; Package Type: TDFN(3x3)-10 |
| AS1351-T | Dual LDO with OTP 1.8 to 3.3V; Package Type: QFN(3x3)-12; Output Range: 2 x 3,3V |
| AS1352-7BC0-T | Quad LDO with OTP 1.8 to 3.3V; Package Type: QFN(4x4)-12; Output Range: 1,8V; Output Range: 2,5V; Output Range: 2,9V; Output Range: 3,0V |
| AS1352-C0CF-T | Quad LDO with OTP 1.8 to 3.3V; Package Type: QFN(4x4)-12; Output Range: 1,8V; Output Range: 2 x 3,0V; Output Range: 3,3V |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AS1341-BTDT-1K | 功能描述:IC REG BUCK 5V/ADJ 0.6A 8TDFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:1,000 系列:- 類型:降壓（降壓） 輸出類型:可調式 輸出數:1 輸出電壓:0.6 V ~ 4.5 V 輸入電壓:3 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:3MHz 電流 - 輸出:1.5A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:6-LLP-EP（3x3） 產品目錄頁面:1300 (CN2011-ZH PDF) 其它名稱:LM2831ZSDLM2831ZSDTR |
| AS1341-BTDT-6K | 功能描述:IC REG BUCK 5V/ADJ 0.6A 8TDFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:50 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:5 V ~ 25 V 輸入電壓:2.3 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:600kHz，1.2MHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 包裝:管件 供應商設備封裝:8-MSOP |
| AS1341-CUT TAPE | 制造商:AMS 功能描述:AS Series 20 V 600 mA Surface Mount 100% Duty Cycle Step-Down Converter - TDFN-8 |
| AS1341-EB | 制造商:ams 功能描述:AS1341 Evaluation Board |
| AS1341-TD_EK_ST | 功能描述:AS1341 - DC/DC, Step Down with LDO 1, Non-Isolated Outputs Evaluation Board 制造商:ams 系列:- 零件狀態:有效 主要用途:DC/DC，LDO 步降 輸出和類型:1，非隔離 功率 - 輸出:- 電壓 - 輸出:3.3V 電流 - 輸出:600mA 電壓 - 輸入:4.5 V ~ 20 V 穩壓器拓?fù)?降壓 頻率 - 開關:200kHz 板類型:完全填充 所含物品:板 使用的 IC/零件:AS1341 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。