- 您現在的位置：買賣IC網 > PDF目錄381303 > AS1108WL-T (AUSTRIAMICROSYSTEMS AG) 4-digit, 5mA, serial Int.; Package Type: SOIC-20; Temperature Range: 0 - +70 °C PDF資料下載
參數資料
| 型號： | AS1108WL-T |
| 廠商： | AUSTRIAMICROSYSTEMS AG |
| 元件分類： | LED驅動器 |
| 英文描述： | 4-digit, 5mA, serial Int.; Package Type: SOIC-20; Temperature Range: 0 - +70 °C |
| 中文描述： | LED DISPLAY DRIVER, PDSO20 |
| 封裝： | SOIC-20 |
| 文件頁數： | 7/19頁 |
| 文件大?。?/td> | 587K |
| 代理商： | AS1108WL-T |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁
7 - 19
AS1108
Datasheet - Detailed Description
8 Detailed Description
Serial-Addressing Format
Programming the AS1108 is accomplished by writing to the device’s internal registers (see Digit- and Control-Registers
on page 8) via the 4-wire serial interface. A programming sequence consists of 16-bit packages as depicted in Table 6.
The data is shifted into the internal 16-bit register with the rising edge of the CLK signal. With the rising edge of the
LOAD/CSN signal the data is latched into a digit- or control-register. The LOAD/CSN signal must go high after the 16th
rising clock edge.
The LOAD/CSN signal can also come later but this must happen just before the next rising edge of CLK, otherwise the
data will be lost. The contents of the internal shift register are applied 16.5 clock cycles later to pin DOUT. The data is
clocked out at the falling edge of CLK.
The first 4 bits (D15:D12) are “don't care” settings, bits D11:D8 contain the register address, and bits D7:D0 contain the
data. The first bit is D15, the most significant bit (MSB). The exact timing is shown in Figure 10.
Initial Power-Up
On initial power-up, the AS1108 registers are reset to their default values, the display is blanked, and the device goes
into shutdown mode. All registers should be programmed for normal operation at this time.
Note:
The default settings enable only scanning of one digit; the internal decoder is disabled and the Intensity Control
Register (see page 11) is set to the minimum values.
Figure 10. Interface Timing
Table 6. 16-Bit Serial Data Format
D15
X
D14
X
D13
X
D12
X
D11
Register Address (see Table 7) MSB
D10
D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
LSB
Data
t
CL
LOAD/
CSN
CLK
DIN
DOUT
D15
D14
D1
D0
t
DO
t
CSS
t
DS
t
DH
t
CH
t
CP
t
CSH
t
CSW
t
LDCK
相關PDF資料 |
PDF描述 |
|---|---|
| AS1109-BQFT | 100mA, 8-Bit, Diagnostic; Package Type: QFN(4x4)-16 |
| AS1109-BSOT | 100mA, 8-Bit, Diagnostic |
| AS1109-BSST | 100mA, 8-Bit, Diagnostic; Package Type: SSOP-16 |
| AS1110-BQFT | 100mA, 16-CH, Diagnostics; Package Type: TQFN(5x5)-28 |
| AS1110-BSST | 100mA, 16-CH, Diagnostics; Package Type: SSOP-24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AS1108WL-T-Z | 制造商:AMS 功能描述:0 |
| AS1108-XXX-I-A1-D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog Filter |
| AS1108-XXX-I-A1-S | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog Filter |
| AS1108-XXX-I-A2-D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog Filter |
| AS1108-XXX-I-A2-S | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog Filter |
發布緊急采購，3分鐘左右您將得到回復。