- 您現在的位置：買賣IC網 > PDF目錄378403 > AN1687 (Motorola, Inc.) A FULL-FEATURED WIRELESS INTERFACE FOR RS-232 COMMUNICATIONS PDF資料下載
參數資料
| 型號： | AN1687 |
| 廠商： | Motorola, Inc. |
| 英文描述： | A FULL-FEATURED WIRELESS INTERFACE FOR RS-232 COMMUNICATIONS |
| 中文描述： | 一個全功能的無線接口為RS - 232通信 |
| 文件頁數： | 1/12頁 |
| 文件大?。?/td> | 166K |
| 代理商： | AN1687 |
ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005
SEMICONDUCTOR APPLICATION NOTE
A
A
1
MOTOROLA SEMICONDUCTOR APPLICATION INFORMATION
Prepared by; Paul Sofianos
Motorola, Inc., WSSG RF/IF Applications Engineering
INTRODUCTION
This application note describes a full–duplex, wireless
data communication link targeted for RS–232 applications.
An encoding technique has been designed which addresses
many of the problems incurred when attempting to implement
the RS–232 (EIA–232) standard, including but not limited to:
hardware flow control, the DC component of the transmitted
signal, automatic synchronization from host to slave and
error detection. The design emulates a RS–232 null modem
cable for computer–to–computer communications.
The actual design was realized with standard SSI logic
from the high speed CMOS family (MC74HCxxx), an HC05
based MCU, and Motorola’s ISM Band RF chipset. The
targeted data rate was 57,600 Baud, although both higher
and lower data rates are easily attainable. It is expected that
most applications would embed the logic functions (and
possibly the MCU functions) into a FPGA, CPLD, ASIC, or
other LSI logic building block.
Throughout this application note, it is assumed the user is
familiar with standard TTL–compatible CMOS devices and
the ISM Band RF chipset. Please refer to DL110/D and
DL129/D for additional details on individual device
specifications.
THE WIRELESS LINK
The actual implementation of the wireless link transceiver
was accomplished with the Motorola’s ISM Band RF chipset.
This consists of a MC13145 RF Receiver, MC13146 RF
Transmitter and MC33411 Baseband. Figure 1 depicts the
block diagram of the RF transceiver. Figures 2, 3, and 4 are
the actual schematics for the Receiver, Transmitter, and
Baseband, respectively.
The transceiver was designed to operate in the unlicensed
(i.e. FCC Part 15) 902–928 MHz Industrial, Scientific and
Medical (ISM) band with low–power transmission. Since
direct–conversion FSK modulation is used in conjunction
with a PLL synthesized carrier, the digital modulation source
must meet certain requirements:
1. The DC component should be as close to zero as
possible. This maintains the best noise immunity at the
receiver.
2. A minimum frequency component must be maintained at
all times. If this condition is not met, the transmitter’s PLL
and receiver’s coilless demodulator will tend to
“track–out” the modulating signal.
3. The maximum frequency component should be known.
This will help define the modulation index and total
bandwidth required for the transceiver.
4. The system should be able to tolerate reasonable
bit–errors.
The MC33411 baseband controls all of the synthesizer
functions via a MCU SPI compatible interface. None of the
audio processing capabilities of the device are used. Table 1
lists various MC33411 register values for both baseset and
handset for the 5 channels used for the prototype.
Figure 1. RF Transceiver
Block Diagram
Order this document
by AN1687/D
REV 1
相關PDF資料 |
PDF描述 |
|---|---|
| AN1812 | Freescale Semiconductor, Inc. |
| AN2001 | Designing Expansion Boards |
| AN211A | FIFELD EFFECT TRANSISTORS IN THEORY AND PRACTICE |
| AN2121SC | USB Controller(通用串行總線（USB）控制器) |
| AN2125SC | USB Controller(USB控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AN1690.0 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Electronics Meets the Challenges of Patient Monitors |
| AN16903A | 制造商:PANASONIC 制造商全稱:Panasonic Semiconductor 功能描述:IC for sound multiplex demodulation in NTSC (Japanese TV mode) |
| AN-1698 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:A Specification for EMI Hardened Operational Amplifiers |
| AN16AN0AC | 制造商:Eaton Corporation 功能描述:NEMA STARTER; SIZE 00; 120VAC COIL 制造商:Eaton Corporation 功能描述:CONTROLLER STARTER; Supply Voltage Range:200VAC to 575VAC; No. of Phases:Three; Current Rating:9A; Operating Temperature Min:-20C; Operating Temperature Max:65C; Approval Bodies:CSA / UL / VDE; Current Max (Full Load):11A ;RoHS Compliant: No |
| AN16AN0BC | 制造商:Eaton Corporation 功能描述:NEMA STARTER, SIZE 00, 240VAC COIL 制造商:Eaton Corporation 功能描述:CONTROLLER STARTER, Supply Voltage Range:230VAC to 240VAC, No. of Phases:Three, |
發布緊急采購，3分鐘左右您將得到回復。