參數資料
型號： AMIS49587C5871RG
廠商： ON Semiconductor
文件頁數： 8/55頁
文件大小： 0K
描述： IC MODEM PLC 50/60MHZ 28PLCC
標準包裝： 750
波特率： 可選
電源電壓： 3 V ~ 3.6 V
安裝類型： 表面貼裝
封裝/外殼： 28-LCC（J 形引線）
供應商設備封裝： 28-PLCC（11.51x11.51）
包裝： 帶卷 (TR)
AMIS49587
http://onsemi.com
16
5 INTRODUCTION
5.1
GENERAL DESCRIPTION
The AMIS49587 is a single chip half duplex SFSK
modem dedicated to power line carrier (PLC) data
transmission on low or mediumvoltage power lines. The
device offers complete handling of the protocol layers from
the physical up to the MAC. AMIS49587 complies with the
CENELEC EN 500651 and the IEC 6133451 standards.
It operates from a single 3.3 V power supply and is
interfaced to the power line by an external power driver and
transformer. An internal PLL is locked to the mains
frequency and is used to synchronize the data transmission
at data rates of 300, 600, 1200 and 2400 baud for a 50Hz
mains frequency, or 360, 720, 1440 and 2880 baud for a
60 Hz mains frequency. In both cases this corresponds to
3,6,12 or 24 data bits per half cycle of the mains period.
SFSK is a modulation and demodulation technique that
combines some of the advantages of a classical spread
spectrum system (e.g. immunity against narrow band
interferers) with the advantages of the classical FSK system
(low complexity). The transmitter assigns the space
frequency fS to “data 0” and the mark frequency fM to “data
1”. The difference between SFSK and the classical FSK
lies in the fact that fS and fM are now placed far from each
other, making their transmission quality independent from
each other (the strengths of the small interferences and the
signal attenuation are both independent at the two
frequencies). The frequency pairs supported by the
AMIS49587 are in the range of 995 kHz with a typical
separation of 10 kHz.
The conditioning and conversion of the signal is
performed at the analog frontend of the circuit. The further
processing of the signal and the handling of the protocol is
digital. At the backend side, the interface to the application
is done through a serial interface. The digital processing of
the signal is partitioned between hardwired blocks and a
microprocessor block. The microprocessor is controlled by
firmware. Where timing is most critical, the functions are
implemented with dedicated hardware. For the functions
where the timing is less critical, typically the higher level
functions, the circuit makes use of the ARM 7TDMI
microprocessor core.
The processor runs DSP algorithms and, at the same time,
handles the communication protocol. The communication
protocol, in this application, contains the MAC = Medium
Access Control Layer. The program running on the
microprocessor is stored into ROM. The working data
necessary for the processing is stored in an internal RAM. At
the backend side the link to the application hardware is
provided by a Serial Communication Interface (SCI). The
SCI is an easy to use serial interface, which allows
communication between an external processor used for the
application software and the AMIS49587 modem. The SCI
works on two wires: TXD and RXD. Baud rate is
programmed by setting 2 bits (BR0, BR1).
Because the low protocol layers are handled in the circuit,
the AMIS49587 provides an innovative architectural split.
Thanks to this, the user has the benefit of a higher level
interface of the link to the PLC medium. Compared to an
interface at the physical level, the AMIS49587 allows
faster development of applications. The user just needs to
send the raw data to the AMIS49587 and no longer has to
take care of the protocol detail of the transmission over the
specific medium. This last part represents usually 50 percent
of the software development costs.
Minor User Type
Major User Type
SPY
Application
AMIS49587 in
MONITOR mode
TEST
Application
AMIS49587 in
TEST mode
CLIENT
Application
AMIS49587 in
MASTER mode
SERVER
Application
AMIS49587 in
SLAVE mode
SERVER
Application
AMIS49587 in
SLAVE mode
Figure 8. Application Examples
AMIS49587 intended to connect equipment using
Distribution Line Carrier (DLC) communication. It serves
two major and two minor types of applications:
Major types:
Master or Client:
A Master is a client to the data served by one or
many slaves on the power line. It collects data from
and controls the slave devices. A typical application
is a concentrator system.
Slave or Server:
A Slave is a server of the data to the Master. A
typical application is an electricity meter equipped
with a PLC modem.
Minor type:
Spy or Monitor:
Spy or Monitor mode is used to only listen to the
data that comes across the power line. Only the
physical layer frame correctness is checked. When
相關PDF資料
PDF描述
AMIS49587C5872RG IC MODEM PLC 50/60MHZ 52QFN
VI-J6B-IY-B1 CONVERTER MOD DC/DC 95V 50W
NCN5192MNG IC HART MODEM CMOS SGL 32QFN
VI-2N4-IX-F2 CONVERTER MOD DC/DC 48V 75W
VI-26D-CV CONVERTER MOD DC/DC 85V 150W
相關代理商/技術參數
參數描述
AMIS49587C5872G 功能描述:電信線路管理 IC PLC MODEM 2400BAUD RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
AMIS49587C5872RG 功能描述:電信線路管理 IC PLC MODEM 2400BAUD RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
AMIS49587GEVK 功能描述:KIT EVALUATION AMIS49587 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板
AMIS-50050 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Trays 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Tape and Reel
AMIS-50051 制造商:ON Semiconductor 功能描述:DMOD 32LQFP / - Trays 制造商:ON Semiconductor 功能描述:DMOD - Tape and Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*