參數資料
型號： AMIS49587C5871G
廠商： ON Semiconductor
文件頁數： 2/55頁
文件大?。?/td> 0K
描述： IC MODEM PLC 50/60MHZ 28PLCC
標準包裝： 37
波特率： 可選
電源電壓： 3 V ~ 3.6 V
安裝類型： 表面貼裝
封裝/外殼： 28-LCC（J 形引線）
供應商設備封裝： 28-PLCC（11.51x11.51）
包裝： 管件
AMIS49587
http://onsemi.com
10
CRC
CRC is a 5V compliant open drain output. An external pullup resistor defines the logic high level as illustrated in Figure 5.
A typical value for this pullup resistance “R” is 10 k
W. The signal on this output depends on the cyclic redundancy code result
of the received frame. If the cyclic redundancy code is correct CRC = 1 during the pause between 2 time slots.
RESB
RESB is a digital input pin. It is used to perform a hardware reset of the AMIS49587. This pin supports a 5 V voltage level.
The reset is active when the signal is low (0 V).
TEST
TEST is a digital input pin. It is used to enable the test mode of the chip. Normal mode is activated when TEST signal is low
(0 V). For normal operation, the TEST pin may be left unconnected. Due to the internal pulldown, the signal is maintained to
low (0 V). TEST pin is not 5 V safe.
TX_ENB
TX_ENB is a digital output pin. It is low when the transmitter is activated. The signal is available to turn on the line driver.
TX_ENB is a 5 V safe with open drain output, hence a pullup resistance is necessary achieve the requested voltage level
associated with a logical one. See also Figure 5 for reference.
TX_OUT
TX_OUT is the analog output pin of the transmitter. The provided signal is the SFSK modulated frames. A filtering operation
must be performed to reduce the second order harmonic distortion. For this purpose an active filter is realized. Figure 7 gives
the representation of this filter.
Figure 7. TX_OUT Filter
ALC
control
ALC_IN
Transmitter (SFSK Modulator)
ARM
Interface
&
Control
TX_OUT
LP
Filter
TX_EN
TO TX POWER
OUTPUT STAGE
FROM LINE
DRIVER
C1
R1
VSSA
C2
R2
R3
C3
C4
ALC_IN
ALC_IN is the automatic level control analog input pin. The signal is used to adjust the level of the transmitted signal. The
signal level adaptation is based on the AC component. The DC level on the ALC_IN pin is fixed internally to 1.65 V. Comparing
the peak voltage of the AC signal with two internal thresholds does the adaptation of the gain. Low threshold is fixed to 0.4 V.
A value under this threshold will result in an increase of the gain. The high threshold is fixed to 0.6 V. A value over this threshold
will result in a decrease of the gain. A serial capacitance is used to block the DC components. The level adaptation is performed
during the transmission of the first two bits of a new frame. Eight successive adaptations are performed.
相關PDF資料
PDF描述
VE-24X-IX-F3 CONVERTER MOD DC/DC 5.2V 75W
VE-24X-IX-F2 CONVERTER MOD DC/DC 5.2V 75W
SI3015-KS IC SI2400 LINE-SIDE DAA 16SOIC
SI2400-KS IC ISOMODEM SYSTEM-SIDE 16SOIC
VE-24W-IX-F4 CONVERTER MOD DC/DC 5.5V 75W
相關代理商/技術參數
參數描述
AMIS49587C5871R 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Power Line Carrier Modem
AMIS49587C5871RG 功能描述:電信線路管理 IC C587- NAF- AMIS49587 RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
AMIS49587C5872G 功能描述:電信線路管理 IC PLC MODEM 2400BAUD RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
AMIS49587C5872RG 功能描述:電信線路管理 IC PLC MODEM 2400BAUD RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
AMIS49587GEVK 功能描述:KIT EVALUATION AMIS49587 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*