
AMIS-710310-DR:
300dpi Two-Level Digital Output Module
Data Sheet
1.0 General Description
The AMIS-710310-DR (PI310MC-DR) is a contact image sensor (CIS) module with an additional on-board circuit that digitizes the
analog pixels from the CIS image sensor to a “background-tracking”, two-level digital output signal. The module uses MOS image
sensor technology to gain high-speed performance and high sensitivity. The AMIS-710310-DR is suitable for scanning documents with
widths of 89mm and with resolutions of 11.8 dots per millimeter (dpm). It has broad applications but is specifically designed for the
following areas:
Where data compression is required, such as in data transmissions.
Where component pin-out count must be kept to a minimum.
The background-tracking-digitizing circuits in the AMIS-710310-DR have been referred to as the “dynamic threshold” two-level A/D
converter. For the purpose of describing the module’s characteristics, this “dynamic threshold” processing circuit shall herein be
referred to as the “tracking digitizer”.
2.0 Key Features
Light source, lens and sensor are integrated into a single module
11.8dpm resolution, 89mm scanning length
Up to 423
μ
sec/line scanning speed, with 2.5MHz pixel rate (see Table 3, Note 3)
Wide dynamic range two-level tracking digital output (“Dynamic Threshold Digitizer”)
Standard Yellow-Green light source (other colors are available)
Compact size
13mm x 25.6mm x 102mm low power
Light weight
3.0 Module Description
Figure 1: Block Diagram of AMIS-710310-DR
1
AMI Semiconductor
– May 06, M-20566-001
www.amis.com