
AJ4
NOTES
1. Installation
Keep the panel tightening torque to less
than 1.96 Ncm. Also, do not tighten the
nut, holding the switch.
2. For induction load switching
(relays, solenoids and buzzers, etc.)
we recommend inserting a suitable
spark quenching circuit in order to
prevent damage to the contacts due to
the possibility of arcing caused by
back voltage.
3. For hand soldering, a 350°C
soldering iron should be used with the
soldering completed within 5
seconds. Also, care should be taken
not to touch the body of the switch
with the soldering iron.
4. We cannot guarantee performance if
the product is dropped onto a hard,
concrete oor from a height of 80 cm
or more. Please be careful.
5. When using the switch, be careful
not to apply unreasonable
perpendicular force (static loading of
112.7 N or more) in the operation
direction.
6. Verication of insulation distance
Please verify that insulation distances
have been maintained between terminals
and with ground after installation and
wiring of the switch.
When wiring the .110 Quick connect
terminal we recommend using a
receptacle with an insulating sleeve.
Also, after wiring make sure that the
terminals are free from any steady forces.
7. This product is not hermetically
sealed, so its performance could
deteriorate under certain ambient
conditions. Avoid using and storing
these switches in a location where
they will be exposed to corrosive
gases, silicon, or high dust levels, all
of which can have an adverse effect
on the contacts.
8. Do not use the switches where they
will come into contact with water
through splashing, etc. This could
cause abnormal heating and smoke
generation, which could damage the
circuit and lead to an accident.
9. Do not use in atmospheres that
contain combustible gas. Such use
could cause res and explosions.
All Rights Reserved COPYRIGHT Matsushita Electric Works, Ltd.