- 您現在的位置：買賣IC網 > PDF目錄381259 > AIC2951D-33CS (Analog Integrations Corporation) CABLE RISER UNSHLD 2COND 22AWG PDF資料下載
參數資料
| 型號： | AIC2951D-33CS |
| 廠商： | Analog Integrations Corporation |
| 英文描述： | CABLE RISER UNSHLD 2COND 22AWG |
| 中文描述： | 低壓差線性穩壓器 |
| 文件頁數： | 7/10頁 |
| 文件大?。?/td> | 153K |
| 代理商： | AIC2951D-33CS |
AIC2951/2951D
7
n
BLOCK DIAGR AM
-
+
-
+
FB
VIN
VOUT
SHDN
60mV
1
8
7
3
1.235V REFERENCE
AMP
ERROR
RF2
RF1
SENSE
TAP
GND
ERROR
4
5
6
2
+
+
ERROR DETECTION
COMPARATOR
n
PIN DE SCR IPTIONS
PIN 1:
VOUT - Output pin.
PIN 2:
SENSE -Remote sense input, connected
to internal resistor divider.
PIN 3:
SHDN - Shutdown input.
PIN 4:
GND
- Power GND.
PIN 5:
PIN 6: TAP
ERROR
- Open drain output of error flag warns.
- Center output of internal resistor di-
vider.
PIN 7: FB
- Error amplifier positive feedback (see
Block Diagram)
PIN 8: VIN
- Power supply input
n
APPLICATION INFOR MATIONS
Output Filter Capacitors
A 1
μ
F (or greater) capacitor is required between the AIC2951/AIC2951D output and ground for stability. Without
this capacitor the part will oscillate. Even though most types of capacitor may work, if Aluminum electrolytic type
is used, the equivalent series resistance (ESR) should be held to 5
or less. Many Aluminum electrolytics have
electrolytes that freeze at about -30
°
C, so solid tantalums are recommended for operation below -25
°
C. The value
of this capacitor may be increased without limit.
The output capacitance required for stability varies with output voltage (smaller for higher output voltage) and out-
put current (smaller for lower output currents). At the worst-case situation of a 150mA load at 1.235V output
(output shorted to FB pin) a 3.3
μ
F or greater capacitor should be used.
A 0.1
μ
F capacitor should be placed from the AIC2951/2951D input to ground if the lead inductance between the
input and power source exceeds 500nH (approximately 10 inches of trace). Noise injection into the feedback
terminal of the AIC2951/2951D from nearby noise sources can also upset the output. This may especially
be a problem when using high value external resis-
tors to set the output voltage. Adding a 100pF ca-
pacitor between output and feedback and increas-
ing the output capacitor to at least 3.3
μ
F will cure
this problem.
Programming the Output Voltage
The AIC2951/2951D series can be set to deliver
any output voltage from 1.235V to 11V by using an
external voltage divider. In addition, internal voltage
相關PDF資料 |
PDF描述 |
|---|---|
| AIC2951D-50CN | CABLE RISER UNSHLD 6COND 22AWG |
| AIC2951D-50CS | CABLE 18/2 STR BC CMR GRY |
| AIC431 | Adjustable Precision Shunt Regulators |
| AIC431CS | Adjustable Precision Shunt Regulators |
| AIC431CUN | Adjustable Precision Shunt Regulators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AIC2951D-50CN | 制造商:AIC 制造商全稱:Analog Intergrations Corporation 功能描述:Low Dropout Linear Regulator |
| AIC2951D-50CS | 制造商:AIC 制造商全稱:Analog Intergrations Corporation 功能描述:Low Dropout Linear Regulator |
| AIC-2P-150-23 | 制造商:PREMO 制造商全稱:PREMO CORPORATION S.L 功能描述:High Energy Storage Chokes for inverter Applications |
| AIC-2P-250-23 | 制造商:PREMO 制造商全稱:PREMO CORPORATION S.L 功能描述:High Energy Storage Chokes for inverter Applications |
| AIC-2P-300-12 | 制造商:PREMO 制造商全稱:PREMO CORPORATION S.L 功能描述:High Energy Storage Chokes for inverter Applications |
發布緊急采購，3分鐘左右您將得到回復。