參數資料
型號: ADXL330
廠商: Analog Devices, Inc.
英文描述: Small, Low Power, 3-Axis 【3 g i MEMS Accelerometer
中文描述: 小型,低功耗,3軸【3基MEMS加速度
文件頁數: 11/16頁
文件大?。?/td> 246K
代理商: ADXL330
ADXL330
THEORY OF OPERATION
The ADXL330 is a complete 3-axis acceleration measurement
system on a single monolithic IC. The ADXL330 has a measure-
ment range of ±3
g
minimum. It contains a polysilicon surface
micromachined sensor and signal conditioning circuitry to
implement an open-loop acceleration measurement architecture.
The output signals are analog voltages that are proportional to
acceleration. The accelerometer can measure the static accelera-
tion of gravity in tilt sensing applications as well as dynamic
acceleration resulting from motion, shock, or vibration.
Rev. 0 | Page 11 of 16
The sensor is a polysilicon surface micromachined structure
built on top of a silicon wafer. Polysilicon springs suspend the
structure over the surface of the wafer and provide a resistance
against acceleration forces. Deflection of the structure is meas-
ured using a differential capacitor that consists of independent
fixed plates and plates attached to the moving mass. The fixed
plates are driven by 180° out-of-phase square waves. Acceleration
deflects the moving mass and unbalances the differential
capacitor resulting in a sensor output whose amplitude is
proportional to acceleration. Phase-sensitive demodulation
techniques are then used to determine the magnitude and
direction of the acceleration.
The demodulator output is amplified and brought off-chip
through a 32 kΩ resistor. The user then sets the signal band-
width of the device by adding a capacitor. This filtering improves
measurement resolution and helps prevent aliasing.
MECHANICAL SENSOR
The ADXL330 uses a single structure for sensing the X, Y, and
Z axes. As a result, the three axes sense directions are highly
orthogonal with little cross axis sensitivity. Mechanical mis-
alignment of the sensor die to the package is the chief source
of cross axis sensitivity. Mechanical misalignment can, of
course, be calibrated out at the system level.
PERFORMANCE
Rather than using additional temperature compensation
circuitry, innovative design techniques ensure high
performance is built-in to the ADXL330. As a result, there is
neither quantization error nor nonmonotonic behavior, and
temperature hysteresis is very low (typically less than 3 m
g
over
the 25°C to +70°C temperature range).
Figure 14, Figure 15, and Figure 16 show the zero
g
output
performance of eight parts (X-, Y-, and Z-axis) soldered to a
PCB over a 25°C to +70°C temperature range.
Figure 26, Figure 27, and Figure 28 demonstrate the typical
sensitivity shift over temperature for supply voltages of 3 V. This
is typically better than ±1% over the 25°C to +70°C
temperature range.
相關PDF資料
PDF描述
ADXL330KCPZ Small, Low Power, 3-Axis 【3 g i MEMS Accelerometer
ADXL50 Monolithic Accelerometer With Signal Conditioning(帶信號調節的單片加速計)
ADXRS150ABG 【150∑/s Single Chip Yaw Rate Gyro with Signal Conditioning
ADXRS150ABG-REEL 【150∑/s Single Chip Yaw Rate Gyro with Signal Conditioning
AE04 Schottky Barrier Diodes
相關代理商/技術參數
參數描述
ADXL330_07 制造商:AD 制造商全稱:Analog Devices 功能描述:Small, Low Power, 3-Axis 【3 g i MEMS㈢ Accelerometer
ADXL330KCPZ 功能描述:IC ACCELEROMETER 3-AXIS 16LFCSP RoHS:是 類別:傳感器,轉換器 >> 加速計 系列:iMEMS® 標準包裝:1 系列:SCA1000 軸:X,Y 加速范圍:±1.7g 靈敏度:1.2V/g 電源電壓:4.75 V ~ 5.25 V 輸出類型:數字 帶寬:50±30Hz 接口:SPI 安裝類型:表面貼裝 封裝/外殼:12-SMD 供應商設備封裝:12-SMD 其它名稱:551-1007-1
ADXL330KCPZ1 制造商:AD 制造商全稱:Analog Devices 功能描述:Small, Low Power, 3-Axis 【3 g i MEMS㈢ Accelerometer
ADXL330KCPZ-RL 功能描述:IC ACCELEROMETER 3-AXIS 16LFCSP RoHS:是 類別:傳感器,轉換器 >> 加速計 系列:iMEMS® 標準包裝:1 系列:SCA1000 軸:X,Y 加速范圍:±1.7g 靈敏度:1.2V/g 電源電壓:4.75 V ~ 5.25 V 輸出類型:數字 帶寬:50±30Hz 接口:SPI 安裝類型:表面貼裝 封裝/外殼:12-SMD 供應商設備封裝:12-SMD 其它名稱:551-1007-1
ADXL330KCPZ-RL1 制造商:AD 制造商全稱:Analog Devices 功能描述:Small, Low Power, 3-Axis 【3 g i MEMS㈢ Accelerometer