- 您現在的位置：買賣IC網 > PDF目錄374039 > ADUC836 (Analog Devices, Inc.) MicroConverter, Dual 16-Bit-ADCs with Embedded 62 kB Flash MCU PDF資料下載
參數資料
| 型號： | ADUC836 |
| 廠商： | Analog Devices, Inc. |
| 元件分類： | 串行ADC |
| 英文描述： | MicroConverter, Dual 16-Bit-ADCs with Embedded 62 kB Flash MCU |
| 中文描述： | MicroConverter的，雙16位ADC的與嵌入62 kB閃存微控制器 |
| 文件頁數： | 46/80頁 |
| 文件大?。?/td> | 5913K |
| 代理商： | ADUC836 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁當前第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
ADuC836
–46–
I
2
C SERIAL INTERFACE
The ADuC836 supports a fully licensed
*
I
2
C serial interface. The
I
2
C interface is implemented as a full hardware slave and soft-
ware master. SDATA (Pin 27) is the data I/O pin and SCLOCK
(Pin 26) is the serial clock. These two pins are shared with the
MOSI and SCLOCK pins of the on-chip SPI interface. Therefore
the user can enable only one interface or the other at any given
time (see SPE in Table XXI). Application Note uC001 describes
the operation of this interface as implemented and is available from
www.analog.com/microconverter.
Three SFRs are used to control the I
2
C interface. These are
described below.
Table XXII. I2CCON SFR Bit Designations
Bit Name Description
7 MDO I
2
C Software Master Data Output Bit (Master Mode Only).
This data bit is used to implement a master I
2
C transmitter interface in software. Data written to this bit will
be output on the SDATA pin if the data output enable (MDE) bit is set.
6 MDE I
2
C Software Master Data Output Enable Bit (Master Mode Only).
Set by user to enable the SDATA pin as an output (Tx).
Cleared by user to enable SDATA pin as an input (Rx).
5 MCO I
2
C Software Master Clock Output Bit (Master Mode Only).
This data bit is used to implement a master I
2
C transmitter interface in software. Data written to this bit will
be output on the SCLOCK pin.
4 MDI I
2
C Software Master Data Input Bit (Master Mode Only).
This data bit is used to implement a master I
2
C receiver interface in software. Data on the SDATA pin is
latched into this bit on SCLOCK if the data output enable (MDE) bit is 0.
3 I2CM I
2
C Master/Slave Mode Bit.
Set by user to enable I
2
C software Master mode.
Cleared by user to enable I
2
C hardware Slave mode.
2 I2CRS I
2
C Reset Bit (Slave Mode Only).
Set by user to reset the I
2
C interface.
Cleared by user code for normal I
2
C operation.
1 I2CTX I
2
C Direction Transfer Bit (Slave Mode Only).
Set by MicroConverter if the interface is transmitting.
Cleared by the MicroConverter if the interface is receiving.
0 I2CI I
2
C Interrupt Bit (Slave Mode Only).
Set by the MicroConverter after a byte has been transmitted or received.
Cleared automatically when the user code reads the I2CDAT SFR (see I2CDAT below).
I2CCON I
2
C Control Register
SFR Address E8H
Power-On Default Value 00H
Bit Addressable Yes
I2CADD I
2
C Address Register
Function Holds the I
2
C peripheral address for the part. It may be overwritten by the user code. Application Note uC001
at
www.analog.com/microconverter
describes the format of the I
2
C standard 7-bit address in detail.
SFR Address 9BH
Power-On Default Value 55H
Bit Addressable No
I2CDAT I
2
C Data Register
Function The I2CDAT SFR is written by the user to transmit data over the I
2
C interface or read by user code to read
data just received by the I
2
C interface. Accessing I2CDAT automatically clears any pending I
2
C interrupt
and the I2CI bit in the I2CCON SFR. User software should access I2CDAT only once per interrupt cycle.
SFR Address 9AH
Power-On Default Value 00H
Bit Addressable No
*
Purchase of licensed I
2
C components of Analog Devices or one of its sublicensed associated companies conveys a license for the purchaser under the Philips I
2
C
Patent Rights to use these components in an I
2
C system provided that the system conforms to the I
2
C Standard Specification as defined by Philips.
REV. A
相關PDF資料 |
PDF描述 |
|---|---|
| ADUC836BCP | MicroConverter, Dual 16-Bit-ADCs with Embedded 62 kB Flash MCU |
| ADUC836BS | MicroConverter, Dual 16-Bit-ADCs with Embedded 62 kB Flash MCU |
| ADUC842BCP62-3 | MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| ADUC843BCP62-5 | MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| ADUC842BCP62-5 | MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADUC836_02 | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter, Dual 16-Bit ADCs with Embedded 62 kB Flash MCU |
| ADUC836BCP | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| ADUC836BCPZ | 功能描述:IC MCU 62K FLASH ADC/DAC 56LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA，UART/USART 外圍設備:欠壓檢測/復位，LED，POR，PWM，WDT 輸入/輸出數:16 程序存儲器容量:4KB（4K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND |
| ADUC836BCPZ-REEL | 功能描述:IC MCU 62K FLASH ADC/DAC 56LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA，UART/USART 外圍設備:欠壓檢測/復位，LED，POR，PWM，WDT 輸入/輸出數:16 程序存儲器容量:4KB（4K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND |
| ADUC836BS | 制造商:Analog Devices 功能描述:MCU 8-bit ADuC8xx 8052 CISC 62KB Flash 3.3V/5V 52-Pin MQFP 制造商:Analog Devices 功能描述:8BIT MCU +16BIT DUAL ADC MQFP52 |
發布緊急采購，3分鐘左右您將得到回復。