- 您現在的位置：買賣IC網 > PDF目錄364643 > ADS8509IDBR RJ Field Cordset Cat5e w/ RJ45 Plug Each End 6.24m / 20 Feet PDF資料下載
參數資料
| 型號： | ADS8509IDBR |
| 英文描述： | RJ Field Cordset Cat5e w/ RJ45 Plug Each End 6.24m / 20 Feet |
| 中文描述： | 16位250 ksps的串行CMOS采樣模擬數字轉換器 |
| 文件頁數： | 16/26頁 |
| 文件大?。?/td> | 693K |
| 代理商： | ADS8509IDBR |
www.ti.com
180
160
140
120
100
80
60
40
20
0
20
0
25
50
75
100
125
8192 Points,
f
s
= 250 KSPS,
f
= 20 kHz, 0 dB
SINAD = 86.0 dB,
THD = 98.7 dB
A
f Frequency kHz
Figure 26.
BASIC OPERATION
Two signals control conversion in the ADS8509: CS and R/C. These two signals are internally ORed together. To
start a conversion the chip must be selected, CS low, and the conversion signal must be active, R/C low. Either
signal can be brought low first. Conversion starts on the falling edge of the second signal. BUSY goes low when
conversion starts and returns high after the data from that conversion is shifted into the internal storage register.
Sampling begins when BUSY goes high.
READING DATA
The conversion result is available as soon as BUSY returns to high therefore, data always represents the
conversion previously completed even when it is read during a conversion. The ADS8509 outputs serial data in
either straight binary or binary two’s compliment format. The SB/BTC pin controls the format. Data is shifted out
MSB first. The first conversion immediately following a power-up will not produce a valid conversion result.
INTERNAL DATACLK
In the internal clock mode data for the previous conversion is clocked out during each conversion period. The
internal data clock is synchronized to the internal conversion clock so that is does not interfere with the
conversion process.
EXTERNAL DATACLK
The external clock mode offers several ways to retrieve conversion results. However, since the external clock
cannot be synchronized to the internal conversion clock care must be taken to avoid corrupting the data.
ADS8509
SLAS324A–OCTOBER 2004–REVISED JUNE 2005
TYPICAL CHARACTERISTICS (continued)
FFT (20 kHz Input)
To reduce the number of control pins CS can be tied low permanently. The R/C pin now controls conversion and
data reading exclusively. In the external clock mode this means that the ADS8509 will clock out data whenever
R/C is brought high and the external clock is active. In the internal clock mode data is clocked out every convert
cycle regardless of the states of CS and R/C. The ADS8509 provides a TAG input for cascading multiple
converters together.
Data can be clocked out with either the internally generated clock or with an external clock. The EXT/INT pin
controls this function. If external clock is used the TAG input can be used to daisy-chain multiple ADS8509 data
pins together.
The DATACLK pin becomes an output when EXT/INT is low. 16 clock pulses are generated at the beginning of
each conversion after timing t
8
is satisfied, i.e. you can only read previous conversion result during conversion.
DATACLK returns to low when it is inactive. The 16 bits of serial data are shifted out the DATA pin synchronous
to this clock with each bit available on a rising and then a falling edge. DATA pin returns to the state of TAG pin
input sensed at the start of transmission.
16
相關PDF資料 |
PDF描述 |
|---|---|
| ADS8509IDBRG4 | 16-BIT 250-KSPS SERIAL CMOS SAMPLING ANALOG-TO-DIGITAL CONVERTER |
| ADS8509IDW | 16-BIT 250-KSPS SERIAL CMOS SAMPLING ANALOG-TO-DIGITAL CONVERTER |
| ADS8509IDWR | 16-BIT 250-KSPS SERIAL CMOS SAMPLING ANALOG-TO-DIGITAL CONVERTER |
| ADS852 | 14-Bit, 65MHz Sampling ANALOG-TO-DIGITAL CONVERTER |
| ADS852Y | 14-Bit, 65MHz Sampling ANALOG-TO-DIGITAL CONVERTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADS8509IDBRG4 | 功能描述:模數轉換器 - ADC 16-Bit 250kHz CMOS w/Serial Interface RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS8509IDW | 功能描述:模數轉換器 - ADC 16-Bit 250kHz CMOS w/Serial Interface RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS8509IDW | 制造商:Texas Instruments 功能描述:IC 16BIT ADC 250KHZ 20SOIC 制造商:Texas Instruments 功能描述:IC, 16BIT ADC, 250KHZ, 20SOIC 制造商:Texas Instruments 功能描述:IC, 16BIT ADC, 250KHZ, 20SOIC; Resolution (Bits):16bit; Sampling Rate:250kSPS; Supply Voltage Type:Single; Supply Voltage Min:4.75V; Supply Voltage Max:5.25V; Supply Current:10mA; Digital IC Case Style:SOIC; No. of Pins:20; Input ;RoHS Compliant: Yes |
| ADS8509IDWG4 | 功能描述:模數轉換器 - ADC 16-Bit 250kHz CMOS w/Serial Interface RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS8509IDWR | 功能描述:模數轉換器 - ADC 16-Bit 250kHz CMOS w/Serial Interface RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。