- 您現在的位置：買賣IC網 > PDF目錄375263 > ADS1254 24-Bit, 20kHz, Low Power ANALOG-TO-DIGITAL CONVERTER PDF資料下載
參數資料
| 型號： | ADS1254 |
| 英文描述： | 24-Bit, 20kHz, Low Power ANALOG-TO-DIGITAL CONVERTER |
| 中文描述： | 24位20kHz的，低功耗模擬數字轉換器 |
| 文件頁數： | 8/17頁 |
| 文件大?。?/td> | 281K |
| 代理商： | ADS1254 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁
ADS1254
SBAS213
8
FIGURE 3. Recommended External Voltage Reference Circuit for Best Low-Noise Operation with the ADS1254.
DELTA-SIGMA MODULATOR
The ADS1254 operates from a nominal system clock fre-
quency of 8MHz. The modulator frequency is fixed in
relation to the system clock frequency. The system clock
frequency is divided by 6 to derive the modulator frequency.
Therefore, with a system clock frequency of 8MHz, the
modulator frequency is 1.333MHz. Furthermore, the
oversampling ratio of the modulator is fixed in relation to the
modulator frequency. The oversampling ratio of the modu-
lator is 64, and with the modulator frequency running at
1.333MHz, the data rate is 20.8kHz. Using a slower system
clock frequency will result in a lower data output rate, as
shown in Table II.
TABLE II. CLK Rate versus Data Output Rate.
CLK (MHz)
DATA OUTPUT RATE (Hz)
8
(1)
20,833
19,200
16,000
15,625
12,800
9,600
8,000
6,400
4,800
2,400
1,200
1,000
500
100
60
50
30
25
20
16.67
15
12.50
10
7.372800
(1)
6.144000
(1)
6.000000
(1)
4.915200
(1)
3.686400
(1)
3.072000
(1)
2.457600
(1)
1.843200
(1)
0.921600
0.460800
0.384000
0.192000
0.038400
0.023040
0.019200
0.011520
0.009600
0.007680
0.006400
0.005760
0.004800
0.003840
NOTE: (1) Standard Clock Oscillator.
REFERENCE INPUT
Reference input takes an average current of 32
μ
A with a
8MHz system clock. This current will be proportional to the
system clock. A buffered reference is recommended for the
ADS1254. The recommended reference circuit is shown in
Figure 3.
Reference voltages higher than 4.096V will increase the
full-scale range, while the absolute internal circuit noise of
the converter remains the same. This will decrease the noise
in terms of ppm of full scale, which increases the effective
resolution (see the Typical Characteristic “RMS Noise vs
V
REF
Voltage”).
DIGITAL FILTER
The digital filter of the ADS1254, referred to as a sinc
5
filter,
computes the digital result based on the most recent outputs
from the delta-sigma modulator. At the most basic level, the
digital filter can be thought of as simply averaging the
modulator results in a weighted form and presenting this
average as the digital output. The digital output rate, or data
rate, scales directly with the system CLK frequency. This
allows the data output rate to be changed over a very wide
range (five orders of magnitude) by changing the system
CLK frequency. However, it is important to note that the
–3dB point of the filter is 0.2035 times the data output rate,
so the data output rate should allow for sufficient margin to
prevent attenuation of the signal of interest.
Since the conversion result is essentially an average, the
data-output rate determines the location of the resulting
notches in the digital filter (see Figure 4). Note that the first
notch is located at the data-output rate frequency, and
subsequent notches are located at integer multiples of the
data-output rate to allow for rejection of not only the
fundamental frequency, but also harmonic frequencies. In
this manner, the data-output rate can be used to set specific
notch frequencies in the digital filter response.
For example, if the rejection of power-line frequencies is
desired, then the data-output rate can simply be set to the
power-line frequency. For 50Hz rejection, the system CLK
0.10
μ
F
+5V
+5V
4.99k
10k
10
μ
F
LM404-4.1
4
3
1
2
7
6
+
0.10
μ
F
0.1
μ
F
10
μ
F
+
OPA350
To V
Pin 18 of
the ADS1254
相關PDF資料 |
PDF描述 |
|---|---|
| ADS1254E | 24-Bit, 20kHz, Low Power ANALOG-TO-DIGITAL CONVERTER |
| ADS1255IDB | Very Low Noise, 24-Bit Analog-to-Digital Converter |
| ADS1255IDBR | Very Low Noise, 24-Bit Analog-to-Digital Converter |
| ADS1255IDBT | Very Low Noise, 24-Bit Analog-to-Digital Converter |
| ADS1256IDB | Very Low Noise, 24-Bit Analog-to-Digital Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADS1254E | 功能描述:模數轉換器 - ADC 24-Bit 20kHz Low Power RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS1254E | 制造商:Texas Instruments 功能描述:IC 24BIT ADC SMD 1254 SSOP20 制造商:Texas Instruments 功能描述:IC, 24BIT ADC, SMD, 1254, SSOP20 制造商:Texas Instruments 功能描述:IC, 24BIT ADC, SMD, 1254, SSOP20; Resolution (Bits):24bit; Sampling Rate:20.8kSPS; Supply Voltage Type:Single; Supply Voltage Min:4.75V; Supply Voltage Max:5.25V; Supply Current:800A; Digital IC Case Style:SSOP; No. of Pins:20; ;RoHS Compliant: Yes |
| ADS1254E/2K5 | 功能描述:模數轉換器 - ADC 24-Bit 20kHz Low Power RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS1254E/2K5G4 | 功能描述:模數轉換器 - ADC 24-Bit 20kHz Low Power RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS1254EG4 | 功能描述:模數轉換器 - ADC 24-Bit 20kHz Low Power RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。