- 您現在的位置：買賣IC網 > PDF目錄5374 > ADR827ARMZ-REEL7 (Analog Devices Inc)IC OPAMP GP R-R 1MHZ LP 10MSOP PDF資料下載
參數資料
| 型號： | ADR827ARMZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 10/20頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP GP R-R 1MHZ LP 10MSOP |
| 產品變化通告： | Product Discontinuance 27/Oct/2011 |
| 標準包裝： | 1 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.5 V/µs |
| 增益帶寬積： | 1MHz |
| 電流 - 輸入偏壓： | 10nA |
| 電壓 - 輸入偏移： | 100µV |
| 電流 - 電源： | 400µA |
| 電流 - 輸出 / 通道： | 20mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 15 V，±2.7 V ~ 15 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 796 (CN2011-ZH PDF) |
| 其它名稱： | ADR827ARMZ-REEL7DKR |
ADR821/ADR827
Rev. 0 | Page 18 of 20
APPLICATIONS INFORMATION
+2.5 V AND 2.5 V OUTPUTS (ADR821)
0
66
65
-0
03
REF
REF_OUT
AMP_OUT
V–
V+
10k
R1
R2
+2.5V
–2.5V
+IN
0.1F
Figure 38. +2.5 V and 2.5 V Outputs
In many dual-supply applications, it is desirable to have ±2.5 V
references. Using the configuration shown in Figure 38, it is
possible to generate 2.5 V with the help of a +2.5 V reference,
an internal op amp, and 10 kΩ resistors. The supply voltages V+
and V should be greater than +2.8 V and 2.8 V, respectively.
The op amp is configured as an inverting amplifier with a gain
of 1, which produces 2.5 V at the output of the op amp. The
output of the reference is fed to the amplifier inverting input.
Because the op amp has very low input offset voltage (500 μV
over the full temperature range) and the TC ratio of the
resistors is typically ±25 ppm/°C, the 2.5 V output is less than
7 mV away from the theoretical value.
2.5 V AND 5.0 V OUTPUTS (ADR821)
06
66
5-
00
4
REF_OUT
AMP_OUT
V–
V+
10k
R1
R2
2.5V
5.0V
+IN
–IN
0.1F
REF
Figure 39. 2.5 V and 5.0 V Outputs
In many single-supply applications, it is desirable to have
multiple reference voltages. Using the configuration shown in
Figure 39, it is possible to generate 5.0 V with the help of a
2.5 V reference, an internal op amp, and resistors. V+ should
be kept at greater than 5.8 V and V can be connected either
to ground or to negative supply. The output of the reference is
fed to the amplifier noninverting input. The op amp is config-
ured as a noninverting amplifier with a gain of +2, which
produces 5 V at the output of the op amp. Using the guaranteed
maximum offset voltage over the temperature, and the typical
TC ratio of the resistors over the full temperature range, the
output is within 15 mV of the calculated value.
MULTIPLE 2.5 V OUTPUTS (ADR821)
06
66
5-
04
0
REF_OUT
AMP_OUT
V–
V+
10k
R1
R2
2.5V
+IN
–IN
0.1F
REF
Figure 40. Multiple 2.5 V Outputs
On some boards, sensitive analog circuits, such as a VCO, exist
with noisy digital circuits. If the supply current requirements
are low (less than 3 mA), series references and op amps can be
used. Using the configuration shown in Figure 40, two different
2.5 V supplies can be created using a single ADR821. The supply
voltage V+ should be greater than 2.8 V and V can be con-
nected to ground or a negative voltage. The op amp is configured
as a voltage follower with a gain of +1, which produces 2.5 V at
the output of the op amp. The output of the reference is fed
to the amplifier noninverting input. Because the op amp has
very low input offset voltage (500 μV maximum over the full
temperature range), the output voltage from the op amp section
tracks the reference voltage within 1 mV. For a dynamic load,
such as the reference input pin on some analog-to-digital
converters, the load should be connected to an op amp output
and the noise sensitive circuitry, such as a VCO, should be
connected to the reference output. If the dynamic load is con-
nected to the reference voltage, any perturbations appear as a
signal to the input of the voltage follower and appear on the
other output.
相關PDF資料 |
PDF描述 |
|---|---|
| MNG10-6RX-BOTTLE | CONN RING NYLON INSUL #6 50PC |
| 0034.6712 | MTS 500MA 250V FST 18.8MM PC |
| MNG10-10RX-BOTTLE | CONN RING NYLON INSUL #10 50PC |
| 0034.6711 | MTS 400MA 250V FST 18.8MM PC |
| 0034.6710 | MTS 315MA 250V FST 18.8MM PC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADR827ARMZ-REEL71 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, Precision Reference and Op Amp |
| ADR827BRMZ | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, Precision Reference and Op Amp |
| ADR827BRMZ-R2 | 功能描述:IC OPAMP GP R-R 1MHZ LP 10MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT |
| ADR827BRMZ-R21 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, Precision Reference and Op Amp |
| ADR827BRMZ-REEL7 | 功能描述:IC OPAMP GP R-R 1MHZ LP 10MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。