- 您現在的位置：買賣IC網 > PDF目錄294846 > ADP1715-080 (ANALOG DEVICES INC) 0.8 V FIXED POSITIVE LDO REGULATOR, 0.25 V DROPOUT, PDSO8 PDF資料下載
參數資料
| 型號： | ADP1715-080 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 固定正電壓單路輸出LDO穩壓器 |
| 英文描述： | 0.8 V FIXED POSITIVE LDO REGULATOR, 0.25 V DROPOUT, PDSO8 |
| 封裝： | PLASTIC, MO-187AA, MSOP-8 |
| 文件頁數： | 7/9頁 |
| 文件大?。?/td> | 1337K |
| 代理商： | ADP1715-080 |
PRELIMINARY TECHNICAL DATA
ADP1715/ADP1716
Rev. PrA | Page 7 of 9
THEORY OF OPERATION
Introduction
The ADP1715/16 is a low-dropout linear regulator that uses
an advanced, proprietary architecture to provide high power
supply rejection ratio (PSRR) and excellent line and load
transient response with just a small 2.2
F ceramic output
capacitor. Supply current in shutdown mode is reduced to
1
A.
Three versions are available: one with fixed output voltage
and soft-start, one with fixed output voltage and output
voltage tracking, and one with adjustable output voltage. The
fixed output voltage is internally set to one of sixteen values
between 0.75V and 3.3V. The adjustable output voltage is set
between 0.8V and 5.0V by an external voltage divider from
OUT to ADJ. The soft-start uses an external capacitor at SS
to control the output voltage ramp. In the case of the
adjustable version, ADP1715-ADJ, the soft-start is controlled
by an internal 3pF capacitor, limiting the output voltage ramp-
up period to approximately 24
s. Tracking limits the output
voltage to the at-or-below the voltage at TRK.
The ADP1715/16 is available in a thermally-enhanced MSOP
package, making it a very compact solution for applications
requiring up to 500mA in a small, low-profile footprint.
Soft-start Function (ADP1715)
For applications that require a controlled startup, the ADP1715
provides a programmable soft-start function. Programmable
soft-start is useful for reducing inrush current upon startup and
for providing voltage sequencing. To implement soft-start,
connect a capacitor from SS to GND. Upon startup, a 1A
current source charges the capacitor. The ADP1715 startup
output voltage is limited by the voltage at SS, providing a
smooth ramp up to the nominal output voltage. The soft-start
time is calculated by TSS= VREF x (CSS/ISS), where TSS is the
soft-start period, VREF is the 0.8V reference voltage, CSS is the
soft-start capacitance from SS to GND, and ISS is the current
sourced from SS (1A). Note that when the ADP1715 is
disabled, the soft-start capacitor is discharged to GND through
an internal 100
resistor.
In the case of the adjustable output version, there is no pin for
soft-start, so the function is switched to an internal 3pF
capacitor. This sets the soft-start ramp-up period to
approximately 24
s. Using the suggested 2.2F output
capacitor, the resulting input inrush current is approximately
460mA, which is less than the maximum 500mA load current.
Voltage Tracking Function (ADP1716)
For applications that require voltage tracking, the ADP1716
provides a TRK pin. The ADP1716’s output voltage is not
allowed to exceed the voltage on the TRK pin, allowing control
of the output voltage of the ADP1716 by another voltage rail in
the system. The ADP1716’s tracking function is always
enabled, hence if the voltage applied to TRK pin drops below
the output voltage at any time, the ADP1716’s output tracks it
down. This ensures that the ADP1716 provides proper voltage
tracking under startup and shutdown as well as under fault
conditions.
The ADP1716 is only available in the fixed output voltage
version. A voltage divider is present from TRK to the error
amplifier input whose divider ratio is equal to the divider from
OUT to the error amplifier. This sets the output voltage equal
to the tracking voltage. Both divider ratios are set by post-
package trim depending on the desired output voltage.
Output Capacitor Selection
The ADP1715/16 is optimized for operation with small ceramic
capacitors. For output voltages, VOUT ≥ 2V, the ADP1715/16
operates with just 2.2
F of output capacitance. For output
voltages below 1.8V, additional output capacitance may be
required. Ceramic capacitors are manufactured with a variety of
dielectrics, each with different behavior over temperature and
applied voltage. When choosing your capacitor be sure to
choose a dielectric adequate to ensure the minimum
capacitance over the necessary temperature range.
Thermal Protection and Current Limit
The ADP1715/16 contains internal current limiting to protect
itself and it’s loads during overload and short-circuit
conditions. In addition to current limiting, this device contains
automatic thermal overload protection circuitry to provide
additional protection under continuous short-circuit conditions.
Adjustable Output Voltage
The ADP1715-ADJ’s output voltage is adjustable over a 0.8V
to 5.0V range. The output voltage is set by connecting a
resistive voltage divider from OUT to ADJ. The output voltage
is calculated using the equation VOUT=0.8V(1+RTOP/RBOTTOM)
where RTOP is the resistor from OUT to ADJ and RBOTTOM is the
resistor from ADJ to GND. The maximum bias current into
ADJ is 100nA, so for less than 0.1% error due to the bias
current, use values less than 12k
for R
BOTTOM.
Shutdown
The ADP1715/16 includes a low power shutdown state entered
by driving EN to GND. In shutdown, power consumption is
1
A. When the ADP1715-XX is disabled, the soft-start
capacitor CSS is discharged to GND with a 100 resistance.
Package and Power Dissipation
The ADP1715/16 use a thermally-enhanced MSOP package,
which achieves a respectable TBD°C/W for such a small
footprint.
相關PDF資料 |
PDF描述 |
|---|---|
| ADP1715-075 | 0.75 V FIXED POSITIVE LDO REGULATOR, 0.25 V DROPOUT, PDSO8 |
| ADP3152 | 5-Bit Programmable Synchronous Switching Regulator Controller(用于PⅡ處理器的5位可編程同步開關穩壓控制器) |
| ADP3629ARMZ-R7 | High Speed, Dual, 2 A MOSFET Driver, inverting A/B input pins; Package: 8 ld MSOP; No of Pins: 8; Temperature Range: Ind |
| ADP3629ARZ-R7 | High Speed, Dual, 2 A MOSFET Driver, inverting A/B input pins; Package: 8 ld SOIC; No of Pins: 8; Temperature Range: Ind |
| ADP3630ARMZ-R7 | High Speed, Dual, 2 A MOSFET Driver, non-inverting A/B input pins; Package: 8 ld MSOP; No of Pins: 8; Temperature Range: Ind |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADP1715-1.8-EVALZ | 功能描述:BOARD EVAL FOR ADP1715-1.8 RoHS:是 類別:編程器，開發系統 >> 評估板 - 線性穩壓器 (LDO) 系列:- 產品變化通告:1Q2012 Discontinuation 30/Mar/2012 設計資源:NCP590MNDPTAGEVB Gerber Files 標準包裝:1 系列:- 每 IC 通道數:2 - 雙 輸出電壓:1.8V，2.8V 電流 - 輸出:300mA 輸入電壓:2.1 ~ 5.5 V 穩壓器類型:正，固定式 工作溫度:-40°C ~ 85°C 板類型:完全填充 已供物品:板 已用 IC / 零件:NCP590MNDP 其它名稱:NCP590MNDPTAGEVB-NDNCP590MNDPTAGEVBOS |
| ADP1715-3.3-EVALZ | 功能描述:BOARD EVAL FOR ADP1715-3.3 RoHS:是 類別:編程器，開發系統 >> 評估板 - 線性穩壓器 (LDO) 系列:- 產品變化通告:1Q2012 Discontinuation 30/Mar/2012 設計資源:NCP590MNDPTAGEVB Gerber Files 標準包裝:1 系列:- 每 IC 通道數:2 - 雙 輸出電壓:1.8V，2.8V 電流 - 輸出:300mA 輸入電壓:2.1 ~ 5.5 V 穩壓器類型:正，固定式 工作溫度:-40°C ~ 85°C 板類型:完全填充 已供物品:板 已用 IC / 零件:NCP590MNDP 其它名稱:NCP590MNDPTAGEVB-NDNCP590MNDPTAGEVBOS |
| ADP1715ARMZ | 制造商:Analog Devices 功能描述:IC V REG LDO 0.5A ADJ SMD MSOP8 制造商:Analog Devices 功能描述:IC, V REG, LDO 0.5A ADJ, SMD, MSOP8 |
| ADP1715ARMZ-0.75R7 | 功能描述:IC REG LDO 0.75V .5A 8-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:2.7V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.21V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最小）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 供應商設備封裝:TSOT-23-5 包裝:剪切帶 (CT) 產品目錄頁面:1100 (CN2011-ZH PDF) 其它名稱:576-1852-1 |
| ADP1715ARMZ-0.85R7 | 功能描述:IC REG LDO 0.85V .5A 8-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:2.7V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.21V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最小）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 供應商設備封裝:TSOT-23-5 包裝:剪切帶 (CT) 產品目錄頁面:1100 (CN2011-ZH PDF) 其它名稱:576-1852-1 |
發布緊急采購，3分鐘左右您將得到回復。