- 您現在的位置：買賣IC網 > PDF目錄223311 > ADP125ARHZ (ANALOG DEVICES INC) 5.5V INPUT, 500 MA, LOW QUIESCENT CURRENT, CMOS LINEAR REGULATOR W/EXTERNAL VOLTAGE DIVIDER No of Pins: 8 Temperature Range: Ind PDF資料下載
參數資料
| 型號： | ADP125ARHZ |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 可調正電壓單路輸出LDO穩壓器 |
| 英文描述： | 5.5V INPUT, 500 MA, LOW QUIESCENT CURRENT, CMOS LINEAR REGULATOR W/EXTERNAL VOLTAGE DIVIDER No of Pins: 8 Temperature Range: Ind |
| 中文描述： | 0.8 V-5 V ADJUSTABLE POSITIVE LDO REGULATOR, 0.23 V DROPOUT, PDSO8 |
| 封裝： | ROHS COMPLIANT, MO-187AAT, MSOP-8 |
| 文件頁數： | 4/20頁 |
| 文件大?。?/td> | 648K |
| 代理商： | ADP125ARHZ |
ADP124/ADP125
Rev. A | Page 12 of 20
APPLICATIONS INFORMATION
CAPACITOR SELECTION
Output Capacitor
The ADP124/ADP125 are designed for operation with small,
space-saving ceramic capacitors, but these devices can function
with most commonly used capacitors as long as care is taken to
ensure an appropriate effective series resistance (ESR) value. The
ESR of the output capacitor affects the stability of the LDO control
loop. A minimum of 0.70 F capacitance with an ESR of 1 or
less is recommended to ensure stability of the ADP124/ADP125.
The transient response to changes in load current is also affected by
the output capacitance. Using a larger value of output capacitance
improves the transient response of the ADP124/ADP125 to
dynamic changes in load current. Figure 30 and Figure 31 show
the transient responses for output capacitance values of 1 F and
4.7 F, respectively.
08476-
028
M400ns
A CH1
200mA
1
2
T
13.20%
VIN = 4V
VOUT = 3.3V
VOUT
IOUT
1mA TO 500mA LOAD STEP
CH1 500mA
B
W
CH2 50.0mV
B
W
Figure 30. Output Transient Response, COUT = 1 F
08476-
029
M400ns
A CH1
200mA
1
2
T
13.60%
VIN = 4V
VOUT = 3.3V
VOUT
IOUT
1mA TO 500mA LOAD STEP
CH1 500mA
B
W
CH2 50.0mV
B
W
Figure 31. Output Transient Response, COUT = 4.7 F
Input Bypass Capacitor
Connecting a 1 F capacitor from VIN to GND reduces the circuit
sensitivity to the printed circuit board (PCB) layout, especially
when a long input trace or high source impedance is encountered.
If greater than 1 F of output capacitance is required, the input
capacitor should be increased to match it.
Input and Output Capacitor Properties
Any good quality ceramic capacitors can be used with the
ADP124/ADP125, as long as the capacitor meets the minimum
capacitance and maximum ESR requirements. Ceramic capacitors
are manufactured with a variety of dielectrics, each with different
behavior over temperature and applied voltage. Capacitors must
have an adequate dielectric to ensure the minimum capacitance
over the necessary temperature range and dc bias conditions.
Using an X5R or X7R dielectric with a voltage rating of 6.3 V or
10 V is recommended. However, using Y5V and Z5U dielectrics
are not recommended for any LDO, due to their poor temperature
and dc bias characteristics.
Figure 32 depicts the capacitance vs. capacitor voltage bias charac-
teristics of an 0402, 1 F, 10 V X5R capacitor. The voltage stability
of a capacitor is strongly influenced by the capacitor size and the
voltage rating. In general, a capacitor in a larger package or of a
higher voltage rating exhibits better stability. The temperature
variation of the X5R dielectric is about ±15% over the 40°C to
+85°C temperature range and is not a function of package or
voltage rating.
0.70
0.75
0.80
0.85
0.90
0.95
1.00
1.05
1.10
0
1
2
3
4
5
6
7
BIAS VOLTAGE (V)
CA
P
ACI
T
ANCE
(
F
)
08476-
030
Figure 32. Capacitance vs. Capacitor Voltage Bias Characteristics
Equation 1 can be used to determine the worst-case capacitance,
accounting for capacitor variation over temperature, component
tolerance, and voltage.
CEFF = C × (1 TEMPCO) × (1 TOL)
(1)
where:
CEFF is the effective capacitance at the operating voltage.
C is the rated capacitance value.
TEMPCO is the worst-case capacitor temperature coefficient.
TOL is the worst-case component tolerance.
相關PDF資料 |
PDF描述 |
|---|---|
| ADP125ARHZ-R7 | 5.5V INPUT, 500 MA, LOW QUIESCENT CURRENT, CMOS LINEAR REGULATOR W/EXTERNAL VOLTAGE DIVIDER No of Pins: 8 Temperature Range: Ind |
| ADP1875ARQZ-0.3-R7 | SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO16 |
| ADP2121ACBZ-1.85R7 | 1.222 A SWITCHING REGULATOR, 6640 kHz SWITCHING FREQ-MAX, PBGA6 |
| ADS-119MC | 1-CH 12-BIT FLASH METHOD ADC, PARALLEL ACCESS, CDIP24 |
| ADS6243IRGZT | 2-CH 14-BIT PROPRIETARY METHOD ADC, SERIAL ACCESS, PQCC48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADP125ARHZ-R7 | 功能描述:IC REG LDO ADJ .5A 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:75 系列:- 穩壓器拓?fù)浣Y(jié)構:正，可調式 輸出電壓:1.2 V ~ 37 V 輸入電壓:4.2 V ~ 40 V 電壓 - 壓降（標準）:- 穩壓器數量:1 電流 - 輸出:500mA 電流 - 限制（最?。?500mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-252-3，DPak（2 引線+接片），SC-63 供應商設備封裝:TO-252-3 包裝:管件 產品目錄頁面:1286 (CN2011-ZH PDF) 其它名稱:*LM317AMDT/NOPBLM317AMDT |
| ADP125CP-EVALZ | 功能描述:BOARD EVAL ADP125 RoHS:是 類別:編程器，開發系統 >> 評估板 - 線性穩壓器 (LDO) 系列:- 產品變化通告:1Q2012 Discontinuation 30/Mar/2012 設計資源:NCP590MNDPTAGEVB Gerber Files 標準包裝:1 系列:- 每 IC 通道數:2 - 雙 輸出電壓:1.8V，2.8V 電流 - 輸出:300mA 輸入電壓:2.1 ~ 5.5 V 穩壓器類型:正，固定式 工作溫度:-40°C ~ 85°C 板類型:完全填充 已供物品:板 已用 IC / 零件:NCP590MNDP 其它名稱:NCP590MNDPTAGEVB-NDNCP590MNDPTAGEVBOS |
| ADP125-EVALZ | 功能描述:BOARD EVALUATION ADJUSTABLE V RoHS:是 類別:編程器，開發系統 >> 評估板 - 線性穩壓器 (LDO) 系列:- 產品變化通告:1Q2012 Discontinuation 30/Mar/2012 設計資源:NCP590MNDPTAGEVB Gerber Files 標準包裝:1 系列:- 每 IC 通道數:2 - 雙 輸出電壓:1.8V，2.8V 電流 - 輸出:300mA 輸入電壓:2.1 ~ 5.5 V 穩壓器類型:正，固定式 工作溫度:-40°C ~ 85°C 板類型:完全填充 已供物品:板 已用 IC / 零件:NCP590MNDP 其它名稱:NCP590MNDPTAGEVB-NDNCP590MNDPTAGEVBOS |
| ADP1261 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PRECISION SEMICONDUCTOR PRESSURE SENSOR |
| ADP1271 | 功能描述:板上安裝壓力/力傳感器 490.3kPa 5.0kgf/cm Pressure Sensor RoHS:否 制造商:Honeywell 工作壓力:0 bar to 4 bar 壓力類型:Gage 準確性:+ / - 0.25 % 輸出類型:Digital 安裝風格:Through Hole 工作電源電壓:5 V 封裝 / 箱體:SIP 端口類型:Dual Radial Barbed, Same sides |
發布緊急采購，3分鐘左右您將得到回復。