參數資料
型號: ADN2890ACP-RL7
廠商: Analog Devices Inc
文件頁數: 11/12頁
文件大小: 0K
描述: IC AMP LIM 16LFCSP
產品變化通告: Product Discontinuance 27/July/2010
標準包裝: 1
放大器類型: 限制
電路數: 1
輸出類型: 差分
電壓 - 輸入偏移: 100µV
電流 - 電源: 39mA
電壓 - 電源,單路/雙路(±): 3 V ~ 3.6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 16-VFQFN 裸露焊盤,CSP
供應商設備封裝: 16-LFCSP-VQ
包裝: 剪切帶 (CT)
其它名稱: ADN2890ACP-RL7CT
ADN2890
Data Sheet
Rev. A | Page 8 of 12
THEORY OF OPERATION
LIMAMP
Input Buffer
The limiting amplifier has differential inputs (PIN/NIN), with
an internal 50 termination. The ROSA (receive optical sub-
assembly) is typically ac-coupled to the ADN2890 inputs,
although dc coupling is possible.
An internal offset correction loop requires that a capacitor be
connected between the CAZ1 and CAZ2 pins. A 0.01 F
capacitor provides a low frequency cutoff of 2 kHz.
CML Output Buffer
The ADN2890 provides CML outputs, OUTP/OUTN. The
outputs are internally terminated with 50 to VCC.
The outputs can be kept at a static voltage by driving the
SQUELCH pin to a logic high. The SQUELCH pin can be
driven directly by the LOS pin, which automatically disables
the LIMAMP outputs in situations with no data input.
LOSS OF SIGNAL (LOS) DETECTOR
The receiver front-end LOS detector circuit indicates when the
input signal level has fallen below the user-adjustable threshold.
The threshold is set by a resistor connected between the
THRADJ pin and VEE. The ADN2890 LOS circuit has a trip
point down to <3.0 mV with >3 dB electrical hysteresis to
prevent chatter at the LOS output. The LOS output is an open-
collector output that must be pulled up externally with a 4.7 k
to 10 k resistor.
RECEIVED SIGNAL STRENGTH INDICATOR (RSSI)
The ADN2890 has an on-chip RSSI circuit that automatically
detects the average received power based on a direct measure-
ment of the PIN photodiode’s current. The photodiode bias is
supplied by the ADN2890, which allows a very accurate, on-
chip, average power measurement based on the amount of
current supplied to the photodiode. The output of the RSSI is a
current that is directly proportional to the average amount of
PIN photodiode current. Placing a resistor between the
RSSI_OUT pin and GND converts the current to a GND
referenced voltage. This function eliminates the need for
external RSSI circuitry in SFF-8472 compliant optical receivers.
SQUELCH MODE
Driving the SQUELCH input to a logic high disables the
limiting amplifier outputs. The SQUELCH input can be
connected to the LOS output to keep the limiting amplifier
outputs at a static voltage level anytime the input level to the
limiting amplifier drops below the programmed LOS threshold.
相關PDF資料
PDF描述
ADN2891ACPZ-500RL7 IC AMP LIM 16LFCSP
ADN2892ACPZ-500RL7 IC AMP LIM 16LFCSP
ADR827BRMZ-REEL7 IC OPAMP GP R-R 1MHZ LP 10MSOP
ADTL084ARZ-REEL7 IC OPAMP JFET 5MHZ QUAD 14SOIC
AFB02512HHA FAN DC AXIAL 12V 25X10 13000RPM
相關代理商/技術參數
參數描述
ADN2890ACPZ-RL 功能描述:IC AMP LIM 16LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:13 V/µs 增益帶寬積:3MHz -3db帶寬:- 電流 - 輸入偏壓:65pA 電壓 - 輸入偏移:3000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):7 V ~ 36 V,±3.5 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:通孔 封裝/外殼:8-DIP(0.300",7.62mm) 供應商設備封裝:8-PDIP 包裝:管件
ADN2890ACPZ-RL7 功能描述:IC AMP LIM 16LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:13 V/µs 增益帶寬積:3MHz -3db帶寬:- 電流 - 輸入偏壓:65pA 電壓 - 輸入偏移:3000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):7 V ~ 36 V,±3.5 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:通孔 封裝/外殼:8-DIP(0.300",7.62mm) 供應商設備封裝:8-PDIP 包裝:管件
ADN2890XCP 制造商:Analog Devices 功能描述:- Trays
ADN2891 制造商:AD 制造商全稱:Analog Devices 功能描述:3.3 V, 3.2 Gbps, Limiting Amplifier
ADN2891ACP 制造商:AD 制造商全稱:Analog Devices 功能描述:3.3 V, 3.2 Gbps, Limiting Amplifier