- 您現在的位置：買賣IC網 > PDF目錄10507 > ADM211EARS-REEL (Analog Devices Inc)IC TXRX RS-232 5V 0.1UF 28SSOP PDF資料下載
參數資料
| 型號： | ADM211EARS-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 5/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX RS-232 5V 0.1UF 28SSOP |
| 標準包裝： | 1 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 4/5 |
| 規程： | RS232 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 789 (CN2011-ZH PDF) |
| 其它名稱： | ADM211EARS-REELDKR ADM211EARSREELDKR ADM211EARSREELDKR-ND |
ADM206E/ADM207E/ADM208E/ADM211E/ADM213E
Rev. E | Page 13 of 20
burst of sparks as the relay contacts separate. The voltage
appearing on the line, therefore, consists of a burst of extremely
fast transient impulses. A similar effect occurs when switching
on fluorescent lights.
The fast transient burst test defined in IEC 1000-4-4 simulates
this arcing; its waveform is illustrated in Figure 29. It consists of
a burst of 2.5 kHz to 5 kHz transients repeating at 300 ms
intervals. It is specified for both power and data lines.
300ms
15ms
t
V
5ns
0.2ms/0.4ms
50ns
V
t
0
00
68
-0
29
Figure 29. IEC 1000-4-4 Fast Transient Waveform
Table 9.
Level
V Peak (kV)
PSU
V Peak (kV)
I/O
1
0.5
0.25
2
1
0.5
3
2
1
4
2
A simplified circuit diagram of the actual EFT generator is
illustrated in Figure 30.
The transients are coupled onto the signal lines using an EFT
coupling clamp. The clamp is 1 m long and surrounds the cable
completely, providing maximum coupling capacitance (50 pF to
200 pF typical) between the clamp and the cable. High energy
transients are capacitively coupled onto the signal lines. Fast rise
times (5 ns), as specified by the standard, result in very effective
coupling. Because high voltages are coupled onto the signal
lines, this test is very severe. The repetitive transients can often
cause problems where single pulses do not. Destructive latch-up
can be induced due to the high energy content of the transients.
Note that this stress is applied while the interface products are
powered up and are transmitting data. The EFT test applies
hundreds of pulses with higher energy than ESD. Worst-case
transient current on an I/O line can be as high as 40 A.
Test results are classified according to the following:
Classification 1: Normal performance within speci-
fication limits.
Classification 2: Temporary degradation or loss of
performance that is self recoverable.
Classification 3: Temporary degradation or loss of function
or performance that requires operator intervention or
system reset.
Classification 4: Degradation or loss of function that is not
recoverable due to damage.
ADM2xxE products meet Classification 2 and have been tested
under worst-case conditions using unshielded cables. Data
transmission during the transient condition is corrupted, but it
can resume immediately following the EFT event without user
intervention.
RC
RM
CC
L
ZS
CD
50
OUTPUT
HIGH
VOLTAGE
SOURCE
00
068
-03
0
Figure 30. IEC 1000-4-4 Fast Transient Generator
IEC 1000-4-3 RADIATED IMMUNITY
IEC 1000-4-3 (previously IEC 801-3) describes the measure-
ment method and defines the levels of immunity to radiated
electromagnetic fields. It was originally intended to simulate the
electromagnetic fields generated by portable radio transceivers
or any other devices that generate continuous wave-radiated
EM energy. Its scope has since been broadened to include
spurious EM energy that can be radiated from fluorescent
lights, thyristor drives, inductive loads, and other sources.
Testing for immunity involves irradiating the device with an EM
field. There are various methods of achieving this, including use of
anechoic chamber, stripline cell, TEM cell, and GTEM cell. A
stripline cell consists of two parallel plates with an electric field
developed between them. The device under test is placed within
the cell and exposed to the electric field. There are three severity
levels having field strengths ranging from 1 V/m to 10 V/m.
Results are classified in a similar fashion to those for IEC 100044.
Classification 1: Normal operation.
Classification 2: Temporary degradation or loss of function
that is self recoverable when the interfering signal is
removed.
Classification 3: Temporary degradation or loss of function
that requires operator intervention or system reset when
the interfering signal is removed.
Classification 4: Degradation or loss of function that is not
recoverable due to damage.
The ADM2xxE family of products easily meets Classification 1 at
the most stringent requirement (Level 3). In fact, field strengths
up to 30 V/m showed no performance degradation, and error-
free data transmission continued even during irradiation.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-2TT-MX | CONVERTER MOD DC/DC 6.5V 75W |
| MS3100A24-27P | CONN RCPT 7POS WALL MNT W/PINS |
| VI-24H-MX | CONVERTER MOD DC/DC 52V 75W |
| MS3102R22-12S | CONN RCPT 5POS BOX MNT W/SCKT |
| VI-24F-MX | CONVERTER MOD DC/DC 72V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM211EARSZ | 功能描述:IC TX/RX RS-232 5V 0.1UF 28SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2 |
| ADM211EARSZ1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:EMI/EMC-Compliant, ?±15 kV ESDProtected, RS-232 Line Drivers/Receivers |
| ADM211EARSZ-2REEL | 制造商:Analog Devices 功能描述:5V RS-232 TRANSCEIVER W/COMPLIANCE I.C. - Tape and Reel |
| ADM211EARSZ-REEL | 功能描述:IC TXRX RS-232 5V 0.1UF 28SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:2,500 系列:- 類型:驅動器 驅動器/接收器數:4/0 規程:RS422 電源電壓:4.5 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| ADM211EARSZ-REEL1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:EMI/EMC-Compliant, ?±15 kV ESDProtected, RS-232 Line Drivers/Receivers |
發布緊急采購，3分鐘左右您將得到回復。