- 您現在的位置：買賣IC網 > PDF目錄378278 > ADC0817CCN (NATIONAL SEMICONDUCTOR CORP) 8-Bit レP Compatible A/D Converters with 16-Channel Multiplexer PDF資料下載
參數資料
| 型號： | ADC0817CCN |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | ADC |
| 英文描述： | 8-Bit レP Compatible A/D Converters with 16-Channel Multiplexer |
| 中文描述： | 16-CH 8-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, PDIP40 |
| 封裝： | PLASTIC, DIP-40 |
| 文件頁數： | 7/13頁 |
| 文件大小： | 245K |
| 代理商： | ADC0817CCN |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁
Timing Diagram
(Continued)
The successive approximation register (SAR) performs 8 it-
erations to approximate the input voltage. For any SAR type
converter, n-iterations are required for an n-bit converter.
Figure 2 shows a typical example of a 3-bit converter. In the
ADC0816, ADC0817, the approximation technique is ex-
tended to 8 bits using the 256R network.
The A/D converter’s successive approximation register
(SAR) is reset on the positive edge of the start conversion
(SC) pulse. The conversion is begun on the falling edge of
the start conversion pulse.Aconversion in process will be in-
terrupted by receipt of a new start conversion pulse. Con-
tinuous conversion may be accomplished by tying the
end-of-conversion (EOC) output to the SC input. If used in
this mode, an external start conversion pulse should be ap-
plied after power up. End-of-conversion will go low between
0 and 8 clock pulses after the rising edge of start conversion.
The most important section of the A/D converter is the com-
parator. It is this section which is responsible for the ulimate
accuracy of the entire converter. It is also the comparator
drift which has the greatest influence on the repeatability of
the device. A chopper-stabilized comparator provides the
most effective method of satisfying all the converter require-
ments.
The chopper-stabilized comparator converts the DC input
signal into an AC signal. This signal is then fed through a
high gain AC amplifier and has the DC level restored. This
technique limits the drift component of the amplifier since the
drift is a DC component which is not passed by the AC am-
plifier. This makes the entire A/D converter extremely insen-
sitive to temperature, long term drift and input offset errors.
Figure 4 shows a typical error curve for the ADC0816 as
measured using the procedures outlined in AN-179.
www.national.com
7
相關PDF資料 |
PDF描述 |
|---|---|
| ADC0819BCN | 8-Bit Serial I/O A/D Converter with 19-Channel Multiplexer |
| ADC0819BCV | 8-Bit Serial I/O A/D Converter with 19-Channel Multiplexer |
| ADC0819CCV | 8-Bit Serial I/O A/D Converter with 19-Channel Multiplexer |
| ADC0819CIN | 8-Bit Serial I/O A/D Converter with 19-Channel Multiplexer |
| ADC081S021 | Single Channel, 500 kSPS, 8-Bit A/D Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADC0817CCN | 制造商:Texas Instruments 功能描述:DATA ACQUISITION UNIT DIP40 817 |
| ADC0817CCN/A+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog-to-Digital Converter， 8-Bit |
| ADC0817CCN/NOPB | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADC0819 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:8-Bit Serial I/O A/D Converter with 19-Channel Multiplexer |
| ADC0819_09 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:8-Bit Serial I/O A/D Converter with 19-Channel Multiplexer |
發布緊急采購，3分鐘左右您將得到回復。
