- 您現在的位置：買賣IC網 > PDF目錄375250 > ADA4410-6 (Analog Devices, Inc.) Integrated Video Filter with Selectable Cutoff Frequencies for RGB, HD/SD Y, C, and CV PDF資料下載
參數資料
| 型號： | ADA4410-6 |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | Integrated Video Filter with Selectable Cutoff Frequencies for RGB, HD/SD Y, C, and CV |
| 中文描述： | 集成視頻濾波器截止可選為RGB，頻率高清/標清輜，C和簡歷 |
| 文件頁數： | 7/16頁 |
| 文件大?。?/td> | 343K |
| 代理商： | ADA4410-6 |
ADA4410-6
ABSOLUTE MAXIMUM RATINGS
Table 3.
Parameter
Supply Voltage
Power Dissipation
Storage Temperature Range
Operating Temperature Range
Lead Temperature (Soldering 10 sec)
Junction Temperature
Rev. B | Page 7 of 16
Rating
12 V
See Figure 2
–65°C to +125°C
–40°C to +85°C
300°C
150°C
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
THERMAL RESISTANCE
θ
JA
is specified for the worst-case conditions, that is, θ
JA
is
specified for a device soldered in the circuit board with its
exposed paddle soldered to a pad on the PCB surface that is
thermally connected to a copper plane.
Table 4. Thermal Resistance
Package Type
5 mm × 5 mm, 32-Lead LFCSP
Maximum Power Dissipation
The maximum safe power dissipation in the ADA4410-6
package is limited by the associated rise in junction temperature
(T
J
) on the die. At approximately 150°C, which is the glass
transition temperature, the plastic changes its properties. Even
temporarily exceeding this temperature limit can change the
stresses that the package exerts on the die, permanently shifting
the parametric performance of the ADA4410-6. Exceeding a
junction temperature of 150°C for an extended time can result
in changes in the silicon devices, potentially causing failure.
θ
JA
43
θ
JC
5.1
Unit
°C/W
The power dissipated in the package (P
D
) is the sum of the
quiescent power dissipation and the power dissipated in the
package due to the load drive for all outputs. The quiescent
power is the voltage between the supply pins (V
S
) times the
quiescent current (I
S
). The power dissipated due to load drive
depends upon the particular application. For each output, the
power due to load drive is calculated by multiplying the load
current by the associated voltage drop across the device. The
power dissipated due to all of the loads is equal to the sum of
the power dissipations due to each individual load. RMS
voltages and currents must be used in these calculations.
Airflow increases heat dissipation, effectively reducing θ
JA
. In
addition, more metal directly in contact with the package leads
from metal traces, through-holes, ground, and power planes,
reduces the θ
JA
. The exposed paddle on the underside of the
package must be soldered to a pad on the PCB surface that is
thermally connected to a copper plane to achieve the specified θ
JA
.
Figure 2 shows the maximum safe power dissipation in the
package vs. the ambient temperature for the 32-lead LFCSP
(43°C/W) on a JEDEC standard 4-layer board with the underside
paddle soldered to a pad that is thermally connected to a PCB
plane. θ
JA
values are approximations.
1.0
1.5
2.0
2.5
3.0
3.5
4.5
4.0
–40
–20
0
20
40
60
LFCSP
80
0
AMBIENT TEMPERATURE (°C)
M
Figure 2. Maximum Power Dissipation vs. Temperature for a 4-Layer Board
ESD CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily accumulate
on the human body and test equipment and can discharge without detection. Although this product features
proprietary ESD protection circuitry, permanent damage may occur on devices subjected to high energy
electrostatic discharges. Therefore, proper ESD precautions are recommended to avoid performance
degradation or loss of functionality.
相關PDF資料 |
PDF描述 |
|---|---|
| ADA4410-6ACPZ-R2 | Integrated Video Filter with Selectable Cutoff Frequencies for RGB, HD/SD Y, C, and CV |
| ADA4410-6ACPZ-R7 | Integrated Video Filter with Selectable Cutoff Frequencies for RGB, HD/SD Y, C, and CV |
| ADA4410-6ACPZ-RL | Integrated Video Filter with Selectable Cutoff Frequencies for RGB, HD/SD Y, C, and CV |
| ADA4411-3 | Integrated Triple Video Filter and Buffer with Selectable Cutoff Frequencies and Multiplexed Inputs for RGB, HD/SD |
| ADA4411-3ARQZ | Integrated Triple Video Filter and Buffer with Selectable Cutoff Frequencies and Multiplexed Inputs for RGB, HD/SD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADA4410-6ACPZ-R2 | 功能描述:IC VIDEO FILTER SELECT 32-LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064 |
| ADA4410-6ACPZ-R7 | 功能描述:IC VIDEO FILTER SELECT 32-LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064 |
| ADA4410-6ACPZR7KL1 | 制造商:Analog Devices 功能描述: |
| ADA4410-6ACPZ-RL | 功能描述:IC VIDEO FILTER SELECT 32-LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064 |
| ADA4411-3 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Integrated Triple Video Filter and Buffer with Selectable Cutoff Frequencies and Multiplexed Inputs for RGB, HD/SD |
發布緊急采購，3分鐘左右您將得到回復。