- 您現在的位置：買賣IC網 > PDF目錄5426 > ADA4310-1ACPZ-RL (Analog Devices Inc)IC OPAMP CF DUAL LDIST 16LFCSP PDF資料下載
參數資料
| 型號： | ADA4310-1ACPZ-RL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 3/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP CF DUAL LDIST 16LFCSP |
| 標準包裝： | 5,000 |
| 放大器類型： | 電流反饋 |
| 電路數： | 2 |
| 轉換速率： | 820 V/µs |
| -3db帶寬： | 190MHz |
| 電流 - 輸入偏壓： | 6µA |
| 電壓 - 輸入偏移： | 1000µV |
| 電流 - 電源： | 7.6mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 12 V，±2.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-VQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 16-LFCSP-VQ EP（4x4） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
ADA4310-1
Rev. 0 | Page 11 of 16
APPLICATION INFORMATION
FEEDBACK RESISTOR SELECTION
The feedback resistor has a direct impact on the closed-loop
bandwidth and stability of the current feedback op amp.
Reducing the resistance below the recommended value can
make the amplifier response peak and even become unstable.
Increasing the size of the feedback resistor beyond the recom-
mended value reduces the closed-loop bandwidth. Table 6
provides a convenient reference for quickly determining the
feedback and gain resistor values, and the corresponding
bandwidth, for common gain configurations. The recommended
value of feedback resistor for the ADA4310-1 is 499 Ω.
Table 6. Recommended Values and Frequency Performance1
Gain
RF (Ω)
RG (Ω)
3 dB SS BW (MHz)
+2
499
230
+5
499
124
190
+5
1k
249
125
+10
499
55.4
160
+20
499
26.1
115
1 Conditions: VS = ±6 V, TA = 25°C, RL = 50 Ω, PD1, PD0 = 0,0.
POWER CONTROL MODES OF OPERATION
The ADA4310-1 features four power modes: full power,
power, power, and shutdown. The power modes are
controlled by two logic pins, PD0 and PD1. The power-down
control pins are compatible with standard 3 V and 5 V CMOS
logic. Table 7 shows the various power modes and associated
logic states. In the power-down mode, the output of the
amplifier goes into a high-impedance state.
Table 7. Power Modes
PD1
PD0
Power Mode
Total Supply
Current (mA)
Output
Impedance
Low
Full Power
15.2
Low
High
Power
11.2
Low
High
Low
Power
7.8
Low
High
Power Down
1.3
High
EXPOSED THERMAL PAD CONNECTIONS
The exposed thermal pad on the 10-lead MSOP package is both
the reference for the PD pins and the only electrical connection
for the negative supply voltage. Therefore, in the 10-lead MSOP
package, the ADA4310-1 can only be used on a single supply.
The exposed thermal pad MUST be connected to ground.
Failure to do so will render the part inoperable.
The 4 mm × 4 mm 16-lead LFCSP package has dedicated pins
for both the positive and negative supplies, and it can be used
in either single supply or dual supply applications. There is no
electrical connection for the exposed thermal pad. Although the
pad could theoretically be connected to any potential, it is still
typically connected to ground.
A requirement for both packages is that the thermal pad be
connected to a solid plane with low thermal resistance, ensuring
adequate heat transfer away from the die and into the board.
POWER LINE APPLICATION
Applications (that is, powerline AV modems) requiring greater
than 10 dBm peak power should consider using an external line
driver, such as the ADA4310-1. Figure 21 shows an example
interface between the TxDAC output and ADA4310-1 biased
for single-supply operation. The TxDAC’s peak-to-peak differ-
ential output voltage swing should be limited to 2 V p-p, with
the ADA4310-1’s gain configured to realize the additional
voltage gain required by the application. A low-pass filter
should be considered to filter the DAC images inherent in the
signal reconstruction process. In addition, dc blocking capacitors
are required to level-shift the TxDAC’s output signal to the
common-mode level of the ADA4310-1 (that is, AVDD/2).
06027-
019
0.1F
RSET
R
E
F
IO
IOUTP+
IOUTP–
0dB TO –7.5dB
OPTIONAL
LCLPF
AVDD/2
T
xD
IS
A
B
L
E
ADA4310-1
1/2
RE
F
A
D
J
TxDAC
Figure 21. TxDAC Output Directly via Center-Tap Transformer
相關PDF資料 |
PDF描述 |
|---|---|
| RP1608S-R18-F | RES HP .18 OHM 1/5W 1% 0603 SMD |
| 1SMB16AT3 | TVS ZENER UNIDIRECT 600W 16V SMB |
| TSW-138-08-S-D | CONN HEADER 76POS .100" DL GOLD |
| TSW-139-08-S-D | CONN HEADER 78POS .100" DL GOLD |
| TSW-125-08-S-D | CONN HEADER 50POS .100" DL GOLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADA4310-1ARHZ | 功能描述:IC OPAMP CF DUAL LDIST 10MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT |
| ADA4310-1ARHZ-R7 | 功能描述:IC OPAMP CF DUAL LDIST 10MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR) |
| ADA43101ARHZRL | 制造商:ANALOG 功能描述:REEL |
| ADA4310-1ARHZ-RL | 功能描述:IC OPAMP CF DUAL LDIST 10MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:160 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:10 V/µs 增益帶寬積:9MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:250µV 電流 - 電源:730µA 電流 - 輸出 / 通道:28mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:管件 |
| ADA4311-1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Cost, Dual, High Current Output Line Driver with Shutdown |
發布緊急采購，3分鐘左右您將得到回復。