fOUT
參數資料
型號: AD9838BCPZ-RL7
廠商: Analog Devices Inc
文件頁數: 8/32頁
文件大?。?/td> 0K
描述: IC DDS 16MHZ LP 20LFCSP
產品培訓模塊: Direct Digital Synthesis Tutorial Series (1 of 7): Introduction
Direct Digital Synthesizer Tutorial Series (7 of 7): DDS in Action
Direct Digital Synthesis Tutorial Series (3 of 7): Angle to Amplitude Converter
Direct Digital Synthesis Tutorial Series (6 of 7): SINC Envelope Correction
Direct Digital Synthesis Tutorial Series (4 of 7): Digital-to-Analog Converter
Direct Digital Synthesis Tutorial Series (2 of 7): The Accumulator
標準包裝: 1
分辨率(位): 10 b
主 fclk: 16MHz
電源電壓: 2.3 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 20-WFQFN 裸露焊盤,CSP
供應商設備封裝: 20-LFCSP-WQ(4x4)
包裝: 標準包裝
其它名稱: AD9838BCPZ-RL7DKR
AD9838
Rev. A | Page 16 of 32
The prominence of the aliased images depends on the ratio of
fOUT to MCLK. If the ratio is small, the aliased images are very
prominent and of a relatively high energy level as determined by
the sin(x)/x roll-off of the quantized DAC output. In fact, depend-
ing on the fOUT/reference clock ratio, the first aliased image can
be on the order of 3 dB below the fundamental.
A low-pass filter is generally placed between the output of the
DAC and the input of the comparator to further suppress the
effects of aliased images. To avoid unwanted (and unexpected)
output anomalies, it is necessary to consider the relationship of
the selected output frequency and the reference clock frequency.
To apply the AD9838 as a clock generator, limit the selected
output frequency to <33% of the reference clock frequency. In
this way, the user can prevent the generation of aliased signals
that fall within, or close to, the output band of interest (generally
the dc selected output frequency). This practice reduces the
complexity (and cost) of the external filter requirement for the
clock generator application. For more information, see the
To enable the comparator, the SIGN/PIB and OPBITEN bits in
the control resister must be set to 1 (see Table 18).
REGULATOR
The AD9838 has separate power supplies for the analog and
digital sections. AVDD provides the power supply required for
the analog section, and DVDD provides the power supply for
the digital section. Both supplies can have a value of 2.3 V to
5.5 V and are independent of each other. For example, the
analog section can be operated at 5 V, and the digital section
can be operated at 3 V, or vice versa.
The internal digital section of the AD9838 is operated at 2.5 V.
An on-board regulator steps down the voltage applied at DVDD
to 2.5 V. The digital interface (serial port) of the AD9838 also
operates from DVDD. These digital signals are level shifted
within the AD9838 to make them 2.5 V compatible.
If the voltage applied at the DVDD pin of the AD9838 is less than
or equal to 2.7 V, the CAP/2.5V and DVDD pins should be tied
together to bypass the on-board regulator.
SYSTEM CLOCK
fOUT
fC fOUT
fC + fOUT
2
fC fOUT
2
fC + fOUT
3
fC fOUT
3
fC + fOUT
fC
0Hz
FIRST
IMAGE
SECOND
IMAGE
THIRD
IMAGE
FOURTH
IMAGE
FIFTH
IMAGE
SIXTH
IMAGE
2
fC
3
fC
FREQUENCY (Hz)
SI
G
N
A
L
A
M
PL
IT
U
D
E
sin(x)/x ENVELOPE
x = π (
f/fC)
09
07
7
-04
0
Figure 21. DAC Output Spectrum
相關PDF資料
PDF描述
VI-21L-CU-S CONVERTER MOD DC/DC 28V 200W
VE-B1L-IX-B1 CONVERTER MOD DC/DC 28V 75W
VI-B1L-IX-B1 CONVERTER MOD DC/DC 28V 75W
AD9837ACPZ-RL7 IC WAVEFORM GEN PROG 10LFCSP
VE-21N-CU-S CONVERTER MOD DC/DC 18.5V 200W
相關代理商/技術參數
參數描述
AD9840 制造商:AD 制造商全稱:Analog Devices 功能描述:Complete 10-Bit 40 MSPS CCD Signal Processor
AD9840A 制造商:AD 制造商全稱:Analog Devices 功能描述:Complete 10-Bit 40 MSPS CCD Signal Processor
AD9840AJST 制造商:Analog Devices 功能描述:AFE Video 1ADC 10-Bit 3V 48-Pin LQFP 制造商:Analog Devices 功能描述:AFE VID 1ADC 10-BIT 3.3V 48LQFP - Bulk
AD9840AJSTRL 制造商:Analog Devices 功能描述:AFE Video 1ADC 10-Bit 3V 48-Pin LQFP T/R 制造商:Analog Devices 功能描述:AFE VID 1ADC 10-BIT 3.3V 48LQFP - Tape and Reel
AD9840AJSTZ 功能描述:IC CCD SIGNAL PROC 10BIT 48-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 傳感器和探測器接口 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:74 系列:- 類型:觸控式傳感器 輸入類型:數字 輸出類型:數字 接口:JTAG,串行 電流 - 電源:100µA 安裝類型:表面貼裝 封裝/外殼:20-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:20-TSSOP 包裝:管件