- 您現在的位置：買賣IC網 > PDF目錄5343 > AD8615AUJZ-R2 (Analog Devices Inc)IC OPAMP GP R-R CMOS LN TSOT23-5 PDF資料下載
參數資料
| 型號： | AD8615AUJZ-R2 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 6/20頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP GP R-R CMOS LN TSOT23-5 |
| 設計資源： | Compact, Low Cost, 5 V, Variable Gain, Noninverting Amplifier Using AD5270/2 and AD8615 (CN0161) Compact, Low Cost, 5 V, Variable Gain, Inverting Amplifier Using AD5270/2 and AD8615(CN0168) |
| 標準包裝： | 250 |
| 系列： | DigiTrim® |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 12 V/µs |
| 增益帶寬積： | 24MHz |
| 電流 - 輸入偏壓： | 0.2pA |
| 電壓 - 輸入偏移： | 23µV |
| 電流 - 電源： | 1.7mA |
| 電流 - 輸出 / 通道： | 150mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-5 細型，TSOT-23-5 |
| 供應商設備封裝： | TSOT-23-5 |
| 包裝： | 帶卷 (TR) |
AD8615/AD8616/AD8618
Data Sheet
The following formula can be used to calculate the internal
application:
TJ = PDISS × θJA + TA
where:
TJ = junction temperature
PDISS = power dissipation
θJA = package thermal resistance, junction-to-case
TA = ambient temperature of the circuit
AD8618, use the following:
PDISS = ILOAD × (VS – VOUT)
where:
ILOAD = output load current
VS = supply voltage
VOUT = output voltage
The quantity within the parentheses is the maximum voltage
developed across either output transistor.
POWER CALCULATIONS FOR VARYING OR
UNKNOWN LOADS
Often, calculating power dissipated by an integrated circuit to
determine if the device is being operated in a safe range is not as
simple as it may seem. In many cases, power cannot be directly
measured. This may be the result of irregular output waveforms or
varying loads. Indirect methods of measuring power are required.
There are two methods to calculate power dissipated by an
integrated circuit. The first is to measure the package temperature
and the board temperature. The second is to directly measure
the circuit’s supply current.
Calculating Power by Measuring Ambient Temperature
and Case Temperature
The two equations for calculating the junction temperature are
TJ = TA + P θJA
where:
TJ = junction temperature
TA = ambient temperature
θJA = the junction-to-ambient thermal resistance
TJ = TC + P θJC
where:
TC is case temperature.
θJA and θJC are given in the data sheet.
The two equations for calculating P (power) are
TA + P θJA = TC + P θJC
P = (TA TC)/(θJC θJA)
Once the power is determined, it is necessary to recalculate the
junction temperature to ensure that the temperature was not
exceeded.
The temperature should be measured directly on and near the
package but not touching it. Measuring the package can be
difficult. A very small bimetallic junction glued to the package
can be used, or an infrared sensing device can be used, if the
spot size is small enough.
Calculating Power by Measuring Supply Current
If the supply voltage and current are known, power can be
calculated directly. However, the supply current can have a dc
component with a pulse directed into a capacitive load, which
can make the rms current very difficult to calculate. This difficulty
can be overcome by lifting the supply pin and inserting an rms
current meter into the circuit. For this method to work, make
sure the current is delivered by the supply pin being measured.
This is usually a good method in a single-supply system; however,
if the system uses dual supplies, both supplies may need to be
monitored.
Rev. F | Page 14 of 20
相關PDF資料 |
PDF描述 |
|---|---|
| NCV33204DTBR2 | IC OPAMP QUAD R-R LV 14TSSOP |
| NPTC102KFMS-RC | CONN FEMALE 20POS DL .1" TIN SMD |
| MME25-0201R1 | CONN RACK/PANEL 20POS 5A |
| LPPB132NFSS-RC | CONN HEADER .050" 26PS DL SMD AU |
| LT1990IS8#PBF | IC AMP DIFF +/-250V MCRPWR 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8615AUJZ-R21 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision, 20 MHz, CMOS, Rail-to-Rail Input/Output Operational Amplifiers |
| AD8615AUJZ-REEL | 功能描述:IC OPAMP GP R-R CMOS LN TSOT23-5 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:DigiTrim® 標準包裝:160 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:10 V/µs 增益帶寬積:9MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:250µV 電流 - 電源:730µA 電流 - 輸出 / 通道:28mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:管件 |
| AD8615AUJZ-REEL1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision, 20 MHz, CMOS, Rail-to-Rail Input/Output Operational Amplifiers |
| AD8615AUJZ-REEL7 | 功能描述:IC OPAMP GP R-R CMOS LN TSOT23-5 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:DigiTrim® 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| AD8615AUJZ-REEL71 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision, 20 MHz, CMOS, Rail-to-Rail Input/Output Operational Amplifiers |
發布緊急采購，3分鐘左右您將得到回復。