參數資料
型號: AD8607ARZ-REEL
廠商: Analog Devices Inc
文件頁數: 4/16頁
文件大?。?/td> 0K
描述: IC OPAMP GP R-R CMOS DUAL 8SOIC
產品培訓模塊: Power Line Monitoring
標準包裝: 2,500
放大器類型: 通用
電路數: 2
輸出類型: 滿擺幅
轉換速率: 0.1 V/µs
增益帶寬積: 400kHz
電流 - 輸入偏壓: 0.2pA
電壓 - 輸入偏移: 12µV
電流 - 電源: 40µA
電流 - 輸出 / 通道: 70mA
電壓 - 電源,單路/雙路(±): 1.8 V ~ 5 V,±0.9 V ~ 2.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 8-SO
包裝: 帶卷 (TR)
AD8603/AD8607/AD8609
Rev. C | Page 12 of 16
APPLICATIONS
NO PHASE REVERSAL
The AD8603/AD8607/AD8609 do not exhibit phase inversion
even when the input voltage exceeds the maximum input
common-mode voltage. Phase reversal can cause permanent
damage to the amplifier, resulting in system lockups. The
AD8603/AD8607/AD8609 can handle voltages of up to 1 V
over the supply.
V
O
LT
A
G
E
(
1V/
D
IV)
TIME (4s/DIV)
VS = ±2.5V
VIN = 6V p-p
AV = 1
RL = 10k
VIN
VOUT
04
35
6-
0
41
Figure 41. No Phase Response
INPUT OVERVOLTAGE PROTECTION
If a voltage 1 V higher than the supplies is applied at either
input, the use of a limiting series resistor is recommended. If
both inputs are used, each one should be protected with a
series resistor.
To ensure good protection, the current should be limited to a
maximum of 5 mA. The value of the limiting resistor can be
determined from the following equation:
(VIN VS)/(RS + 200 Ω) ≤ 5 mA
DRIVING CAPACITIVE LOADS
The AD8603/AD8607/AD8609 are capable of driving large
capacitive loads without oscillating. Figure 42 shows the output
of the AD8603/AD8607/AD8609 in response to a 100 mV input
signal, with a 2 nF capacitive load.
Although it is configured in positive unity gain (the worst case),
the AD8603 shows less than 20% overshoot. Simple additional
circuitry can eliminate ringing and overshoot.
One technique is the snubber network, which consists of a
series RC and a resistive load (see Figure 43). With the snubber
in place, the AD8603/AD8607/AD8609 are capable of driving
capacitive loads of 2 nF with no ringing and less than 3%
overshoot.
The use of the snubber circuit is usually recommended for unity
gain configurations. Higher gain configurations help improve
the stability of the circuit. Figure 44 shows the same output
response with the snubber in place.
VS = ±0.9V
VIN = 100mV
CL = 2nF
RL = 10k
0
43
56
-04
2
Figure 42. Output Response to a 2 nF Capacitive Load, Without Snubber
04
35
6-
04
3
CS
47pF
VCC
VEE
RS
150
200mV
CL
V+
V–
+
Figure 43. Snubber Network
VSY = ±0.9V
VIN = 100mV
CL = 2nF
RL = 10k
RS = 150
CS = 470pF
0
435
6-
0
44
Figure 44. Output Response to a 2 nF Capacitive Load with Snubber
Optimum values for RS and CS are determined empirically;
Table 5 lists a few starting values.
Table 5. Optimum Values for the Snubber Network
CL (pF)
RS (Ω)
CS (pF)
100 to ~500
500
680
1500
100
330
1600 to ~2000
400
100
相關PDF資料
PDF描述
LT1783CS5#TRMPBF IC OPAMP R-R IN/OUT TSOT-23-5
TSW-127-08-S-D CONN HEADER 54POS .100" DL GOLD
TSW-128-08-S-D CONN HEADER 56POS .100" DL GOLD
LT1783CS5#TRPBF IC OPAMP R-R IN/OUT TSOT-23-5
1PMT12AT1 TVS ZENER 200W 12V POWERMITE
相關代理商/技術參數
參數描述
AD8607ARZ-REEL1 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision Micropower, Low Noise CMOS, Rail-to-Rail Input/Output Operational Amplifiers
AD8607ARZ-REEL7 功能描述:IC OPAMP GP R-R CMOS DUAL 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤,CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT
AD8607ARZ-REEL71 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision Micropower, Low Noise CMOS, Rail-to-Rail Input/Output Operational Amplifiers
AD8608 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision Low noise CMOS Rail-to-Rail Input/Output Operational Amplifiers
AD8608_CN 制造商:AD 制造商全稱:Analog Devices 功能描述:精密、低噪聲、CMOS軌到軌輸入/輸出運算放大器