- 您現在的位置：買賣IC網 > PDF目錄6117 > AD8603AUJZ-REEL7 (Analog Devices Inc)IC OPAMP GP R-R CMOS TSOT23-5 PDF資料下載
參數資料
| 型號： | AD8603AUJZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP R-R CMOS TSOT23-5 |
| 產品培訓模塊： | Power Line Monitoring |
| 設計資源： | Generating a Negative Precision Voltage Reference Without Precision Resistors (CN0005) High Precision, Low Cost Current Sources Using AD8276 and AD8603 (CN0099) Measuring -48 V High-Side Current Using AD629, AD8603, AD780, and AD7453 (CN0100) |
| 標準包裝： | 1 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.1 V/µs |
| 增益帶寬積： | 400kHz |
| 電流 - 輸入偏壓： | 0.2pA |
| 電壓 - 輸入偏移： | 12µV |
| 電流 - 電源： | 40µA |
| 電流 - 輸出 / 通道： | 70mA |
| 電壓 - 電源，單路/雙路(±)： | 1.8 V ~ 5 V，±0.9 V ~ 2.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-5 細型，TSOT-23-5 |
| 供應商設備封裝： | TSOT-23-5 |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 767 (CN2011-ZH PDF) |
| 其它名稱： | AD8603AUJZREEL7DKR |
AD8603/AD8607/AD8609
Rev. C | Page 12 of 16
APPLICATIONS
NO PHASE REVERSAL
The AD8603/AD8607/AD8609 do not exhibit phase inversion
even when the input voltage exceeds the maximum input
common-mode voltage. Phase reversal can cause permanent
damage to the amplifier, resulting in system lockups. The
AD8603/AD8607/AD8609 can handle voltages of up to 1 V
over the supply.
V
O
LT
A
G
E
(
1V/
D
IV)
TIME (4s/DIV)
VS = ±2.5V
VIN = 6V p-p
AV = 1
RL = 10k
VIN
VOUT
04
35
6-
0
41
Figure 41. No Phase Response
INPUT OVERVOLTAGE PROTECTION
If a voltage 1 V higher than the supplies is applied at either
input, the use of a limiting series resistor is recommended. If
both inputs are used, each one should be protected with a
series resistor.
To ensure good protection, the current should be limited to a
maximum of 5 mA. The value of the limiting resistor can be
determined from the following equation:
(VIN VS)/(RS + 200 Ω) ≤ 5 mA
DRIVING CAPACITIVE LOADS
The AD8603/AD8607/AD8609 are capable of driving large
capacitive loads without oscillating. Figure 42 shows the output
of the AD8603/AD8607/AD8609 in response to a 100 mV input
signal, with a 2 nF capacitive load.
Although it is configured in positive unity gain (the worst case),
the AD8603 shows less than 20% overshoot. Simple additional
circuitry can eliminate ringing and overshoot.
One technique is the snubber network, which consists of a
series RC and a resistive load (see Figure 43). With the snubber
in place, the AD8603/AD8607/AD8609 are capable of driving
capacitive loads of 2 nF with no ringing and less than 3%
overshoot.
The use of the snubber circuit is usually recommended for unity
gain configurations. Higher gain configurations help improve
the stability of the circuit. Figure 44 shows the same output
response with the snubber in place.
VS = ±0.9V
VIN = 100mV
CL = 2nF
RL = 10k
0
43
56
-04
2
Figure 42. Output Response to a 2 nF Capacitive Load, Without Snubber
04
35
6-
04
3
CS
47pF
VCC
VEE
RS
150
200mV
CL
V+
V–
–
+
Figure 43. Snubber Network
VSY = ±0.9V
VIN = 100mV
CL = 2nF
RL = 10k
RS = 150
CS = 470pF
0
435
6-
0
44
Figure 44. Output Response to a 2 nF Capacitive Load with Snubber
Optimum values for RS and CS are determined empirically;
Table 5 lists a few starting values.
Table 5. Optimum Values for the Snubber Network
CL (pF)
RS (Ω)
CS (pF)
100 to ~500
500
680
1500
100
330
1600 to ~2000
400
100
相關PDF資料 |
PDF描述 |
|---|---|
| TSW-105-23-T-D | CONN HEADER 10POS .100" DUAL TIN |
| TSW-115-08-T-S-RA | CONN HEADER 15POS .100" SNGL R/A |
| TSW-101-08-T-D-RA | CONN HEADER 2POS .100 DL R/A TIN |
| TSW-105-08-L-S-RA | CONN HEADER 5POS .100 SGL R/A AU |
| ADA4691-2ACBZ-R7 | IC OPAMP GP R-R 3.6MHZ 9WLCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8603AUJZ-REEL71 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision Micropower, Low Noise CMOS, Rail-to-Rail Input/Output Operational Amplifiers |
| AD8604 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision CMOS Single Supply Rail-to-Rail Input/Output Wideband Operational Amplifiers |
| AD8604AR | 制造商:Analog Devices 功能描述:OP Amp Quad GP R-R I/O 5.5V 14-Pin SOIC N 制造商:Rochester Electronics LLC 功能描述:QUAD, PRECISION CMOS RAIL-RAIL OP AMP - Bulk 制造商:Analog Devices 功能描述:IC OP AMP QUAD CMOS 8604 SOIC14 |
| AD8604ARQZ | 功能描述:IC OPAMP GP R-R 8MHZ QUAD 16QSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:DigiTrim® 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| AD8604ARQZ-R7 | 功能描述:IC OPAMP GP R-R 8MHZ QUAD 16QSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:DigiTrim® 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。