- 您現在的位置：買賣IC網 > PDF目錄5467 > AD8531ARTZ-REEL (Analog Devices Inc)IC OPAMP GP R-R CMOS SOT23-5 PDF資料下載
參數資料
| 型號： | AD8531ARTZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 5/20頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP GP R-R CMOS SOT23-5 |
| 標準包裝： | 10,000 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 5 V/µs |
| 增益帶寬積： | 3MHz |
| 電流 - 輸入偏壓： | 5pA |
| 電壓 - 輸入偏移： | 25000µV |
| 電流 - 電源： | 750µA |
| 電流 - 輸出 / 通道： | 250mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 6 V，±1.35 V ~ 3 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SC-74A，SOT-753 |
| 供應商設備封裝： | SOT-23-5 |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
AD8531/AD8532/AD8534
Rev. F | Page 13 of 20
5V
RS
5
CS
1F
VOUT
VIN
100mV p-p
AD8532
01
09
9-
0
40
CL
47nF
OUTPUT PHASE REVERSAL
Some operational amplifiers designed for single-supply operation
exhibit an output voltage phase reversal when their inputs are
driven beyond their useful common-mode range. The AD8531/
AD8532/AD8534 are free from reasonable input voltage range
restrictions, provided that input voltages no greater than the
supply voltage rails are applied. Although the output of the
device does not change phase, large currents can flow through
internal junctions to the supply rails, which was described in the
Input Overvoltage Protection section. Without limit, these fault
currents can easily destroy the amplifier. The technique
recommended in the Input Overvoltage Protection section
should therefore be applied in those applications where the
possibility of input voltages exceeding the supply voltages exists.
Figure 40. Snubber Network Compensates for Capacitive Loads
The first step is to determine the value of the resistor, RS. A good
starting value is 100 Ω. This value is reduced until the small signal
transient response is optimized. Next, CS is determined; 10 μF is a
good starting point. This value is reduced to the smallest value
for acceptable performance (typically, 1 μF). For the case of a
47 nF load capacitor on the AD8531/AD8532/AD8534, the
optimal snubber network is 5 Ω in series with 1 μF. The benefit
is immediately apparent, as seen in Figure 41. The top trace was
taken with a 47 nF load, and the bottom trace was taken with
the 5 Ω in series with a 1 μF snubber network in place. The
amount of overshoot and ringing is dramatically reduced. Table 5
illustrates a few sample snubber networks for large load
capacitors.
CAPACITIVE LOAD DRIVE
The AD8531/AD8532/AD8534 exhibit excellent capacitive load
driving capabilities. They can drive up to 10 nF directly, as
shown in Figure 25 through Figure 28. However, even though
the device is stable, a capacitive load does not come without a
penalty in bandwidth. As shown in Figure 39, the bandwidth is
reduced to less than 1 MHz for loads greater than 10 nF. A snubber
network on the output does not increase the bandwidth, but it
does significantly reduce the amount of overshoot for a given
capacitive load. A snubber consists of a series RC network (RS,
device to ground. This network operates in parallel with the
load capacitor, CL, to provide phase lag compensation. The
actual value of the resistor and capacitor is best determined
empirically.
Table 5. Snubber Networks for Large Capacitive Loads
Load Capacitance (CL)
Snubber Network (RS, CS)
0.47 nF
300 Ω, 0.1 μF
4.7 nF
30 Ω, 1 μF
47 nF
5 Ω, 1 μF
0
10
99-
041
10
0%
100
47nF LOAD
ONLY
SNUBBER
IN CIRCUIT
90
10s
50mV
CAPACITIVE LOAD (nF)
BANDW
IDI
T
H
(
M
Hz
)
3.5
4.0
3.0
2.5
2.0
1.5
1.0
0.5
0
0.01
0.1
1
10
100
01
099
-03
9
VS = ±2.5V
RL = 1k
TA = 25°C
Figure 41. Overshoot and Ringing Are Reduced by Adding a Snubber
Network in Parallel with the 47 nF Load
Figure 39. Unity-Gain Bandwidth vs. Capacitive Load
相關PDF資料 |
PDF描述 |
|---|---|
| 51760-10402002AA | R/A SOLDER REC.PWRBLADE |
| GTC35SGSN-M89 | CONN HEADER 35POS .100 R/A SMD |
| GTC34SGSN-M89 | CONN HEADER 34POS .100 R/A SMD |
| AD8541ARTZ-REEL | IC OPAMP GP R-R CMOS SOT23-5 |
| SMAJ110A-13 | TVS UNI-DIR 110V 400W SMA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8531ARTZ-REEL7 | 功能描述:IC OPAMP GP R-R CMOS SOT23-5 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 特色產品:CMOS Operational Amplifier 標準包裝:2,500 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:1000µV 電流 - 電源:900µA 電流 - 輸出 / 通道:1mA 電壓 - 電源，單路/雙路(±):5 V ~ 14.5 V，±2.5 V ~ 7.25 V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.173"，4.40mm 寬） 供應商設備封裝:8-SOP 包裝:帶卷 (TR) 產品目錄頁面:1372 (CN2011-ZH PDF) 其它名稱:BD7562SF-E2TR |
| AD8531ARTZ-REEL7 | 制造商:Analog Devices 功能描述:IC OP-AMP 3MHZ 5V/S SOT-23-5 |
| AD8531ARZ | 功能描述:IC OPAMP GP R-R CMOS 3MHZ 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| AD8531ARZ-REEL | 功能描述:IC OPAMP GP R-R CMOS 3MHZ 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 特色產品:CMOS Operational Amplifier 標準包裝:2,500 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:1000µV 電流 - 電源:900µA 電流 - 輸出 / 通道:1mA 電壓 - 電源，單路/雙路(±):5 V ~ 14.5 V，±2.5 V ~ 7.25 V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.173"，4.40mm 寬） 供應商設備封裝:8-SOP 包裝:帶卷 (TR) 產品目錄頁面:1372 (CN2011-ZH PDF) 其它名稱:BD7562SF-E2TR |
| AD8532 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Cost, 250 mA Output Single-Supply Amplifiers |
發布緊急采購，3分鐘左右您將得到回復。