參數資料
型號: AD848JRZ
廠商: Analog Devices Inc
文件頁數: 8/8頁
文件大?。?/td> 0K
描述: IC OPAMP GP 175MHZ LP 32MA 8SOIC
標準包裝: 98
放大器類型: 通用
電路數: 1
轉換速率: 300 V/µs
增益帶寬積: 175MHz
電流 - 輸入偏壓: 3.3µA
電壓 - 輸入偏移: 200µV
電流 - 電源: 5.1mA
電流 - 輸出 / 通道: 32mA
電壓 - 電源,單路/雙路(±): ±4.5 V ~ 18 V
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 8-SO
包裝: 管件
產品目錄頁面: 769 (CN2011-ZH PDF)
AD848/AD849
REV. B
–8–
C1261b–5–9/90
PRINTED
IN
U.S.A.
GROUNDING AND BYPASSING
In designing practical circuits with the AD848 or AD849, the
user must remember that whenever high frequencies are
involved, some special precautions are in order. Circuits must
be built with short interconnect leads. A large ground plane
should be used whenever possible to provide a low resistance,
low inductance circuit path, as well as minimizing the effects of
high frequency coupling. Sockets should be avoided because the
increased interlead capacitance can degrade bandwidth.
Feedback resistors should be of low enough value to assure that
the time constant formed with the capacitances at the amplifier
summing junction will not limit the amplifier performance.
Resistor values of less than 5 k
are recommended. If a larger
resistor must be used, a small (< 10 pF) feedback capacitor in
parallel with the feedback resistor, RF, may be used to compen-
sate for the input capacitances and optimize the dynamic per-
formance of the amplifier.
Power supply leads should be bypassed to ground as close as
possible to the amplifier pins. 0.1
F ceramic disc capacitors are
recommended.
VIDEO LINE DRIVER
The AD848 functions very well as a low cost, high speed line
driver of either terminated or unterminated cables. Figure 22
shows the AD848 driving a doubly terminated cable.
The termination resistor, RT, (when equal to the characteristic
impedance of the cable) minimizes reflections from the far end
of the cable. While operating off
±5 V supplies, the AD848
maintains a typical slew rate of 200 V/
s, which means it can
drive a
±1 V, 24 MHz signal on the terminated cable.
A back-termination resistor (RBT, also equal to the characteristic
impedance of the cable) may be placed between the AD848
output and the cable in order to damp any reflected signals
caused by a mismatch between RT and the cable’s characteristic
impedance. This will result in a “cleaner” signal, although it
requires that the op amp supply
±2 V to the output in order to
achieve a
±1 V swing at the line.
Figure 22. Video Line Driver
100pF
LOAD
1000pF
LOAD
Figure 23. AD848 Driving a Capacitive Load
AD848/AD849–Applications
Often termination is not used, either because signal integrity
requirements are low or because too many high frequency
signals returned to ground contaminate the ground plane.
Unterminated cables appear as capacitive loads. Since the
AD848 and AD849 are stable into any capacitive load, the op
amp will not oscillate if the cable is not terminated; however
pulse integrity will be degraded. Figure 23 shows the AD848
driving both 100 pF and 1000 pF loads.
LOW NOISE PRE-AMP
The input voltage noise spectral densities of the AD848 and the
AD849 are shown in Figure 24. The low wideband noise and
high gain bandwidths of these devices makes them well suited as
pre-amps for high frequency systems.
Figure 24. Input Voltage Noise Spectral Density
Input voltage noise will be the dominant source of noise at the
output in most applications. Other noise sources can be
minimized by keeping resistor values as small as possible.
OUTLINE DIMENSIONS
Dimensions shown in inches and (mm).
Cerdip (Q) Package
Mini-DIP (N) Package
Small Outline (R) Package
相關PDF資料
PDF描述
M80-5S21405MQ CONN HDR 2MM R/A W/SCREW 14POS
AMP03GSZ IC AMP DIFF PREC LDIST 8SOIC
M80-5S20805MQ CONN HDR 2MM R/A W/SCREW 8POS
AD847JNZ IC OPAMP GP 50MHZ LP 32MA 8DIP
M80-5405042 CONN HDR 2MM R/A W/SCREW 50POS
相關代理商/技術參數
參數描述
AD848JRZ-REEL 功能描述:IC OPAMP GP 175MHZ LP 32MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源,單路/雙路(±):2.7 V ~ 12 V,±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT
AD848JRZ-REEL7 功能描述:IC OPAMP GP 175MHZ LP 32MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源,單路/雙路(±):2.7 V ~ 12 V,±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT
AD848SCHIPS 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage-Feedback Operational Amplifier
AD848SE/883B 制造商:AD 制造商全稱:Analog Devices 功能描述:High Speed, Low Power Monolithic Op Amp
AD848SE/883D 制造商:Analog Devices 功能描述: