- 您現在的位置：買賣IC網 > PDF目錄6030 > AD8370AREZ (Analog Devices Inc)IC AMP VGA DIFF LN 16TSSOP PDF資料下載
參數資料
| 型號： | AD8370AREZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 16/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP VGA DIFF LN 16TSSOP |
| 產品培訓模塊： | Differential Circuit Design Techniques for Communication Applications |
| 標準包裝： | 96 |
| 放大器類型： | 可變?cè)鲆?br> |
| 電路數： | 1 |
| 輸出類型： | 差分 |
| 轉換速率： | 5750 V/ns |
| -3db帶寬： | 750MHz |
| 電流 - 輸入偏壓： | 400pA |
| 電流 - 電源： | 79mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm）裸露焊盤 |
| 供應商設備封裝： | 16-TSSOP-EP |
| 包裝： | 管件 |
| 產品目錄頁面： | 775 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Data Sheet
AD8370
Rev. B | Page 23 of 28
03692-058
Figure 60. Evaluation Software
Table 7. AD8370 Evaluation Board Configuration Options
Component
Function
Default Condition
VS, GND, VOCM
Power Interface Vector Pins. Apply supply voltage between VS and GND. The VOCM
pin allows external monitoring of the common-mode input and output bias levels.
Not applicable
SW1, R8,
C10, PWUP
Device Enable. Set to Position B to power up the device. When in Position A, the PWUP
pin is connected to the PWUP vector pin. The PWUP pin allows external power cycling
of the device. R8 and C10 are provided to allow for proper cable termination.
SW1 = installed
R8 = 49.9 (Size 0805)
C10 = open (Size 0805)
P1, R5, R6,
R7, C9
Serial Control Interfaces. The evaluation board can be controlled using most PCs.
Windows-based control software is shipped with the evaluation kit. A 25-pin, D-sub
connector cable is required to connect the PC to the evaluation board. It may be
necessary to use a capacitor on the clock line, depending on the quality of the PC port
signals. A 1 nF capacitor for C9 is usually sufficient for reducing clock overshoot.
P1 = installed
R5, R6, R7 = 1 k (Size 0603)
C9 = open (Size 0603)
J1, J2, J6, J7
Input and Output Signal Connectors. These SMA connectors provide a convenient way
to interface the evaluation board with 50 test equipment. Typically, the device is
evaluated using a single-ended source and load. The source should connect to
J1 (IN+), and the load should connect to J6 (OUT+).
Not applicable
C1, C2, C3, C4
AC Coupling Capacitors. Provide ac coupling of the input and output signals.
C1, C2, C3, C4 = 1 nF (Size 0603)
T1, T2
Impedance Transformers. T1 provides a 50 to 200 impedance transformation.
T2 provides a 100 to 50 impedance transformation.
T1 = TC4 1W (Mini-Circuits)
T2 = JTX210T (Mini-Circuits)
R1, R2, R3, R4
Single-Ended or Differential. R2 and R4 are used to ground the center tap of the
secondary windings on transformers T1 and T2. R1 and R3 should be used to ground
J2 and J7 when used in single-ended applications.
R1, R2, R3, R4 = 0 (Size 0603)
C5, C6, C7,
C8 L1, L2
Power Supply Decoupling. Nominal supply decoupling consists of a ferrite bead
series inductor followed by a 1 F capacitor to ground followed by a 0.1 F capacitor
to ground positioned as close to the device as possible. C7 provides additional
decoupling of the input common-mode voltage. L1 provides high frequency
isolation between the input and output power supply. L2 provides high
frequency isolation between the analog and digital ground.
C6 = 1 F (Size 0805)
C5, C7, C8 = 0.1 F (Size 0603)
L1, L2 = HZ1206E601R-00
(Steward, Size 1206)
相關PDF資料 |
PDF描述 |
|---|---|
| LT1352IS8#PBF | IC OP AMP DUAL HI SPD 3MHZ 8SOIC |
| AD8625ARUZ | IC OPAMP JFET 5MHZ QUAD 14TSSOP |
| 4-103327-0-26 | CONN HEADR BRKWAY .100 26POS STR |
| AD8625ARZ | IC OPAMP JFET 5MHZ QUAD 14SOIC |
| AD8024ARZ | IC OPAMP CF QUAD LP 50MA 16SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8370AREZ | 制造商:Analog Devices 功能描述:IC VARIABLE GAIN AMP 750MHZ TSSOP-16 制造商:Analog Devices 功能描述:IC, VARIABLE GAIN AMP, 750MHZ, TSSOP-16 |
| AD8370AREZ1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:LF to 750 MHz, Digitally Controlled VGA |
| AD8370AREZ-RL7 | 功能描述:IC AMP VGA DIFF LN 16TSSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:150 系列:- 放大器類型:音頻 電路數:2 輸出類型:- 轉換速率:5 V/µs 增益帶寬積:12MHz -3db帶寬:- 電流 - 輸入偏壓:100nA 電壓 - 輸入偏移:500µV 電流 - 電源:6mA 電流 - 輸出 / 通道:50mA 電壓 - 電源，單路/雙路(±):4 V ~ 32 V，±2 V ~ 16 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| AD8370-EVAL | 制造商:Analog Devices 功能描述:AD8370 EVAL BOARD - Bulk |
| AD8370-EVALZ | 制造商:Analog Devices 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。