參數資料
型號: AD8367ARU-REEL7
廠商: Analog Devices Inc
文件頁數: 13/24頁
文件大?。?/td> 0K
描述: IC AMP VGA 14TSSOP
標準包裝: 1,000
系列: X-AMP®
放大器類型: 可變?cè)鲆?br>
電路數: 1
-3db帶寬: 500MHz
電流 - 輸入偏壓: 27µA
電流 - 電源: 26mA
電壓 - 電源,單路/雙路(±): 2.7 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 14-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 14-TSSOP
包裝: 帶卷 (TR)
AD8367
Rev. A | Page 20 of 24
Table 7 details the various configuration options of the evaluation board.
Table 7. Evaluation Board Configuration Options
Component
Function
Default Condition
TP1, TP2
Supply and Ground Vector Pins.
Not Applicable
TP3, TP4
Mode and Gain Vector Pins.
Not Applicable
SW1
VGA/AGC Select: Used to select VGA (Position A) or AGC (Position B) mode of
operation. SW2 must be set for Position A for AGC mode of operation.
SW1 = A
SW2
MODE Select. Used to select positive or negative VGA slope. Set to Position B for an
increasing gain with VGAIN, Position A for decreasing gain law.
SW2 = B
LK1
Device Enable. When LK1 is installed, the ENBL pin is connected to the positive supply
and the AD8367 is in operating mode.
LK1 = Installed
R1, R2
Input Interface. R1 and R2 are used to provide an L-pad impedance-transforming
network. The broadband matching network transforms a 50 Ω source to match a
200 Ω load with 11.5 dB of insertion loss.
R1 = 57.6 Ω (Size 0603)
R2 = 174 Ω (Size 0603)
R3, R4, C4
Output Interface. R3 and R4 are used to transform a 50 Ω load termination to look like
a 200 Ω load with 11.5 dB of insertion loss. The ac coupling capacitor, C4, can be
increased to obtain a lower high-pass corner frequency.
R3 = 57.6 Ω (Size 0603)
R4 = 174 Ω (Size 0603)
C4 = 0.1 μF (Size 0603)
C1, C2, C3, R5, R6
Power Supply Decoupling. The nominal supply decoupling consists of a 1 μF capacitor
to ground, a 4.7 Ω series resistor, and a 0.1 μF capacitor to ground. The same
decoupling network should be used on both the VPSI and VPSO supply lines.
C1 = 1 μF (Size 0603)
R5 = R6 = 4.7 Ω (Size 0805)
C2 = C3 = 0.1 μF (Size 0603)
C5
Internal Supply Decoupling. Capacitor C5 provides midsupply decoupling.
C5 = 10 nF (Size 0603)
CHP
Filter Capacitor. HPFL capacitor, sets the high-pass corner frequency.
CHP = 0.01 μF (Size 0805)
RHP = 0 Ω (Size 0603)
CAGC
AGC Filter Capacitor. Capacitor, CAGC, sets closed-loop AGC response time.
CAGC = 0.1 μF (Size 0805)
R7
Mode Pull-Up Resistor.
R7 = 10 kΩ (Size 0805)
RHP
High-Pass Filter Resistor.
RHP = 100 Ω (Size)
CHARACTERIZATION SETUP AND METHODS
Minimum-loss, L-pad matching networks were used to
interface standard 50 Ω. A test equipment to the 200 Ω input
impedance during the characterization process. Using a 57.6 Ω
shunt resistor followed by a 174 Ω series resistor provides a
broadband match between the 50 Ω test equipment and the
200 Ω device impedance, as illustrated in Figure 45. The
insertion loss of this network is 11.5 dB.
02710-
045
57.6
Ω
174
Ω
57.6
Ω
174
Ω
AD8367
Figure 45. Characterization Test Setup
相關PDF資料
PDF描述
69155-316LF QKE HEADER
AD843JRZ-16-REEL IC OPAMP GP 34MHZ 50MA 16SOIC
1-87224-7 17 MODII HDR SRST UNSHRD .100
N3793-2302RB CONN HEADER 10POS STR LONG LATCH
XG8W-3031 PLUG 30POS DOUBLE ROW STRAIGHT
相關代理商/技術參數
參數描述
AD8367ARU-REEL-7 制造商:AD 制造商全稱:Analog Devices 功能描述:500 MHz, Linear-in-dB VGA with AGC Detector
AD8367ARUZ 功能描述:IC AMP VGA 14TSSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:X-AMP® 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源,單路/雙路(±):3 V ~ 32 V,±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR
AD8367ARUZ 制造商:Analog Devices 功能描述:PROGRAMMABLE GAIN AMPLIFIER IC ((NW))
AD8367ARUZ 制造商:Analog Devices 功能描述:IC DETECTOR
AD8367ARUZ1 制造商:AD 制造商全稱:Analog Devices 功能描述:500 MHz, Linear-in-dB VGA with AGC Detector