參數資料
型號： AD8366ACPZ-R7
廠商： Analog Devices Inc
文件頁數： 14/28頁
文件大?。?/td> 0K
描述： IC DUAL AMP VGA 32LFCSP
標準包裝： 1
放大器類型： 可變?cè)鲆?br>
電路數： 2
輸出類型： 差分
轉換速率： 1100 V/µs
-3db帶寬： 600MHz
電流 - 電源： 180mA
電壓 - 電源，單路/雙路(±)： 4.75 V ~ 5.25 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 32-VFQFN 裸露焊盤，CSP
供應商設備封裝： 32-LFCSP-VQ
包裝： 標準包裝
其它名稱： AD8366ACPZ-R7DKR
AD8366
Rev. A | Page 21 of 28
BASEBAND INTERFACE
In most direct-conversion receiver designs, it is desirable to select a
wanted carrier within a specified band. The desired channel can be
demodulated by tuning the LO to the appropriate carrier frequency.
If the desired RF band contains multiple carriers of interest, the
adjacent carriers would also be down converted to a lower IF
frequency. These adjacent carriers can be a problem if they are
large relative to the desired carrier because they can overdrive
the baseband signal detection circuitry. As a result, it is often
necessary to insert a filter to provide sufficient rejection of the
adjacent carriers.
It is necessary to consider the overall source and load impedance
presented by the AD8366 and the ADC input to design the
filter network. The differential baseband output impedance of
the AD8366 is 25 Ω and is designed to drive a high impedance
ADC input. It may be desirable to terminate the ADC input down
to the lower impedance by using a terminating resistor, such as
500 Ω. The terminating resistor helps to better define the input
impedance at the ADC input at the cost of a slightly reduced gain.
The order and type of filter network depends on the desired high
frequency rejection required, pass-band ripple, and group delay.
Figure 57 shows the schematic for a typical fourth-order, Chebyshev,
low-pass filter. Table 4 shows the typical values of the filter
components for a fourth-order, Chebyshev, low-pass filter with
a differential source impedance of 25 Ω and a differential load
impedance of 200 Ω.
L1
L2
C1
L3
L4
C2
ZLOAD
ZSOURCE
0
758
4-
0
51
Figure 57. Schematic of a Fourth-Order, Chebyshev, Low-Pass Filter
Table 4. Typical Values for Fourth-Order, Chebyshev, Low-Pass Filter
3 dB Corner (MHz)
ZSOURCE (Ω)
ZLOAD (Ω)
L1 (μH)
L2 (μH)
L3 (μH)
L4 (μH)
C1 (pF)
C2 (pF)
5
25
200
6.6
6.0
220
180
10
25
200
3.3
3
110
90
28
25
200
1.2
1
39
33
相關PDF資料
PDF描述
AD8367ARU IC AMP VGA 14TSSOP
AD8368ACPZ-WP IC AMP VGA 24LFCSP
AD8369ARUZ-REEL7 IC AMP VGA 16TSSOP
AD8370ARE-REEL7 IC AMP VGA DIFF LN 16TSSOP
AD8372ACPZ-R7 IC AMP VGA DIFF DUAL LN 32LFCSP
相關代理商/技術參數
參數描述
AD8366-EVALZ 制造商:AD 制造商全稱:Analog Devices 功能描述:DC to 500 MHz, Dual Digital Gain Trim Amplifier
AD8367 制造商:AD 制造商全稱:Analog Devices 功能描述:500 MHz, Linear-in-dB VGA with AGC Detector
AD8367_05 制造商:AD 制造商全稱:Analog Devices 功能描述:500 MHz, Linear-in-dB VGA with AGC Detector
AD8367ARU 功能描述:IC AMP VGA 14TSSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:X-AMP® 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR)
AD8367ARU-REEL 制造商:Analog Devices 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*