- 您現在的位置：買賣IC網 > PDF目錄373933 > AD8056ANZ (ANALOG DEVICES INC) Low Cost, 300 MHz Voltage Feedback Amplifiers PDF資料下載
參數資料
| 型號： | AD8056ANZ |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | Low Cost, 300 MHz Voltage Feedback Amplifiers |
| 中文描述： | 1 CHANNEL, VIDEO AMPLIFIER, PDIP8 |
| 封裝： | LEAD FREE, PLASTIC, MS-001BA, DIP-8 |
| 文件頁數： | 12/16頁 |
| 文件大?。?/td> | 255K |
| 代理商： | AD8056ANZ |
AD8055/AD8056
APPLICATIONS
FOUR-LINE VIDEO DRIVER
The AD8055 is a useful low cost circuit for driving up to four
video lines. For such an application, the amplifier is configured
for a noninverting gain of 2, as shown in Figure 36. The input
video source is terminated in 75 Ω and is applied to the high
impedance noninverting input.
Rev. J | Page 12 of 16
Between these points, a feedback resistor can be used to close
the loop. As in the case of a conventional op amp inverting gain
stage, an input resistor is added to vary the gain.
/R
The gain of this circuit from the input to AMP1 output is R
F
while the gain to the output of AMP2 is R /R
therefore creates a balanced differential output signal from a
single-ended input. The advantage of this circuit is that the gain
can be changed by changing a single resistor, while still
maintaining the balanced differential outputs.
I
,
F
I
. The circuit
Each output cable is connected to the op amp output via a 75 Ω
series back termination resistor for proper cable termination.
The terminating resistors at the other ends of the lines divide
the output signal by 2, which is compensated for by the gain of 2
of the op amp stage.
75
+5V
–5V
AD8056
402
402
402
402
49.9
49.9
1
2
3
8
AMP1
5
6
7
4
AMP2
0.1μF
R
F
402
R
I
402
10μF
0.1μF
10μF
V
IN
+V
OUT
–V
OUT
0
For a single load, the differential gain error of this circuit was
measured as 0.01%, with a differential phase error of 0.02°. The
two load measurements were 0.02% and 0.03°, respectively. For
four loads, the differential gain error is 0.02%, while the
differential phase increases to 0.1°.
V
OUT3
AD8055
+5V
–5V
6
7
2
3
4
75
75
75
75
75
75
75
75
V
OUT1
V
OUT2
V
OUT4
0.1μF
0.1μF
10μF
10μF
75
402
402
V
IN
0
Figure 37. Single-Ended-to-Differential Line Driver
Figure 36. Four-Line Video Driver
LOW NOISE, LOW POWER PREAMP
The AD8055 makes a good, low cost, low noise, low power
preamp. A gain-of-10 preamp can be made with a feedback
resistor of 909 Ω and a gain resistor of 100 Ω, as shown in
Figure 38. The circuit has a 3 dB bandwidth of 20 MHz.
SINGLE-ENDED-TO-DIFFERENTIAL LINE DRIVER
Creating differential signals from single-ended signals is
required for driving balanced, twisted pair cables, differential
input ADCs, and other applications that require differential
signals. This can be accomplished by using an inverting and a
noninverting amplifier stage to create the complementary
signals.
0.1μF
10μF
0.1μF
10μF
+5V
–5V
+
AD8055
6
7
2
3
4
V
OUT
R
S
909
100
0
The circuit shown in Figure 37 shows how an AD8056 can be
used to make a single-ended-to-differential converter that offers
some advantages over the architecture previously mentioned.
Each op amp is configured for unity gain by the feedback
resistors from the outputs to the inverting inputs. In addition,
each output drives the opposite op amp with a gain of 1 by
means of the crossed resistors. The result of this is that the
outputs are complementary and there is high gain in the overall
configuration.
Figure 38. Low Noise, Low Power Preamp with G = +10 and BW = 20 MHz
With a low source resistance (< approximately 100 Ω), the
major contributors to the input-referred noise of this circuit are
the input voltage noise of the amplifier and the noise of the
100 Ω resistor. These are 6 nV/√Hz and 1.2 nV/√Hz, respectively.
These values yield a total input referred noise of 6.1 nV/√Hz.
Feedback techniques similar to a conventional op amp are used
to control the gain of the circuit. From the noninverting input
of AMP1 to the output of AMP2 is an inverting gain.
相關PDF資料 |
PDF描述 |
|---|---|
| AD8056ARMZ | Low Cost, 300 MHz Voltage Feedback Amplifiers |
| AD8056ARMZ-REEL | Low Cost, 300 MHz Voltage Feedback Amplifiers |
| AD8056ARZ | Low Cost, 300 MHz Voltage Feedback Amplifiers |
| AD8056ARZ-REEL | Low Cost, 300 MHz Voltage Feedback Amplifiers |
| AD8056ARZ-REEL7 | Low Cost, 300 MHz Voltage Feedback Amplifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8056AR | 功能描述:IC OPAMP VF DUAL LDIST LN 8SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| AD8056AR | 制造商:Analog Devices 功能描述:SEMICONDUCTOR |
| AD8056AR-EBZ | 功能描述:BOARD EVAL FOR AD8056AR RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8056ARM | 功能描述:IC OPAMP VF DUAL LDIST LN 8MSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| AD8056ARM-EBZ | 功能描述:BOARD EVAL FOR AD8056ARM RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
發布緊急采購，3分鐘左右您將得到回復。