參數資料
型號: AD8052ARM-REEL7
廠商: Analog Devices Inc
文件頁數: 11/25頁
文件大?。?/td> 0K
描述: IC OPAMP VF R-R DUAL LDIST 8MSOP
標準包裝: 1,000
放大器類型: 電壓反饋
電路數: 2
輸出類型: 滿擺幅
轉換速率: 170 V/µs
-3db帶寬: 110MHz
電流 - 輸入偏壓: 1.4µA
電壓 - 輸入偏移: 1800µV
電流 - 電源: 4.8mA
電流 - 輸出 / 通道: 45mA
電壓 - 電源,單路/雙路(±): 3 V ~ 12 V,±1.5 V ~ 6 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 8-TSSOP,8-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 8-MSOP
包裝: 帶卷 (TR)
AD8051/AD8052/AD8054
Rev. J | Page 18 of 24
LAYOUT CONSIDERATIONS
The specified high speed performance of the AD8051/AD8052/
AD8054 requires careful attention to board layout and component
selection. Proper RF design techniques and low parasitic
component selection are necessary.
The PCB should have a ground plane covering all unused
portions of the component side of the board to provide a low
impedance path. The ground plane should be removed from the
area near the input pins to reduce parasitic capacitance.
Chip capacitors should be used for supply bypassing. One end
should be connected to the ground plane and the other within
3 mm of each power pin. An additional large (4.7 μF to 10 μF)
tantalum electrolytic capacitor should be connected in parallel,
but not necessarily so close, to supply current for fast, large
signal changes at the output.
The feedback resistor should be located close to the inverting
input pin to keep the parasitic capacitance at this node to a
minimum. Parasitic capacitance of less than 1 pF at the inverting
input can significantly affect high speed performance.
Stripline design techniques should be used for long signal traces
(greater than about 25 mm). These should be designed with a
characteristic impedance of 50 Ω or 75 Ω and be properly
terminated at each end.
ACTIVE FILTERS
Active filters at higher frequencies require wider bandwidth op
amps to work effectively. Excessive phase shift produced by
lower frequency op amps can significantly affect active filter
performance.
Figure 46 shows an example of a 2 MHz biquad bandwidth filter
that uses three op amps of an AD8054. Such circuits are
sometimes used in medical ultrasound systems to lower the
noise bandwidth of the analog signal before analog-to-digital
conversion.
Note that the unused amplifier’s inputs should be tied to ground.
12
13
14
2
1
6
5
7
9
10
8
AD8054
3
AD8054
R6
1k
R4
2k
R3
2k
R5
2k
R2
2k
R1
3k
C1
50pF
C2
50pF
VIN
BAND-PASS
FILTER OUTPUT
01062-
046
Figure 46. 2 MHz Biquad Band-Pass Filter Using AD8054
The frequency response of the circuit is shown in Figure 47.
FREQUENCY (Hz)
0
–10
–20
–30
–40
GA
IN
(
d
B
)
10k
100k
1M
10M
100M
01
06
2-
04
7
Figure 47. Frequency Response of 2 MHz Band-Pass Biquad Filter
相關PDF資料
PDF描述
EL5455ISZ-T13 IC AMP VFA QUAD 270MHZ 14-SOIC
19221-0240 CONN RING TONG TERM #5/16 1/0AWG
S10K175E2K1 VARISTOR 175V RMS 10MM RADIAL
EL5455ISZ IC AMP VFA QUAD 270MHZ 14-SOIC
0034.4240 FUSE 125MA 125V FAST 18.8MM PCB
相關代理商/技術參數
參數描述
AD8052ARMZ 功能描述:IC OPAMP VF R-R DUAL LDIST 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤,CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT
AD8052ARMZ 制造商:Analog Devices 功能描述:Operational Amplifier (Op-Amp) IC
AD8052ARMZ-REEL 功能描述:Voltage Feedback Amplifier 2 Circuit Rail-to-Rail 8-MSOP 制造商:analog devices inc. 系列:- 包裝:帶卷(TR) 零件狀態:在售 放大器類型:電壓反饋 電路數:2 輸出類型:滿擺幅 壓擺率:170 V/μs 增益帶寬積:- -3db 帶寬:110MHz 電流 - 輸入偏置:1.4μA 電壓 - 輸入失調:1.8mV 電流 - 電源:4.8mA 電流 - 輸出/通道:45mA 電壓 - 電源,單/雙(±):3 V ~ 12 V,±1.5 V ~ 6 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬) 供應商器件封裝:8-MSOP 標準包裝:3,000
AD8052ARMZ-REEL7 功能描述:IC OPAMP VF R-R DUAL LDIST 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源,單路/雙路(±):1.8 V ~ 5.25 V,±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件
AD8052ARREEL 制造商:ANALOG 功能描述:NEW