- 您現在的位置：買賣IC網 > PDF目錄5410 > AD8039ART-REEL7 (Analog Devices Inc)IC OPAMP VF DUAL LP LN SOT23-8 PDF資料下載
參數資料
| 型號： | AD8039ART-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 7/17頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP VF DUAL LP LN SOT23-8 |
| 標準包裝： | 1 |
| 放大器類型： | 電壓反饋 |
| 電路數： | 2 |
| 轉換速率： | 425 V/µs |
| -3db帶寬： | 350MHz |
| 電流 - 輸入偏壓： | 400pA |
| 電壓 - 輸入偏移： | 500µV |
| 電流 - 電源： | 1mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 12 V，±1.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-8 |
| 供應商設備封裝： | SOT-23-8 |
| 包裝： | 標準包裝 |
| 其它名稱： | AD8039ART-REEL7DKR |
AD8038/AD8039
Rev. G | Page 14 of 16
APPLICATIONS INFORMATION
LOW POWER ADC DRIVER
8
1
0.1F
10F
0.1F
10F
+5V
7
0.1F
10F
–5V
3
2
6
5
4
AD8039
1k
VINP
VINN
REF
50
AD9203
1k
VIN
0V
3V
2.5V
02
95
1-
04
3
Figure 43. Schematic to Drive AD9203 with the AD8039
The AD9203 is a low power (125 mW on a 5 V supply), 40 MSPS
10-bit converter. As such, the low power, high performance
AD8039 is an appropriate amplifier choice to drive it.
In low supply voltage applications, differential analog inputs
are needed to increase the dynamic range of the ADC inputs.
Differential driving can also reduce second and other even-order
distortion products. The AD8039 can be used to make a dc-
coupled, single-ended-to-differential driver for driving these
ADCs. Figure 43 is a schematic of such a circuit for driving the
AD9203, 10-bit, 40 MSPS ADC.
The AD9203 works best when the common-mode voltage at the
input is at the midsupply or 2.5 V. The output stage design of
the AD8039 makes it ideal for driving these types of ADCs.
In this circuit, one of the op amps is configured in the inverting
mode, and the other is in the noninverting mode. However, to
provide better bandwidth matching, each op amp is configured
for a noise gain of +2. The inverting op amp is configured for a
gain of 1, and the noninverting op amp is configured for a gain
of +2. Each has a very similar ac response. The input signal to
the noninverting op amp is divided by 2 to normalize its voltage
level and make it equal to the inverting output.
The outputs of the op amps are centered at 2.5 V, which is the
midsupply level of the ADC. This is accomplished by first taking
the 2.5 V reference output of the ADC and dividing it by 2 with
a pair of 1 kΩ resistors. The resulting 1.25 V is applied to the
positive input of each op amp. This voltage is then multiplied by
the gain of the op amps to provide a 2.5 V level at each output.
LOW POWER ACTIVE VIDEO FILTER
Some composite video signals derived from a digital source
contain clock feedthrough that can limit picture quality. Active
filters made from op amps can be used in this application, but
they consume 25 mW to 30 mW for each channel. In power-
sensitive applications, this can be too much, requiring the use
of passive filters that can create impedance matching problems
when driving any significant load.
The AD8038 can be used to make an effective low-pass active
filter that consumes one-fifth of the power consumed by an
active filter made from an op amp. Figure 44 shows a circuit
that uses a AD8038 with ±2.5 V supplies to create a three-pole
Sallen-Key filter. This circuit uses a single RC pole in front of a
standard 2-pole active section.
0.1F
+2.5V
10F
–2.5V
0.1F
10F
C3
33pF
R3
49.9
RF
1
680pF
R5
75
R2
499
C1
100pF
R1
200
R4
49.9
AD8038
VIN
VOUT
02951-
044
Figure 44. Low-Pass Filter for Video
Figure 45 shows the frequency response of this filter. The
response is down 3 dB at 6 MHz; therefore, it passes the video
band with little attenuation. The rejection at 27 MHz is 45 dB,
which provides more than a factor of 100 in suppression of the
clock components at this frequency.
FREQUENCY (MHz)
0.1
GA
IN
(
d
B
)
110
–10
10
100
0
–20
–30
–40
–50
–60
02
95
1-
04
5
Figure 45. Video Filter Response
相關PDF資料 |
PDF描述 |
|---|---|
| 3413.0221.24 | FUSE 3.15A 63V 1206 FAST |
| 3413.0220.26 | FUSE 2.5A 63V 1206 FAST |
| 3413.0220.24 | FUSE 2.5A 63V 1206 FAST |
| 0713085440 | CONN HEADER BKWY SMD TIN 40POS |
| 3413.0219.26 | FUSE 2A 63V 1206 FAST |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8039ARTZ-R2 | 制造商:Analog Devices 功能描述:LOW POWER, 350 MHZ VOLTAGE FEEDBACK AMPL |
| AD8039ARTZ-REEL | 制造商:Analog Devices 功能描述:OP Amp Dual Volt Fdbk |
| AD8039ARTZ-REEL7 | 功能描述:IC OPAMP VF DUAL LP LN SOT23-8 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| AD8039ARZ | 功能描述:IC OPAMP VF DUAL LP LN 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| AD8039ARZ | 制造商:Analog Devices 功能描述:AMP DUAL VOLT FEEDBACK SMD 8039 |
發布緊急采購，3分鐘左右您將得到回復。