參數資料
| 型號： | AD8008AR |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/21頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP CF DUAL ULDIST LN 8SOIC |
| 標準包裝： | 98 |
| 放大器類型： | 電流反饋 |
| 電路數： | 2 |
| 轉換速率： | 1000 V/µs |
| -3db帶寬： | 650MHz |
| 電流 - 輸入偏壓： | 4µA |
| 電壓 - 輸入偏移： | 500µV |
| 電流 - 電源： | 9mA |
| 電流 - 輸出 / 通道： | 130mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 12 V，±2.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 管件 |
AD8007/AD8008
Rev. E | Page 15 of
20
THEORY OF OPERATION
The AD8007 (single) and AD8008 (dual) are current feedback
amplifiers optimized for low distortion performance. A simplified
conceptual diagram of the AD8007 is shown in Figure 51. It
closely resembles a classic current feedback amplifier comprised
of a complementary emitter-follower input stage, a pair of signal
mirrors, and a diamond output stage. However, in the case of
the AD8007/AD8008, several modifications were made to improve
the distortion performance over that of a classic current feedback
topology.
IDI
–
+VS
–VS
CJ1
CJ2
Q1
Q2
IN–
–
D1
D2
I1
I2
IN+
I3
I4
IDO
Q3
Q4
Q5
Q6
+VS
–VS
RF
OUT
RG
M2
M1
HIGH-Z
02
86
6-
05
1
Figure 51. Simplified Schematic of AD8007
The signal mirrors were replaced with low distortion, high
precision mirrors. In Figure 51, they are shown as M1 and M2.
Their primary function from a distortion standpoint is to reduce
the effect of highly nonlinear distortion caused by capacitances,
CJ1 and CJ2. These capacitors represent the collector-to-base
capacitances of the output devices of the mirrors.
A voltage imbalance arises across the output stage, as measured
from the high impedance node, high-Z, to the output node, OUT.
This imbalance is a result of delivering high output currents and
is the primary cause of output distortion. Circuitry is included
to sense this output voltage imbalance and generate a compensating
current, IDO. When injected into the circuit, IDO reduces the
distortion that could be generated at the output stage. Similarly, the
nonlinear voltage imbalance across the input stage (measured from
the noninverting to the inverting input) is sensed, and a current,
IDI, is injected to compensate for input-generated distortion.
The design and layout are strictly top-to-bottom symmetric to
minimize the presence of even-order harmonics.
USING THE AD8007/AD8008
Supply Decoupling for Low Distortion
Decoupling for low distortion performance requires careful
consideration. The commonly adopted practice of returning the
high frequency supply decoupling capacitors to physically separate
(and possibly distant) grounds can lead to degraded even-order
harmonic performance. This situation is shown in Figure 52 using
the AD8007 as an example; however, it is not recommended. For a
sinusoidal input, each decoupling capacitor returns to its ground a
quasi-rectified current carrying high even-order harmonics.
+VS
–VS
RG
499
RS
200
IN
RF
499
GND 1
GND 2
OUT
AD8007
+
10F
0.1F
02
86
6-
05
2
Figure 52. High Frequency Capacitors Returned to Physically Separate
Grounds (Not Recommended)
The decoupling scheme shown in Figure 53 is recommended.
In Figure 53, the two high frequency decoupling capacitors are
first tied together at a common node and are then returned to
the ground plane through a single connection. By first adding
the two currents flowing through each high frequency decoupling
capacitor, this ensures that the current returned into the ground
plane is only at the fundamental frequency.
+VS
–VS
RG
499
RS
200
IN
RF
499
OUT
AD8007
+
10F
0.1F
10F
0.1F
028
66
-05
3
Figure 53. High Frequency Capacitors Returned to Ground at a Single Point
(Recommended)
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2054HVMPS5#TRMPBF | IC OPAMP 0-DRIFT SGL LP TSOT23-5 |
| AD8042AR | IC OPAMP VF R-R DUAL LP 8SOIC |
| AD8557ACPZ-R2 | IC AMP CHOPPER 2MHZ 55MA 16LFCSP |
| AD8643ARZ-REEL | IC OPAMP JFET R-R 3.5MHZ 14SOIC |
| 2026-25-C13 | GAS DISCHARGE TUBE 3 POLE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8008AR-EBZ | 功能描述:BOARD EVAL FOR AD8008AR RoHS:是 類別:編程器，開發(fā)系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8008ARM | 制造商:Analog Devices 功能描述:OP Amp Dual Current Fdbk 制造商:Analog Devices 功能描述:OP Amp Dual Current Fdbk ±6V/12V 8-Pin MSOP Tube 制造商:Rochester Electronics LLC 功能描述:SOIC, AMP- DUAL ULTRA-LOW DIST. HI SPD - Bulk |
| AD8008ARM-EBZ | 功能描述:BOARD EVAL FOR AD8008ARM RoHS:是 類別:編程器，開發(fā)系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8008ARM-REEL | 功能描述:IC OPAMP CF DUAL ULDIST LN 8MSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:100 系列:- 放大器類型:通用 電路數:1 輸出類型:- 轉換速率:0.2 V/µs 增益帶寬積:- -3db帶寬:- 電流 - 輸入偏壓:100pA 電壓 - 輸入偏移:30µV 電流 - 電源:380µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):±2 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:管件 |
| AD8008ARM-REEL7 | 制造商:Analog Devices 功能描述:OP Amp Dual Current Fdbk 制造商:Analog Devices 功能描述:OP Amp Dual Current Fdbk ±6V/12V 8-Pin MSOP T/R |
發(fā)布緊急采購，3分鐘左右您將得到回復。