參數資料
型號: AD7985BCPZ
廠商: Analog Devices Inc
文件頁數: 14/28頁
文件大?。?/td> 0K
描述: IC ADC 16B 2.5MSPS PULSR 20LFCSP
標準包裝: 1
系列: PulSAR®
位數: 16
采樣率(每秒): 2.5M
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 33mW
電壓電源: 模擬和數字
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 20-VFQFN 裸露焊盤,CSP
供應商設備封裝: 20-LFCSP-VQ
包裝: 托盤
輸入數目和類型: 1 個偽差分,單極
產品目錄頁面: 780 (CN2011-ZH PDF)
AD7985
Rev. A | Page 21 of 28
CS MODE, 4-WIRE WITHOUT BUSY INDICATOR
This mode is usually used when multiple AD7985 devices are
connected to an SPI-compatible digital host. A connection dia-
gram example using two AD7985 devices is shown in Figure 30,
and the corresponding timing is given in Figure 31.
With SDI high, a rising edge on CNV initiates a conversion,
selects CS mode, and forces SDO to high impedance. In this
mode, CNV must be held high during the conversion phase
and the subsequent data readback. (If SDI and CNV are low,
SDO is driven low.) Prior to the minimum conversion time,
SDI can be used to select other SPI devices, such as analog multi-
plexers, but SDI must be returned high before the minimum
conversion time elapses and then held high for the maximum
possible conversion time to avoid the generation of the busy
signal indicator.
When the conversion is complete, the AD7985 enters the
acquisition phase and powers down. Each ADC result can be
read by bringing its SDI input low, which consequently outputs
the MSB onto SDO. The remaining data bits are then clocked by
subsequent SCK falling edges. The data is valid on both SCK
edges. Although the rising edge can be used to capture the data,
a digital host using the SCK falling edge allows a faster reading
rate, provided that it has an acceptable hold time. After the 16th
SCK falling edge, SDO returns to high impedance and another
AD7985 can be read.
AD7985
SDI
SDO
CNV
SCK
CONVERT
DATA IN
CLK
DIGITAL HOST
CS1
CS2
AD7985
SDI
SDO
CNV
SCK
07947-
013
Figure 30. CS Mode, 4-Wire Without Busy Indicator Connection Diagram
ACQUISITION (n)
ACQUISITION
(n – 1)
ACQUISITION
(n + 1)
1
2
BEGIN DATA (n – 1)
CONVERSION (n)
END DATA (n – 1)
SCK
CNV
SDO
14
15
CONVERSION (n – 1)
END DATA (n – 2)
tCONV
tDATA
0
(I/O QUIET
TIME)
(I/O QUIET
TIME)
16
14
15
16
1
15
14
13
2
0
1
2
SDI
(I/O QUIET
TIME)
tCYC
tACQ
tQUIET
tSCK
tDIS
tHSDO
tHSDICNV
tSSDICNV
tEN
tDSDO
tHSDO
tDATA
tCONV
07947-
014
Figure 31. CS Mode, 4-Wire Without Busy Indicator Serial Interface Timing
相關PDF資料
PDF描述
ICL3245ECAZ IC 3DRVR/5RCVR RS232 3V 28-SSOP
VI-J4L-MW-F3 CONVERTER MOD DC/DC 28V 100W
AD7820CQ IC ADC 8BIT HS TRACK/HOLD 20CDIP
AD7678ASTZ IC ADC 18BIT SAR 100KSPS 48-LQFP
AD9248BCPZ-20 IC ADC 14BIT DUAL 20MSPS 64LFCSP
相關代理商/技術參數
參數描述
AD7985BCPZ-RL7 功能描述:IC ADC 16B 2.5MSPS PULSR 20LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
AD7986 制造商:AD 制造商全稱:Analog Devices 功能描述:1 nV/√Hz, Low Power
AD7986BCPZ 功能描述:IC ADC 18BIT 2MSPS SAR 20LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率(每秒):20M 數據接口:并聯 轉換器數目:2 功率耗散(最大):155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP(7x7) 包裝:Digi-Reel® 輸入數目和類型:4 個單端,單極;2 個差分,單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
AD7986BCPZ-RL7 功能描述:IC ADC 18BIT 2MSPS SAR 20LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
AD7986BCPZ-U1 制造商:Analog Devices 功能描述:16-BIT, 10MSPS PULSAR DIFFERENTIAL ADC - Rail/Tube