參數資料
型號： AD7980BCPZ-RL7
廠商： Analog Devices Inc
文件頁數： 10/28頁
文件大小： 0K
描述： IC ADC 16BIT 1MSPS SAR 10LFCSP
標準包裝： 1
系列： PulSAR®
位數： 16
采樣率（每秒）： 1M
數據接口： DSP，MICROWIRE?，QSPI?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 9mW
電壓電源： 單電源
工作溫度： -40°C ~ 125°C
安裝類型： 表面貼裝
封裝/外殼： 10-WFDFN 裸露焊盤，CSP
供應商設備封裝： 10-LFCSP-WD（3x3）
包裝： 標準包裝
輸入數目和類型： 1 個偽差分，單極
其它名稱： AD7980BCPZ-RL7DKR
AD7980
Data Sheet
Rev. C | Page 18 of 28
CS MODE 3-WIRE WITH BUSY INDICATOR
This mode is usually used when a single AD7980 is connected
to an SPI-compatible digital host having an interrupt input.
The connection diagram is shown in Figure 33, and the
corresponding timing is given in Figure 34.
With SDI tied to VIO, a rising edge on CNV initiates a
conversion, selects the CS mode, and forces SDO to high
impedance. SDO is maintained in high impedance until the
completion of the conversion irrespective of the state of CNV.
Prior to the minimum conversion time, CNV can be used to
select other SPI devices, such as analog multiplexers, but CNV
must be returned low before the minimum conversion time
elapses and then held low for the maximum conversion time to
guarantee the generation of the busy signal indicator. When the
conversion is complete, SDO goes from high impedance to low.
With a pull-up on the SDO line, this transition can be used as an
interrupt signal to initiate the data reading controlled by the
digital host. The AD7980 then enters the acquisition phase and
powers down. The data bits are clocked out, MSB first, by
subsequent SCK falling edges. The data is valid on both SCK
edges. Although the rising edge can be used to capture the data,
a digital host using the SCK falling edge allows a faster reading
rate provided it has an acceptable hold time. After the optional
17th SCK falling edge or when CNV goes high, whichever is
earlier, SDO returns to high impedance.
If multiple AD7980s are selected at the same time, the SDO
output pin handles this contention without damage or induced
latch-up. Meanwhile, it is recommended to keep this contention
as short as possible to limit extra power dissipation.
06392-
017
AD7980 SDO
SDI
DATA IN
IRQ
DIGITAL HOST
CONVERT
CLK
VIO
47kΩ
CNV
SCK
Figure 33. 3-Wire CS Mode with Busy Indicator
Connection Diagram (SDI High)
06392-
018
tCONV
tCNVH
tCYC
AQUISITION
tACQ
tSCK
tSCKH
tSCKL
CONVERSION
SCK
CNV
SDI = 1
SDO
D15
D14
D1
D0
tHSDO
1
2
3
15
16
17
tDSDO
tDIS
Figure 34. 3-Wire CS Mode with Busy Indicator Serial Interface Timing (SDI High)
相關PDF資料
PDF描述
VE-J1N-MW-F4 CONVERTER MOD DC/DC 18.5V 100W
MAX9646EBS+TG45 IC COMPARATOR W/REF 4UCSP
MAX3086CSD+T IC TXRX RS485/422 10MBPS 14-SOIC
MAX9645EUK+T IC COMPARATOR W/REF SOT23-5
VE-J1N-MW-F2 CONVERTER MOD DC/DC 18.5V 100W
相關代理商/技術參數
參數描述
AD7980BRMZ 功能描述:ADC 16BIT 1MSPS 1.25LSB 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7980BRMZRL7 功能描述:ADC 16BIT 1MSPS LP 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
AD7980-EP 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit, 1 MSPS PulSAR ADC in MSOP QFN
AD7980SRMZ-EP 制造商:Analog Devices 功能描述:16-BIT, 1 MSPS PULSAR ADC IN MSOP/QFN - Rail/Tube
AD7980SRMZ-EP-RL7 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:ADC 16BIT 1MSPS LP 10-MSOP 制造商:Analog Devices 功能描述:CONVERTER - ADC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*