t12 PART IS IN " />
參數資料
型號： AD7904BRUZ
廠商： Analog Devices Inc
文件頁數： 16/32頁
文件大小： 0K
描述： IC ADC 8BIT 4CH 1MSPS 16-TSSOP
標準包裝： 96
位數： 8
采樣率（每秒）： 1M
數據接口： DSP，MICROWIRE?，QSPI?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 13.5mW
電壓電源： 單電源
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 16-TSSOP（0.173"，4.40mm 寬）
供應商設備封裝： 16-TSSOP
包裝： 管件
輸入數目和類型： 4 個單端，單極
產品目錄頁面： 779 (CN2011-ZH PDF)
配用： EVAL-AD79X4CBZ-ND - BOARD EVALUATION FOR AD79X4CBZ
Data Sheet
AD7904/AD7914/AD7924
Rev. C | Page 23 of 32
SCLK
DOUT
DIN
CS
14
16
1
14
16
1
t12
PART IS IN FULL
SHUTDOWN
PART BEGINS TO POWER UP ON
CS RISING EDGE AS PM1 = PM0 = 1
THE PART IS FULLY POWERED UP
ONCE
tPOWER UP HAS ELAPSED
CHANNEL IDENTIFIER BITS + CONVERSION RESULT
DATA IN TO CONTROL REGISTER
CONTROL REGISTER IS LOADED ON THE
FIRST 12 CLOCKS. PM1 = 1, PM0 = 1
TO KEEP THE PART IN NORMAL MODE, LOAD
PM1 = PM0 = 1 IN CONTROL REGISTER
03087-
021
Figure 21. Full Shutdown Mode Operation
SCLK
DOUT
DIN
CS
1
16
12
1
16
12
1
16
12
PART ENTERS
SHUTDOWN ON CS
RISING EDGE AS
PM1 = 0, PM0 = 1
PART BEGINS
TO POWER
UP ON CS
FALLING EDGE
PART IS FULLY
POWERED UP
PART ENTERS
SHUTDOWN ON CS
RISING EDGE AS
PM1 = 0, PM0 = 1
CHANNEL IDENTIFIER BITS + CONVERSION RESULT
INVALID DATA
DATA IN TO CONTROL REGISTER
CONTROL REGISTER IS LOADED ON THE
FIRST 12 CLOCKS, PM1 = 0, PM0 = 1
CONTROL REGISTER CONTENTS SHOULD
NOT CHANGE, WRITE BIT = 0
TO KEEP PART IN THIS MODE, LOAD PM1 = 0, PM0 = 1
IN CONTROL REGISTER OR SET WRITE BIT = 0
DUMMY CONVERSION
03087-
022
Figure 22. Auto Shutdown Mode Operation
POWERING UP THE AD7904/AD7914/AD7924
When supplies are first applied to the AD7904/AD7914/AD7924,
the ADC may power up in any of the operating modes of the
part. To ensure that the part is placed into the required operating
mode, the user should perform a dummy cycle operation as
The dummy conversion operation must be performed to place
the part into the desired mode of operation. To ensure that the
part is in normal mode, this dummy cycle operation can be
performed with the DIN line tied high, that is, the PM1 and
PM0 bits are set to 11 (depending on other required settings in
the control register). However, the minimum power-up time of
1 s must be allowed from the rising edge of CS, where the
control register is updated, before attempting the first valid
conversion. This power-up time allows for the possibility that
the part was initially powered up in shutdown mode.
If the desired mode of operation is full shutdown, one dummy
cycle is required after supplies are applied. In this dummy cycle,
the user simply sets the power management bits, PM1 and PM0,
to 10 and, upon the rising edge of CS at the end of that serial
transfer, the part enters full shutdown mode.
If the desired mode of operation after supplies are applied is
auto shutdown mode, two dummy cycles are required: the first
dummy cycle with DIN tied high, and the second to set the
power management bits, PM1 and PM0, to 01. On the second CS
rising edge after the supplies are applied, the control register
contains the correct information and the part enters auto
shutdown mode as programmed. If power consumption is of
critical concern, then in the first dummy cycle, the user can set
PM1 and PM0 to 10, that is, full shutdown mode, and then place
the part into auto shutdown mode in the second dummy cycle.
For illustration purposes, Figure 25 is shown with DIN tied
high on the first dummy cycle in this case.
Figure 23, Figure 24, and Figure 25 show the required dummy
cycles after supplies are applied for normal mode, full shutdown
mode, and auto shutdown mode, respectively.
相關PDF資料
PDF描述
LTC2483IDD#PBF IC ADC 16BIT I2C 10-DFN
LTC2482IDD#PBF IC ADC 16BIT 10-DFN
VI-B10-MY-B1 CONVERTER MOD DC/DC 5V 50W
VI-B4K-MY-B1 CONVERTER MOD DC/DC 40V 50W
LTC2433-1CMS#PBF IC ADC DIFF 16BIT 3WIRE 10-MSOP
相關代理商/技術參數
參數描述
AD7904BRUZ 制造商:Analog Devices 功能描述:IC 8BIT ADC SMD 7904 TSSOP16
AD7904BRUZ-REEL 功能描述:IC ADC 8BIT 4CH W/SEQ 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
AD7904BRUZ-REEL7 功能描述:IC ADC 8BIT 4CH W/SEQ 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
AD7904WYRUZ-REEL7 功能描述:IC ADC 8BIT 4CH W/SEQ 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
AD7908 制造商:AD 制造商全稱:Analog Devices 功能描述:8-Channel, 1 MSPS, 8-/10-/12-Bit ADCs with Sequencer in 20-Lead TSSOP
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*