參數資料
型號: AD7880CRZ-REEL
廠商: Analog Devices Inc
文件頁數: 15/16頁
文件大小: 0K
描述: IC ADC 12BIT MONO LP 24-SOIC
標準包裝: 1,000
位數: 12
采樣率(每秒): 66k
數據接口: 并聯
轉換器數目: 1
功率耗散(最大): 50mW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 24-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 24-SOIC W
包裝: 帶卷 (TR)
輸入數目和類型: 2 個單端,單極;2 個單端,雙極
AD7880
–8–
REV. 0
12
11.5
11
10.5
10
INPUT FREQUENCY – kHz
SAMPLE FREQUENCY = 61kHz
T = 25 C
A
15
30.5
EFFECTIVE
NUMBER
OF
BITS
Figure 13. Effective Number of Bits vs. Frequency
Total Harmonic Distortion (THD)
THD is the ratio of the rms sum of harmonics to the rms value
of the fundamental. For the AD7880, THD is defined as:
THD
= 20 log
V
2
2 +V
3
2 +V
4
2 +V
5
2 +V
6
2
V
1
(3)
where V1 is the rms amplitude of the fundamental and V2, V3,
V4, V5 and V6 are the rms amplitudes of the second through the
sixth harmonic. The THD is also derived from the FFT plot of
the ADC output spectrum.
Intermodulation Distortion
With inputs consisting of sine waves at two frequencies, fa and
fb, any active device with nonlinearities will create distortion
products at sum and difference frequencies of mfa
± nfb where
m, n = 0, 1, 2, 3, etc. Intermodulation terms are those for which
neither m nor n are equal to zero. For example, the second or-
der terms include (fa + fb) and (fa – fb), while the third order
terms include (2fa + fb), (2fa – fb), (fa + 2fb) and (fa – 2fb).
Using the CCIF standard where two input frequencies near the
top end of the input bandwidth are used, the second and third
order terms are of different significance. The second order terms
are usually distanced in frequency from the original sine waves,
while the third order terms are usually at a frequency close to
the input frequencies. As a result, the second and third order
terms are specified separately. The calculation of the inter-
modulation distortion is as per the THD specification where it is
the ratio of the rms sum of the individual distortion products to
the rms amplitude of the fundamental expressed in dBs. In this
case, the input consists of two, equal amplitude, low distortion,
sine waves. Figure 14 shows a typical IMD plot for the
AD7880.
Figure 14. IMD Plot
Peak Harmonic or Spurious Noise
Peak harmonic or spurious noise is defined as the ratio of the
rms value of the next largest component in the ADC output
spectrum (up to FS/2 and excluding dc) to the rms value of the
fundamental. Normally, the value of this specification will be
determined by the largest harmonic in the spectrum, but for
parts where the harmonics are buried in the noise floor the peak
will be a noise peak.
相關PDF資料
PDF描述
VI-222-IW-F4 CONVERTER MOD DC/DC 15V 100W
LTC1604CG#TR IC ADC 16BIT SAMPL SHTDWN 36SSOP
VE-2NX-MX-F3 CONVERTER MOD DC/DC 5.2V 75W
VI-222-IW-F3 CONVERTER MOD DC/DC 15V 100W
AD9238BSTZRL-65 IC ADC 12BIT DUAL 65MSPS 64LQFP
相關代理商/技術參數
參數描述
AD7883BN 制造商:Analog Devices 功能描述:ADC Single SAR 50ksps 12-bit Parallel 24-Pin SOIC W 制造商:Rochester Electronics LLC 功能描述:12 BIT A/D CONVERTER IC - Bulk
AD7883BR 制造商:Analog Devices 功能描述:ADC Single SAR 50ksps 12-bit Parallel 24-Pin SOIC W 制造商:Analog Devices 功能描述:ADC SGL SAR 50KSPS 12-BIT PARALLEL 24SOIC W - Rail/Tube 制造商:Rochester Electronics LLC 功能描述:12 BIT A/D CONVERTER IC - Bulk
AD7883BR-REEL 制造商:Analog Devices 功能描述:ADC Single SAR 50ksps 12-bit Parallel 24-Pin SOIC W T/R 制造商:Analog Devices 功能描述:ADC SGL SAR 50KSPS 12-BIT PARALLEL 24SOIC W - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:12 BIT A/D CONVERTER IC - Tape and Reel
AD7884AP 制造商:Analog Devices 功能描述:ADC Single 2-Step Flash 166ksps 16-bit Parallel 44-Pin PLCC 制造商:Rochester Electronics LLC 功能描述:16-BIT PARAL.SAMPL.ADC IC - Bulk
AD7884AP-REEL 制造商:Analog Devices 功能描述:ADC Single 2-Step Flash 166ksps 16-bit Parallel 44-Pin PLCC T/R 制造商:Rochester Electronics LLC 功能描述:16-BIT PARAL.SAMPL ADC IC - Tape and Reel