參數資料
型號: AD7787BRMZ-RL
廠商: Analog Devices Inc
文件頁數: 6/20頁
文件大?。?/td> 0K
描述: IC ADC 24BIT 2CH LP SIG 10MSOP
標準包裝: 3,000
位數: 24
采樣率(每秒): 120
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 225µW
電壓電源: 單電源
工作溫度: -40°C ~ 105°C
安裝類型: 表面貼裝
封裝/外殼: 10-TFSOP,10-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 10-MSOP
包裝: 帶卷 (TR)
輸入數目和類型: 1 個單端,單極;1 個單端,雙極;1 個差分,單極;1 個差分,雙極
AD7787
Data Sheet
Rev. A | Page 14 of 20
ADC CIRCUIT INFORMATION
OVERVIEW
The AD7787 is a low power ADC that incorporates an Σ-Δ
modulator, a buffer, and an on-chip digital filter intended for
the measurement of wide dynamic range, low frequency signals,
such as those in pressure transducers, weigh scales, and
temperature measurement applications.
The part has one differential input and one single-ended input. The
inputs can be operated in buffered or unbuffered mode. Buffering
the input channel means that the part can accommodate significant
source impedances on the analog input .The device requires an
external reference of 2.5 nominal. Figure 12 shows the basic
connections required to operate the part.
04477-0-006
IN+
10
F
0.1
F
IN–
OUT–
POWER
SUPPLY
OUT+
REFIN
SCLK
DIN
VDD
GND
AIN+
AIN–
AIN2
AD7787
MICROCONTROLLER
CS
DOUT/RDY
THERMISTOR
10k
Figure 12. Basic Connection Diagram
The output rate of the AD7787 (fADC) is user programmable
with the settling time equal to 2 × tADC. Normal mode rejection
is the major function of the digital filter. Table 12 lists the
available update rates from the AD7787. Simultaneous 50 Hz
and 60 Hz rejection is optimized when the update rate equals
16.6 Hz as notches are placed at both 50 Hz and 60 Hz with this
update rate (see Figure 6).
NOISE PERFORMANCE
Table 13 shows the output rms noise, rms resolution, and peak-
to-peak resolution (rounded to the nearest 0.5 LSB) for the
different update rates and input ranges for the AD7787. The
numbers given are for the bipolar input range with a reference
of 2.5 V. These numbers are typical and generated with a
differential input voltage of 0 V. The peak-to-peak resolution
figures represent the resolution for which there is no code
flicker within a six-sigma limit. The output noise comes from
two sources. The first is the electrical noise in the semiconductor
devices (device noise) used in the implementation of the
modulator. The second is quantization noise, which is added when
the analog input is converted into the digital domain. The device
noise is at a low level and is independent of frequency. The
quantization noise starts at an even lower level but rises rapidly
with increasing frequency to become the dominant noise source.
Table 13. Typical Peak-to-Peak Resolution
(Effective Resolution) vs. Update Rate
Update Rate
Peak-to-Peak
Resolution
Effective
Resolution
9.5
19.5
22
13.3
19
21.5
16.7
19
21.5
16.6
19
21.5
20
18.5
21
33.3
17.5
20
100
14.5
17
120
14
16.5
REDUCED CURRENT MODES
The AD7787 has a current consumption of 160 μA maximum
when operated with a 5 V power supply, the buffer enabled, and
the clock operating at its maximum speed. The clock frequency
can be divided by a factor of 2, 4, or 8 before being applied to
the modulator and filter, resulting in a reduction in the current
consumption of the AD7787. Bits CDIV1 and CDIV0 in the
filter register are used to enter these low power modes (see
When the internal clock is reduced, the update rate is also
reduced. For example, if the filter bits are set to give an update
rate of 16.6 Hz when the AD7787 is operated in full power
mode, the update rate equals 8.3 Hz in divide-by-2 mode. In the
low power modes, there may be some degradation in the ADC
performance.
Table 14. Low Power Mode Selection
CDIV[1:0]
Clock
Typ Current, Buffered (μA)
Typ Current, Unbuffered (μA)
50 Hz/60 Hz Rejection (dB)
00
1
146
75
65
10
1/2
87
45
64
10
1/4
56
30
75
11
1/8
41
25
86
相關PDF資料
PDF描述
MS3114E8-4P CONN RCPT 4POS JAM NUT W/PINS
D38999/26WJ61PBLC CONN HSG PLUG 61POS STRGHT PINS
MS3102R28-10S CONN RCPT 7POS BOX MNT W/SCKT
D38999/24JD5SNLC CONN HSG RCPT 5POS JAM NUT SCKT
MS3106R20-18S CONN PLUG 9POS STRAIGHT W/SCKT
相關代理商/技術參數
參數描述
AD7788 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, 16-/24-Bit Sigma-Delta ADC
AD7788ARM 功能描述:IC ADC 16BIT SIGMA-DELTA 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
AD7788ARM-REEL 功能描述:IC ADC 16BIT SIGMA-DELTA 10-MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
AD7788ARMZ 功能描述:IC ADC 16BIT SIGMA-DELTA 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7788ARMZ-REEL 功能描述:IC ADC 16BIT SIGMA-DELTA 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494