參數資料
型號: AD7769AN
廠商: ANALOG DEVICES INC
元件分類: ADC
英文描述: LC2MOS Analog I/O Port
中文描述: 2-CH 8-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, PDIP28
封裝: PLASTIC, DIP-28
文件頁數: 10/16頁
文件大?。?/td> 265K
代理商: AD7769AN
AD7769
–10–
REV. A
3. If
RD
is held low but
CS
is taken high during the conversion,
the device will be de-selected and DB0–DB7 will revert to
their high impedance state. T his will not affect completion of
the conversion, but the data cannot be read, or any other
operation performed, until
CS
is taken low again.
4. Note that the state of
RD
should not be changed during a
conversion.
Figure 11. Timing for ADC Channel Select and Conversion
Start
Figure 12. Timing for ADC Data Read
Figure 13. Timing for DAC Channel Select and Data Write
DIGIT AL SIGNAL PROCE SSING APPLICAT IONS
In Digital Signal Processing (DSP) application areas like voice
recognition, echo cancellation and adaptive filtering, the dy-
namic characteristics (SNR, Harmonic Distortion, Intermodula-
tion Distortion) of both the ADC and DACs are critical. T he
AD7769 is specified dynamically as well as with standard dc
specifications. Because the track/hold amplifier has a wide band-
width, an antialiasing filter should be placed on the V
IN
A and
V
IN
B inputs to avoid aliasing of high frequency noise back into
the bands of interest.
T he dynamic performance of the ADC is evaluated by applying
a sine wave signal of very low distortion to the V
IN
A or V
IN
B
input which is sampled at a 409.6 kHz sampling rate. A Fast
Fourier T ransform (FFT ) plot or Histogram plot is then gener-
ated from which SNR, harmonic distortion and dynamic differ-
ential nonlinearity data can be obtained. For the DACs, the
codes for an ideal sine wave are stored in PROM and loaded
down to the DAC. T he output spectrum is analyzed, using a
spectrum analyzer to evaluate SNR and harmonic distortion
performance. Similarly, for intermodulation distortion, an input
(either to VIN or DAC code) consisting of pure sine waves at
two frequencies is applied to the AD7769.
Figure 14 shows a 2048 point FFT plot of the ADC with an in-
put signal of 130 kHz. T he SNR is 49.2 dB. It can be seen that
most of the harmonics are buried in the noise floor. It should be
noted that the harmonics are taken into account when calculat-
ing the SNR. T he relationship between SNR and resolution (N)
is expressed by the following equation:
SNR = (6
.02
N
+ 1.76)
dB
Figure 14. ADC FFT Plot
相關PDF資料
PDF描述
AD7769AP LC2MOS Analog I/O Port
AD7769JN LC2MOS Analog I/O Port
AD7769JP LC2MOS Analog I/O Port
AD7773 LC MOS COMPLETE EMBEDDED SERVO FRONT ENDS FOR HDD
AD7775 LC MOS COMPLETE EMBEDDED SERVO FRONT ENDS FOR HDD
相關代理商/技術參數
參數描述
AD7769AP 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS Analog I/O Port
AD7769JN 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS Analog I/O Port
AD7769JP 制造商:Rochester Electronics LLC 功能描述:- Bulk
AD7769JP-REEL 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel
AD7769KN 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CODEC, Single