參數資料
型號: AD7766BRUZ
廠商: Analog Devices Inc
文件頁數: 11/25頁
文件大?。?/td> 0K
描述: IC ADC 24BIT 128KSPS SAR 16TSSOP
標準包裝: 1
位數: 24
采樣率(每秒): 128k
數據接口: 串行
轉換器數目: 1
功率耗散(最大): 18mW
電壓電源: 模擬和數字
工作溫度: -40°C ~ 105°C
安裝類型: 表面貼裝
封裝/外殼: 16-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 16-TSSOP
包裝: 管件
輸入數目和類型: 1 個差分,單極
產品目錄頁面: 779 (CN2011-ZH PDF)
配用: EVAL-AD7766EDZ-ND - BOARD EVAL AD7766 128KSPS 108DB
EVAL-AD7766-2EDZ-ND - BOARD EVAL AD7766-2 32KSPS 114DB
EVAL-AD7766-1EDZ-ND - BOARD EVAL AD7766-1 64KSPS 111DB
AD7766
Rev. C | Page 18 of 24
DAISY CHAINING
Daisy chaining devices allows numerous devices to use the same
digital interface lines by cascading the outputs of multiple ADCs
on a single data line. This feature is especially useful for reduc-
ing component count and wiring connections, for example, in
isolated multiconverter applications or for systems with a limited
interfacing capacity. Data readback is analogous to clocking a
shift register where data is clocked on the falling edge of SCLK.
The block diagram in Figure 36 shows how devices must be
connected to achieve daisy-chain functionality. The scheme
shown operates by passing the output data of the SDO pin of an
AD7766 device to the SDI input of the next AD7766 device in
the chain. The data then continues through the chain until it is
clocked onto the SDO pin of the first device in the chain.
READING DATA IN DAISY-CHAIN MODE
An example of a daisy chain of four AD7766 devices is shown in
Figure 36 and Figure 37. In the case illustrated in Figure 36, the
output of the AD7766 labeled A is the output of the full daisy
chain. The last device in the chain (the AD7766 labeled D) has
its serial data input (SDI) pin connected to ground. All the
devices in the chain must use common MCLK, SCLK, CS, and
SYNC/PD signals.
To enable the daisy-chain conversion process, apply a common
SYNC/PD pulse to all devices, synchronizing all the devices in
the chain (see the
section).
After applying a SYNC/PD pulse to all the devices, there is a
delay (as listed in
) before valid conversion data appears
at the output of the chain of devices. As shown in
, the
first conversion result is output from the AD7766 device labeled
A. This 24-bit conversion result is followed by the conversion
results from the devices labeled B, C, and D, with all conversion
results output in an MSB-first sequence. The stream of conversion
results is clocked through each device in the chain and is eventually
clocked onto the SDO pin of the AD7766 device labeled A. The
conversion results of all the devices in the chain must be clocked
onto the SDO pin of the final device in the chain while its
DRDY
signal is active low. This is illustrated in the examples shown
(
and
), where the conversion results from
the devices labeled A, B, C, and D are clocked onto SDO (A)
during the time between the falling edge of
DRDY (A) and the
rising edge of DRDY (A).
CHOOSING THE SCLK FREQUENCY
As shown in Figure 37, the number of SCLK falling edges that
occurs during the period when DRDY (A) is active low must
match the number of devices in the chain multiplied by 24 (the
number of bits that must be clocked through onto SDO (A) for
each device).
The period of SCLK (tSCLK) required for a known daisy-chain length
using a known common MCLK frequency must, therefore, be
established in advance. Note that the maximum SCLK frequency
is governed by t8 and is specified in Table 3 for different VDRIVE
voltages.
In the case where CS is tied logic low,
×
K
t
READ
SCLK
24
(1)
where:
K
is the number of AD7766/AD7766-1/AD7766-2 devices in
the chain.
tSCLK
is the period of the SCLK.
tREAD
equals tDRDY t5.
In the case where CS is used in the daisy-chain interface,
(
) (
)
×
+
K
t
13
7
6
READ
SCLK
24
(2)
where:
K
is the number of AD7766/AD7766-1/AD7766-2 devices in
the chain.
tSCLK
is the period of the SCLK.
tREAD
equals tDRDY t5.
Note that the maximum value of SCLK is governed by t8 and is
specified in Table 3 for different VDRIVE voltages.
相關PDF資料
PDF描述
AD7324BRUZ IC ADC 12BIT+ SAR 4CHAN 16TSSOP
AD7895ANZ-2 IC ADC 12BIT SRL 5V 8DIP
PX0941/04/S CONN BOX MOUNT 4POS W/SOCKETS
AD7707BRZ IC ADC 16BIT 3CHAN 20SOIC
VI-B51-IV-F4 CONVERTER MOD DC/DC 12V 150W
相關代理商/技術參數
參數描述
AD7766BRUZ-1 功能描述:IC ADC 24BIT 64KSPS SAR 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7766BRUZ-1-RL7 功能描述:IC ADC 24BIT 64KSPS SAR 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
AD7766BRUZ-2 功能描述:IC ADC 24BIT 32KSPS SAR 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7766BRUZ-2-RL7 功能描述:IC ADC 24BIT 32KSPS SAR 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
AD7766BRUZ-RL7 功能描述:IC ADC 24BIT 128KSPS SAR 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極