參數資料
型號： AD7715ANZ-3
廠商： Analog Devices Inc
文件頁數： 27/40頁
文件大小： 0K
描述： IC ADC 16BIT SIGMA-DELTA 16DIP
標準包裝： 25
位數： 16
采樣率（每秒）： 500
數據接口： DSP，MICROWIRE?，QSPI?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 9.5mW
電壓電源： 模擬和數字
工作溫度： -40°C ~ 85°C
安裝類型： 通孔
封裝/外殼： 16-DIP（0.300"，7.62mm）
供應商設備封裝： 16-PDIP
包裝： 管件
輸入數目和類型： 1 個差分，單極；1 個差分，雙極
配用： EVAL-AD7715-3EBZ-ND - BOARD EVALUATION FOR AD7715
AD7715
Rev. D | Page 33 of 40
AD7715 TO 8XC51 INTERFACE
An interface circuit between the AD7715 and the 8XC51
microcontroller is shown in Figure 12. The diagram shows the
minimum number of interface connections with CS on the
AD7715 hardwired low. In the case of the 8XC51 interface, the
minimum number of interconnects is just two. In this scheme,
the DRDY bit of the communications register is monitored to
determine when the data register is updated. The alternative
scheme, which increases the number of interface lines to three,
is to monitor the DRDY output line from the AD7715. The
monitoring of the DRDY line can be done in two ways. First,
DRDY can be connected to one of the 8XC51’s port bits (such
as P1.0) which is configured as an input. This port bit is then
polled to determine the status of DRDY. The second scheme
is to use an interrupt driven system in which case, the DRDY
output is connected to the INT1 input of the 8XC51. For
interfaces that require control of the CS input on the AD7715,
one of the port bits of the 8XC51 (such as P1.1), which is
configured as an output, can be used to drive the CS input.
The 8XC51 is configured in its Mode 0 serial interface mode. Its
serial interface contains a single data line. As a result, the
DOUT and DIN pins of the AD7715 should be connected
together with a 10 kΩ pull-up resistor. The serial clock on the
8XC51 idles high between data transfers. The 8XC51 outputs
the LSB first in a write operation while the AD7715 rearranged
before being written to the output serial register. Similarly, the
AD7715 outputs the MSB first during a read operation while
the 8XC51 expects the LSB first. Therefore, the data which is
read into the serial buffer needs to be rearranged before the
correct data word from the AD7715 is available in the
accumulator.
AD7715
DOUT
8XC51
DIN
SCLK
P3.0
P3.1
10k
RESET
DVDD
CS
08
51
9-
0
1
2
Figure 12. AD7715 to 8XC51 Interface
AD7715 TO ADSP-2103/ADSP-2105 INTERFACE
Figure 13 shows an interface between the AD7715 and the
ADSP-2103/ADSP-2105 DSP processor. In the interface shown,
the DRDY bit of the communications register is monitored to
determine when the data register is updated. The alternative
scheme is to use an interrupt driven system, in which case the
DRDY output is connected to the IRQ2 input of the ADSP-2103/
ADSP-2105. The serial interface of the ADSP-2103/ADSP-2105
is set up for alternate framing mode. The RFS and TFS pins
of the ADSP-2103/ADSP-2105 are configured as active low
outputs, and the ADSP-2103/ADSP-2105 serial clock line,
SCLK, is also configured as an output. The CS for the AD7715
is active when either the RFS or TFS outputs from the ADSP-
2103/ADSP-2105 are active. The serial clock rate on the ADSP-
2103/ADSP-2105 should be limited to 3 MHz to ensure correct
operation with the AD7715.
DVDD
AD7715
DOUT
ADSP-2103/
ADSP-2105
DIN
SCLK
RFS
DR
DT
TFS
SCLK
RESET
CS
08
51
9-
0
13
Figure 13. AD7715 to ADSP-2103/ADSP-2105 Interface
相關PDF資料
PDF描述
AD7716BSZ IC ADC 22BIT SIGMA-DELTA 44-MQFP
AD7718BRU-REEL7 IC ADC 24BIT R-R 8/10CH 28-TSSOP
AD7719BRZ IC ADC 16BIT 24BIT DUAL 28SOIC
AD7720BRU IC MODULATOR SIGMA-DELTA 28TSSOP
AD7721AR IC ADC 16BIT SIGMA-DELTA 28-SOIC
相關代理商/技術參數
參數描述
AD7715ANZ-31 制造商:AD 制造商全稱:Analog Devices 功能描述:3 V/5 V, 450 ??A 16-Bit, Sigma-Delta ADC
AD7715ANZ-5 功能描述:IC ADC 16BIT 5V 16-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7715ANZ-5 制造商:Analog Devices 功能描述:A/D Converter (A-D) IC
AD7715ANZ-51 制造商:AD 制造商全稱:Analog Devices 功能描述:3 V/5 V, 450 ??A 16-Bit, Sigma-Delta ADC
AD7715AR-3 功能描述:IC ADC 16BIT 3V 16-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*