參數資料
型號： AD7682BCPZ
廠商： Analog Devices Inc
文件頁數： 19/32頁
文件大?。?/td> 0K
描述： IC ADC 16BIT 4CH 250KSPS 20LFCSP
產品培訓模塊： Power Line Monitoring
產品變化通告： Startup Circuitry Design Improvement Change 15/April/2009
標準包裝： 1
系列： PulSAR®
位數： 16
采樣率（每秒）： 250k
數據接口： DSP，MICROWIRE?，QSPI?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 21mW
電壓電源： 模擬和數字
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 20-VFQFN 裸露焊盤，CSP
供應商設備封裝： 20-LFCSP-VQ
包裝： 托盤
輸入數目和類型： 8 個單端，單極；4 個差分，雙極；4 個偽差分，雙極
產品目錄頁面： 778 (CN2011-ZH PDF)
AD7682/AD7689
Data Sheet
Rev. D | Page 26 of 32
GENERAL TIMING WITHOUT A BUSY INDICATOR
Figure 37 details the timing for all three modes: read/write
during conversion (RDC), read/write after conversion (RAC),
and read/write spanning conversion (RSC). Note that the gating
item for both CFG and data readback is at the end of conversion
(EOC). At EOC, if CNV is high, the busy indicator is disabled.
As detailed previously in the Digital Interface section, the data
access should occur up to safe data reading/writing time, tDATA.
If the full CFG word was not written to prior to EOC, it is dis-
carded and the current configuration remains. If the conversion
result is not read out fully prior to EOC, it is lost as the ADC
updates SDO with the MSB of the current conversion. For
detailed timing, refer to Figure 40 and Figure 41, which depict
reading/writing spanning conversion with all timing details,
including setup, hold, and SCK.
When CNV is brought low after EOC, SDO is driven from high
impedance to the MSB. Falling SCK edges clock out bits starting
with MSB 1.
The SCK can idle high or low depending on the clock polarity
(CPOL) and clock phase (CPHA) settings if SPI is used. A simple
solution is to use CPOL = CPHA = 0 as shown in Figure 37 with
SCK idling low.
From power-up, in any read/write mode, the first three conver-
sion results are undefined because a valid CFG does not take
place until the 2nd EOC; thus two dummy conversions are
required. Also, if the state machine writes the CFG during the
power-up state (RDC shown), the CFG register needs to be
rewritten again at the next phase. Note that the first valid data
occurs in Phase (n + 1) when the CFG register is written during
Phase (n 1).
ACQUISITION
(n – 1) UNDEFINED
ACQUISITION
(n)
ACQUISITION
(n + 1)
ACQUISITION
(n + 2)
PHASE
POWER
UP
EOC
SOC
EOC
CONVERSION
(n – 1) UNDEFINED
CONVERSION
(n)
CONVERSION
(n + 1)
CONVERSION
(n – 2) UNDEFINED
07
35
3-
0
43
tCONV
tCYC
tDATA
CNV
DIN
SDO
XXX
MSB
XXX
MSB
XXX
NOTES
1. CNV MUST BE HIGH PRIOR TO THE END OF CONVERSION (EOC) TO AVOID THE BUSY INDICATOR.
2. A TOTAL OF 16 SCK FALLING EDGES ARE REQUIRED TO RETURN SDO TO HIGH-Z. IF CFG READBACK IS ENABLED, A TOTAL OF 30 SCK FALLING EDGES IS
REQUIRED TO RETURN SDO TO HIGH-Z.
DATA (n)
DATA (n – 1)
XXX
DATA (n – 1)
XXX
DATA (n – 1)
XXX
DATA (n – 1)
XXX
DATA (n – 2)
XXX
DATA (n – 2)
XXX
DATA (n – 2)
XXX
DATA (n – 2)
XXX
DATA (n – 3)
XXX
MSB
(n)
MSB
(n + 1)
DIN
SDO
DATA (n + 1)
DATA (n)
DATA (n + 1)
DIN
CFG (n)
CFG (n + 2)
CFG (n + 1)
CFG (n + 3)
SDO
SCK
116
16
NOTE 2
1
SCK
116
16
nn
n
n + 1
n
1
SCK
1
116
16
1
CFG (n)
CFG (n + 1)
CFG (n + 2)
RDC
RAC
RSC
CFG (n)
CFG (n + 1)
CFG (n + 2)
CFG (n + 3)
NOTE 2
NOTE 1
Figure 37. General Interface Timing for the AD7682/AD7689 Without a Busy Indicator
相關PDF資料
PDF描述
AD7794BRUZ IC ADC 24BIT SIG-DEL 6CH 24TSSOP
AD7689ACPZ IC ADC 16BIT 250KSPS 8CH 20LFCSP
LTC1598CG#PBF IC A/D CONV 12BIT SRL 8CH 24SSOP
KA339A IC COMPARATOR QUAD 14-DIP
KA339 IC COMPARATOR QUAD 14-DIP
相關代理商/技術參數
參數描述
AD7682BCPZRL7 功能描述:IC ADC 16BIT 4CH 250KSPS 20LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
AD7683 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit, 100 kSPS PulSAR ADC in MSOP/QFN
AD7683ACPZRL 功能描述:IC ADC 16BIT SRL 100KSPS 8LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
AD7683ACPZRL7 功能描述:IC ADC 16BIT 100KSPS 8LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
AD7683ARM 制造商:Analog Devices 功能描述:ADC Single SAR 100ksps 16-bit Serial 8-Pin MSOP Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*