- 您現在的位置：買賣IC網 > PDF目錄10289 > AD7476ABKSZ-500RL7 (Analog Devices Inc)IC ADC 12BIT 1MSPS LP SC70-6 PDF資料下載
參數資料
| 型號： | AD7476ABKSZ-500RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 18/29頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT 1MSPS LP SC70-6 |
| 設計資源： | Output Channel Monitoring Using AD5380 (CN0008) AD5382 Channel Monitor Function (CN0012) AD5381 Channel Monitor Function (CN0013) AD5383 Channel Monitor Function (CN0015) AD5390/91/92 Channel Monitor Function (CN0030) Power off protected data acquisition signal chain using ADG4612 , AD711, and AD7476 (CN0165) |
| 標準包裝： | 500 |
| 位數： | 12 |
| 采樣率（每秒）： | 1M |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 17.5mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 6-TSSOP，SC-88，SOT-363 |
| 供應商設備封裝： | SC-70-6 |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個單端，單極 |
| 配用： | EVAL-AD7476ACBZ-ND - BOARD EVALUATION FOR AD7476A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
AD7476A/AD7477A/AD7478A
Rev. F | Page 24 of 28
To implement the power-down mode, set SLEN to 0111 to issue
an 8-bit SCLK burst. The connection diagram is shown in
Figure 29. The ADSP-218x has the TFS and RFS of the SPORT
tied together, with TFS set as an output and RFS set as an input.
The DSP operates in alternate framing mode, and the SPORT
control register is set up as described. The frame synchronization
signal generated on the TFS is tied to CS, and, as with all signal
processing applications, equidistant sampling is necessary.
However, in this example, the timer interrupt is used to control
the sampling rate of the ADC and, under certain conditions,
equidistant sampling may not be achieved.
AD7476A/
AD7477A/
AD7478A1
SCLK
SDATA
CS
SCLK
DR
RFS
TFS
ADSP-218x1
1ADDITIONAL PINS OMITTED FOR CLARITY.
02930-029
Figure 29. Interfacing to the ADSP-218x
The timer registers, for example, are loaded with a value that
provides an interrupt at the required sample interval. When an
interrupt is received, a value is transmitted with TFS/DT (ADC
control word). The TFS controls the RFS and, thus, the reading
of data. The frequency of the serial clock is set in the SCLKDIV
register. When the instruction to transmit with TFS is given,
that is, TX0 = AX0, the state of the SCLK is checked. The DSP
waits until the SCLK has gone high, low, and high before
transmission starts. If the timer and SCLK values are chosen
such that the instruction to transmit occurs on or near the
rising edge of SCLK, the data can be transmitted or it can wait
until the next clock edge. For example, the ADSP-2111 has a
master clock frequency of 16 MHz. If the SCLKDIV register is
loaded with the Value 3, an SCLK of 2 MHz is obtained and
eight master clock periods will elapse for every one SCLK
period. If the timer registers are loaded with the Value 803,
100.5 SCLKs occur between interrupts and, subsequently,
between transmit instructions. This situation results in
nonequidistant sampling as the transmit instruction is
occurring on an SCLK edge. If the number of SCLKs between
interrupts is a whole integer figure of N, equidistant sampling is
implemented by the DSP.
AD7476A/AD7477A/AD7478A TO DSP563xx
INTERFACE
The connection diagram in Figure 30 shows how the
AD7476A/AD7477A/AD7478A can be connected to the SSI
(synchronous serial interface) of the DSP563xx family of DSPs
from Motorola. The SSI is operated in synchronous and normal
mode (SYN 1 = and MOD = 0 in Control Register B, CRB) with
internally generated word length frame sync for both Tx and Rx
(Bit FSL1 = 0 and Bit FSL0 = 0 in CRB). Set the word length in
Control Register A (CRA) to 16 by setting Bit WL2 = 0, Bit
WL1 = 1, and Bit WL0 = 0 for the AD7476A. The word length
for the AD7478A can be set to 12 bits (WL2 = 0, WL1 = 0, and
WL0 = 1). This DSP does not offer the option for a 14-bit word
length, so the AD7477A word length is set up to 16 bits, the
same as the AD7476A. For the AD7477A, the conversion process
uses 16 SCLK cycles, with the last two clock periods clocking out
two trailing zeros to fill the 16-bit word.
To implement the power-down mode on the AD7476A/AD7477A/
AD7478A, the word length can be changed to eight bits by setting
Bit WL2 = 0, Bit WL1 = 0, and Bit WL0 = 0 in CRA. The FSP
bit in the CRB register can be set to 1, meaning the frame goes
low and a conversion starts. Likewise, by means of the Bit SCD2,
Bit SCKD, and Bit SHFD in the CRB register, it establishes that
Pin SC2 (the frame sync signal) and Pin SCK in the serial port
are configured as outputs and the MSB is shifted first.
In summary:
MOD = 0
SYN = 1
WL2, WL1, and WL0 depend on the word length
FSL1 = 0 and FSL0 = 0
FSP = 1, negative frame sync
SCD2 = 1
SCKD = 1
SHFD = 0
Note that for signal processing applications, it is imperative that
the frame synchronization signal from the DSP563xx provide
equidistant sampling.
AD7476A/
AD7477A
AD7478A1
SDATA
SCLK
CS
DSP563xx1
SCK
SRD
SC2
1ADDITIONAL PINS OMITTED FOR CLARITY.
02930-030
Figure 30. Interfacing to the DSP563xx
相關PDF資料 |
PDF描述 |
|---|---|
| AD7352BRUZ-RL | IC ADC DUAL 12BIT 3MSPS 16TSSOP |
| LTC1407HMSE#TRPBF | IC ADC 12BIT 3MSPS 10-MSOP |
| LTC1854CG#PBF | IC ADC 12BIT 8CH 100KSPS 28SSOP |
| D38999/26MC4AA | CONN HSG PLUG 4POS STRGHT PINS |
| MS27468T13F4P | CONN RCPT 4POS JAM NUT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7476ABKSZ-REEL | 功能描述:IC ADC 12BIT 1MSPS SC70-6 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7476ABKSZ-REEL3 | 制造商:AD 制造商全稱:Analog Devices 功能描述:2.35 V to 5.25 V, 1 MSPS, 12-/10-/8-Bit ADCs in 6-Lead SC70 |
| AD7476ABKSZ-REEL7 | 功能描述:IC ADC 12BIT 1MSPS SC70-6 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| AD7476ABKSZ-REEL73 | 制造商:AD 制造商全稱:Analog Devices 功能描述:2.35 V to 5.25 V, 1 MSPS, 12-/10-/8-Bit ADCs in 6-Lead SC70 |
| AD7476ABRM | 功能描述:IC ADC 12BIT 2.35V 1MSPS 8-MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。