參數資料
型號： AD7357BRUZ-RL
廠商： Analog Devices Inc
文件頁數： 10/21頁
文件大?。?/td> 0K
描述： IC ADC 14BITDUAL 4.MSPS 16TSSOP
設計資源： DC-Coupled, Single-Ended-to-Differential Conversion Using AD8138 and AD7357 (CN0061)
標準包裝： 2,500
位數： 14
采樣率（每秒）： 4.2M
數據接口： DSP，MICROWIRE?，QSPI?，串行，SPI?
轉換器數目： 2
功率耗散（最大）： 59mW
電壓電源： 單電源
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 16-TSSOP（0.173"，4.40mm 寬）
供應商設備封裝： 16-TSSOP
包裝： 帶卷 (TR)
輸入數目和類型： 2 個差分，雙極
AD7357
Rev. B | Page 17 of 20
POWER-UP TIMES
The AD7357 has two power-down modes: partial power-
down and full power-down. There are described in detail in
sections. This section deals with the power-up time required
when coming out of either of these modes. It should be noted
that the power-up times apply with the recommended decoupling
capacitors in place on the REFA and REFB pins.
To power up from partial power-down mode, one dummy cycle
is required. The device is fully powered up after approximately
200 ns from the falling edge of CS has elapsed. Once the partial
power-up time has elapsed, the ADC is fully powered up and
the input signal is acquired properly. The quiet time, tQUIET, must
still be allowed from the point where the bus goes back into three-
state after the dummy conversion to the next falling edge of CS.
To power up from full power-down, approximately 6 ms should
be allowed from the falling edge of CS, shown in
as
tPOWER-UP2.
Note that during power-up from partial power-down mode, the
track-and-hold, which is in hold mode while the part is powered
down, returns to track mode after the first SCLK edge that the
part receives after the falling edge of CS.
When power supplies are first applied to the AD7357, the ADC
can power up in either of the power-down modes or in normal
mode. Because of this, it is best to allow a dummy cycle to elapse
to ensure that the part is fully powered up before attempting
a valid conversion. Likewise, if the part is to be kept in partial
power-down mode immediately after the supplies are applied,
then two dummy cycles must be initiated. The first dummy
cycle must hold CS low until after the 10th SCLK falling edge;
in the second cycle, CS must be brought high between the
second and 10th SCLK falling edges (see
).
Alternatively, if the part is to be placed into full power-down
mode when the supplies are applied, three dummy cycles must
be initiated. The first dummy cycle must hold CS low until after
the 10th SCLK falling edge; the second and third dummy cycles
place the part into full power-down mode (see
and
the
section).
POWER vs. THROUGHPUT RATE
The power consumption of the AD7357 varies with the
throughput rate. When using very slow throughput rates
and as fast an SCLK frequency as possible, the various power-
down options can be used to make significant power savings.
However, the AD7357 quiescent current is low enough that
even without using the power-down options, there is a noticeable
variation in power consumption with sampling rate. This is true
whether a fixed SCLK value is used or if it is scaled with the sam-
pling rate. Figure 29 shows a plot of power vs. throughput rate
when operating in normal mode for a fixed maximum SCLK
frequency and an SCLK frequency that scales with the sampling
rate. The internal reference was used for Figure 29.
10
14
18
22
26
30
34
38
0
1000
2000
3000
4000
THROUGHPUT (kSPS)
TO
T
A
L
P
O
WE
R
(
m
W)
80MHz SCLK
VARIABLE SCLK
07
75
7-
1
29
Figure 29. Power vs. Throughput Rate
相關PDF資料
PDF描述
SP3083EEN-L/TR IC TXRX RS485/RS422 ESD 14NSOIC
SP3081EEN-L/TR IC TXRX RS485/RS422 ESD 8NSOIC
SP3080EEN-L/TR IC TXRX RS485/RS422 ESD 14NSOIC
AD7661ACPZ IC ADC 16BIT W/REF 48LFCSP
SP3077EEN-L/TR IC TXRX RS485/RS422 ESD 8NSOIC
相關代理商/技術參數
參數描述
AD7357WYRUZ 制造商:Analog Devices 功能描述:ADC Dual SAR 4.2Msps 14-bit Serial 16-Pin TSSOP 制造商:Analog Devices 功能描述:14-BIT DUAL DIFF SIMULT 5 MSPS ADC I.C. - Rail/Tube 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:IC ADC 14BIT SRL 5MSPS 16TSSOP 制造商:Analog Devices 功能描述:Analog to Digital Converters - ADC 14-Bit Dual Diff Simult 5 MSPS 制造商:Analog Devices 功能描述:14-Bit Dual Diff Simult 5 MSPS ADC I.C.
AD7357WYRUZ-RL 功能描述:模數轉換器 - ADC 14-Bit Dual Diff Simult 5 MSPS RoHS:否 制造商:Analog Devices 通道數量: 結構: 轉換速率: 分辨率: 輸入類型: 信噪比: 接口類型: 工作電源電壓: 最大工作溫度: 安裝風格: 封裝 / 箱體:
AD7357YRUZ 功能描述:IC ADC DUAL14BIT 4.2MSPS 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極
AD7357YRUZ-500RL7 功能描述:IC ADC DUAL14BIT 4.2MSPS 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
AD7357YRUZ-RL 功能描述:IC ADC DUAL14BIT 4.2MSPS 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*