- 您現在的位置：買賣IC網 > PDF目錄8964 > AD7249ANZ (Analog Devices Inc)IC DAC 12BIT SRL W/REF 16-DIP PDF資料下載
參數資料
| 型號： | AD7249ANZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/14頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 12BIT SRL W/REF 16-DIP |
| 產品培訓模塊： | Data Converter Fundamentals DAC Architectures |
| 標準包裝： | 25 |
| 系列： | DACPORT® |
| 設置時間： | 10µs |
| 位數： | 12 |
| 數據接口： | 串行 |
| 轉換器數目： | 2 |
| 電壓電源： | 雙 ± |
| 功率耗散（最大）： | 300mW |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 16-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 16-PDIP |
| 包裝： | 管件 |
| 輸出數目和類型： | 2 電壓，單極；2 電壓，雙極 |
| 采樣率（每秒）： | 125k |
| 產品目錄頁面： | 784 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁
–6–
AD7249
Internal Reference
The AD7249 has an on-chip temperature compensated buried
Zener reference which is factory trimmed to 5 V
± 50 mV. The
reference voltage is provided at the REFOUT pin. This refer-
ence can be used to provide the reference voltage for the D/A
converter by connecting the REFOUT pin to the REFIN pin.
The reference voltage can also be used as a reference for other
components and is capable of providing up to 500
A to an
external load. The maximum recommended capacitance on
REFOUT for normal operation is 50 pF. If the reference output
is required to drive a capacitive load greater than 50 pF, then a
200
resistor should be placed in series with the capacitive
load. Figure 3 shows the suggested REF OUT decoupling
scheme, a 200
resistor and the parallel combination of a
10
F tantalum and a 0.1 F ceramic capacitor. This decoupling
scheme reduces the noise spectral density of the reference.
REFOUT
200
10 F
0.1 F
EXT LOAD
Figure 3. Reference Decoupling Scheme
External Reference
In some applications, the user may require a system reference or
some other external reference to drive the AD7249. References
such as the AD586 provide an ideal external reference source
(See Figure 10). The REFIN voltage is internally buffered by a
unity gain amplifier before being applied to the D/A converter.
The D/A converter is scaled for a 5 V reference and the device is
tested with 5 V applied to REFIN. Other reference voltages may
be used with degraded performance. Figure 4 shows the degra-
dation in linearity vs. REFIN.
REFIN – Volts
1.0
2
LINEARITY
ERROR
–
LSBs
0.9
0.8
0.7
0.6
0.5
0.4
0.3
0.2
0.1
0.0
3
4567
8
9
VDD = +15V
VSS = –15V
TA = +25 C
INL
DNL
Figure 4. Linearity vs. REFIN Voltage
Op Amp Section
The output of the voltage-mode D/A converter is buffered by a
noninverting CMOS amplifier. The ROFS input allows three
output voltage ranges to be selected. The buffer amplifier is
capable of developing +10 V across a 2 k
load to AGND.
The output amplifier can be operated from a single +15 V sup-
ply by tying VSS = 0 V.
The amplifier can also be operated from dual supplies to allow
an additional bipolar output range of –5 V to +5 V. Dual sup-
plies are necessary for the bipolar output range but can also be
used for the unipolar ranges to give faster settling time to volt-
ages near 0 V, to allow full sink capability of 2.5 mA over the
entire output range and to eliminate the effects of negative offsets
on the transfer characteristic (outlined previously). A plot of the
output sink capability of the amplifier is shown in Figure 5.
OUTPUT VOLTAGE – Volts
3
0
I SINK
–
mA
2
1
0
2
468
10
VSS = 0V
VSS = –15V
Figure 5. Amplifier Sink Current
FREQUENCY – Hz
500
50
nV/
Hz
100
200
500
1k
2k
5k
10k
VDD = +15V
VSS = 0V
TA = +25 C
200
100
50
20
0
REFERENCE DECOUPLING COMPONENTS ARE
A 200
RESISTOR IN SERIES WITH A PARALLEL
COMBINATION OF 10 F AND 0.1 F TO GND.
*
20k
50k
100k
REFERENCE
(NO DECOUPLING)
REFERENCE
(DECOUPLED*)
OUTPUT WITH ALL
0s ON DAC
Figure 6. Noise Spectral Density vs. Frequency
REV. D
相關PDF資料 |
PDF描述 |
|---|---|
| MS27508E24A4P | CONN RCPT 56POS BOX MNT W/PINS |
| D38999/24JE6PD | CONN RCPT 6POS JAM NUT W/PINS |
| AD7398BRUZ | IC DAC 12BIT QUAD SRL-IN 16TSSOP |
| MS27467T25F4SD | CONN PLUG 56POS STRAIGHT W/SCKT |
| VI-24Y-MU-F2 | CONVERTER MOD DC/DC 3.3V 132W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7249ANZ | 制造商:Analog Devices 功能描述:IC 12-BIT DAC |
| AD7249AR | 功能描述:IC DAC 12BIT SRL W/REF 16-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:DACPORT® 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| AD7249AR-REEL | 功能描述:數模轉換器- DAC LC2MOS DUAL 12-BIT SERIAL IC RoHS:否 制造商:Analog Devices 轉換器數量:4 DAC 輸出端數量:4 轉換速率: 分辨率:12 bit 接口類型:Serial (I2C) 穩定時間: 最大工作溫度:+ 105 C 安裝風格: 封裝 / 箱體:TSSOP 封裝:Reel |
| AD7249ARZ | 功能描述:IC DAC 12BIT SRL W/REF 16-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:DACPORT® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF) |
| AD7249ARZ | 制造商:Analog Devices 功能描述:IC 12-BIT DAC |
發布緊急采購，3分鐘左右您將得到回復。