- 您現在的位置：買賣IC網 > PDF目錄373893 > AD7111ABN (ANALOG DEVICES INC) ECONOLINE: REC2.2-S_DRW(Z)/H* - 2.2W DIP Package- 1kVDC Isolation- Regulated Output- 4.5-9V, 9-18V, 18-36V, 36-72V Wide Input Range 2 : 1- UL94V-0 Package Material- Continuous Short Circiut Protection- Cost Effective- 100% Burned In- Efficiency to 84% PDF資料下載
參數資料
| 型號： | AD7111ABN |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | DAC |
| 英文描述： | ECONOLINE: REC2.2-S_DRW(Z)/H* - 2.2W DIP Package- 1kVDC Isolation- Regulated Output- 4.5-9V, 9-18V, 18-36V, 36-72V Wide Input Range 2 : 1- UL94V-0 Package Material- Continuous Short Circiut Protection- Cost Effective- 100% Burned In- Efficiency to 84% |
| 中文描述： | PARALLEL, 8 BITS INPUT LOADING, 8-BIT DAC, PDIP16 |
| 封裝： | PLASTIC, DIP-16 |
| 文件頁數： | 6/8頁 |
| 文件大?。?/td> | 175K |
| 代理商： | AD7111ABN |
AD7111/AD7111A
REV. 0
–6–
For example, the AD7111L is guaranteed monotonic in 0.375 dB
steps from 0 dB to –54 dB inclusive and in 0.75 dB steps from
0 dB to –72 dB inclusive. T o achieve monotonic operation over
the entire 88.5 dB range it is necessary to select input codes so
that the attenuation step size at any point is consistent with the
step size guaranteed for monotonic operation at that point.
E QUIVALE NT CIRCUIT ANALY SIS
Figure 2 shows a simplified circuit of the D/A converter section
of the AD7111/AD7111A, and Figure 3 gives an approximate
equivalent circuit.
T he current source I
LEAK AGE
is composed of surface and junc-
tion leakages. T he resistor R
0
as shown in Figure 3 is the
equivalent output resistance of the device which varies with in-
put code (excluding all 0s code) from 0.8R to 2R. R is typically
12 k
. C
OUT
is the capacitance due to the N channel switches
and varies from about 20 pF to 50 pF depending upon the digi-
tal input. For further information on CMOS multiplying D/A
converters, refer to “CMOS DAC Application Guide” which is
available from Analog Devices, Publication Number
G872b–8–1/89.
Figure 2. Simplified D/A Circuit of AD7111/AD7111A
Figure 3. Equivalent Analog Output Circuit of
AD7111/AD7111A
DY NAMIC PE RFORMANCE
T he dynamic performance of the AD7111/AD7111A will depend
upon the gain and phase characteristics of the output amplifier,
together with the optimum choice of PC board layout and
decoupling components. Circuit layout is most important if the
optimum performance of the AD7111/AD7111A is to be
achieved. Most application problems stem from either poor lay-
out, grounding errors, or inappropriate choice of amplifier.
It is recommended that when using thc AD7111/AD7111A with
a high speed amplifier, a capacitor (C1) he connected in the
feedback path as shown in Figure 1. T his capacitor, which
should be between 10 pF and 30 pF, compensates for the phase
lag introduced by the output capacitance of the D/A converter.
Figures 4 and 5 show the performance of the AD7111/AD7111A
using the AD711, a high speed, low cost BiFET amplifier, and
the OP275, a dual, bipolar/JFET , audio amplifier. T he perfor-
mance without C1 is shown in the middle trace and the re-
sponse with C1 in circuit shown in the bottom trace.
10
90
100
0%
A1
–0.2V
200ns
5V
5V
V
OUT
V
OUT
C1 = 0pF
C1 = 15pF
DATA CHANGE
MSB
DATA CHANGE FROM 80H TO 00H.
Figure 4. Response of AD7111/AD7111A with AD711
10
90
100
0%
A1
200ns
5V
5V
V
OUT
V
OUT
C1 = 0pF
C1 = 15pF
DATA CHANGE
MSB
DATA CHANGE FROM 80H TO 00H.
0.4V
Figure 5. Response of AD7111/AD7111A with 1/2 OP275
In conventional CMOS D/A converter design, parasitic capaci-
tance in N-channel D/A converter switches can give rise to
glitches on the D/A converter output. T hese glitches result from
digital feedthrough. T he AD7111/AD7111A has been designed
to minimize these glitches as much as possible.
For operation beyond 250 kHz, capacitor C1 may be reduced in
value. T his gives an increase in bandwidth at the expense of a
poorer transient response as shown in Figures 5 and 11. In cir-
cuits where C1 is not included, the high frequency roll-off point
is primarily determined by the characteristics of the output am-
plifier and not the AD7111/AD7111A.
Feedthrough and absolute accuracy are sensitive to output leak-
age current effects. For this reason it is recommended that the
operating temperature of the AD7111/AD7111A be kept as
close to 25
°
C as is practically possible, particularly where the
device’s performance at high attenuation levels is important. A typi-
cal
plot of leakage current vs. temperature is shown in Figure 10.
Some solder fluxes and cleaning materials can form slightly con-
ductive films which cause leakage effects between analog
input and output. T he user is cautioned to ensure that the
manufacturing process for circuits using thc AD7111/AD7111A
does not allow such films to form. Otherwise the feedthrough,
accuracy and maximum usable range will be affected.
ST AT IC ACCURACY PE RFORMANCE
T he D/A converter section of the AD7111/AD7111A consists of
a 17-bit R-2R type converter. T o obtain optimum static perfor-
mance at this level of resolution it is necessary to pay great
attention to amplifier selection, circuit grounding, etc.
Amplifier input has current results in a dc offset at the output of
the amplifier due to the current flowing through the feedback
resistor R
FB
. It is recommended that an amplifier with an input
bias current of less than 10 nA be used (e.g., AD711) to mini-
mize this offset.
相關PDF資料 |
PDF描述 |
|---|---|
| AD7111ABR | LC2MOS LOGDAC Logarithmic D/A Converter |
| AD7111ACN | LC2MOS LOGDAC Logarithmic D/A Converter |
| AD7111ACR | ECONOLINE: REC2.2-S_DR/H1 - 2.2W DIP Package- 1kVDC Isolation- Regulated Output- UL94V-0 Package Material- Continuous Short Circiut Protection- Internal SMD design- 100% Burned In- Efficiency to 75% |
| AD7111BQ | ECONOLINE: REC2.2-S_DRW(Z)/H* - 2.2W DIP Package- 1kVDC Isolation- Regulated Output- 4.5-9V, 9-18V, 18-36V, 36-72V Wide Input Range 2 : 1- UL94V-0 Package Material- Continuous Short Circiut Protection- Cost Effective- 100% Burned In- Efficiency to 84% |
| AD7111CQ | LC2MOS LOGDAC Logarithmic D/A Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7111ABNZ | 功能描述:IC DAC LOGARITHMIC 16-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:LOGDAC® 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| AD7111ABR | 功能描述:IC DAC LOGARITHMIC 16-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:LOGDAC® 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| AD7111ABRZ | 功能描述:IC DAC MONO MULTIPLYING 16SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:LOGDAC® 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| AD7111ACN | 功能描述:IC DAC LOGARITHMIC 16-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:LOGDAC® 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| AD7111ACNZ | 功能描述:IC DAC MONO MULTIPLYING 16-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:LOGDAC® 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。