- 您現在的位置：買賣IC網 > Datasheet目錄38 > AD654JNZ/+ (Analog Devices Inc)IC CONV VOLT-FREQ 500KHZ 8DIP Datasheet資料下載
參數資料
| 型號： | AD654JNZ/+ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 354K |
| 描述： | IC CONV VOLT-FREQ 500KHZ 8DIP |
| 標準包裝： | 50 |
| 類型： | 電壓至頻率 |
| 頻率 - 最大： | 500kHz |
| 全量程： | ±50ppm/°C |
| 線性： | ±0.2% |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 8-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 8-PDIP |
| 包裝： | 管件 |
AD654
REV.
7
TWO-WIRE TEMPERATURE-TO-FREQUENCY
CONVERSION
Figure 8 shows the AD654 in a two-wire temperature-to-frequency
conversion scheme. The twisted pair transmission line serves the
dual purpose of supplying power to the device and also carrying
frequency data in the form of current modulation.
The positive supply line is fed to the remote V/F through a
140 & resistor. This resistor is selected such that the quiescent
current of the AD654 will cause less than one V
BE
to be dropped.
As the V/F oscillates, additional switched current is drawn through
R
L
when Pin 1 goes low. The peak level of this additional cur-
rent causes Q1 to saturate, and thus regenerates the AD654s
output square wave at the collector. The supply voltage to the
AD654 then consists of a dc level, less the resistive line drop, plus a
one V
BE
p-p square wave at the output frequency of the AD654.
This ripple is reduced by the diode/capacitor combination.
To set up the receiver circuit for a given voltage, the R
S
and R
L
resistances are selected as shown in Table I. CMOS logic stages
can be driven directly from the collector of Q1, and a single TTL
load can be driven from the junction of R
S
and R6.
Table I.
+V
S
R
S
() R
L
()
10 V
270
1.8k
15 V
680
2.7k
Table II.
(+V
S
) R1 ()R2 () R3 () R4 () R5 ()
K
10 V 100k 127k
F = 10 Hz/K
15 V 100k 127k
癈
10 V 6.49k 4.02k 1k 95.3k 22.6k
F = 10 Hz/癈
15 V 12.7k 4.02k 1k 78.7k 36.5k
癋
10 V 6.49k 4.42k 1k 154k 22.6k
F = 5.55 Hz/癋
15 V 12.7k 4.42k 1k 105k 36.5k
At the V/F end, the AD592C temperature transducer is inter-
faced with the AD654 in such a manner that the AD654 output
frequency is proportional to temperature. The output frequency
can be sealed and offset from K to 癈 or 癋 using the resistor
values shown in Table II. Since temperature is the parameter of
interest, an NPO ceramic capacitor is used as the timing capaci-
tor for low V/F TC.
When scaling per K, resistors R1R3 and the AD589 voltage
reference are not used. The AD592 produces a 1 礎/K current
output which drives Pin 3 of the AD654. With the timing
capacitor of 0.01 礔 this produces an output frequency scaled to
10 Hz/K. When scaling per 癈 and 癋, the AD589 and resistors
R1R3 offset the drive current at Pin 3 by 273.2 礎 for scaling
per 癈 and 255.42 礎 for scaling per 癋. This will result in fre-
quencies sealed at 10 Hz/癈 and 5.55 Hz/癋, respectively.
OPTOISOLATOR COUPLING
A popular method of isolated signal coupling is via optoelec-
tronic isolators, or optocouplers. In this type of device, the signal is
coupled from an input LED to an output photo-transistor, with
light as the connecting medium. This technique allows dc to be
transmitted, is extremely useful in overcoming ground loop
problems between equipment, and is applicable over a wide
range of speeds and power.
Figure 9 shows a general purpose isolated V/F circuit using a
low cost 4N37 optoisolator. A +5 V power supply is assumed for
both the isolated (+5 V isolated) and local (+5 V local) supplies.
The input LED of the isolator is driven from the collector out-
put of the AD654, with a 9 mA current level established by R1
for high speed, as well as for a 100% current transfer ratio.
5V
(ISOLATED)
R1
390
4N37
OPTO-ISOLATOR
5V
(LOCAL)
GRN
LED
OSC/
DRIVER
R
T
1k
V
IN
0V TO 1V)
C
T
1000pF
AD654
R3
270
74LS14
Q1
2N3904
R2
120
V/F OUTPUT
FS = 100kHz
TTL
ISOLATED LOCAL
Figure 9. Optoisolator Interface
OSC/
DRIVER
AD654
V
S
(10V TO 15V)
C
T
0.01F
f
=
I
T
(10V) C
T
R
T
1F
1N4148
R4
R5
R1
R2
R3
+
AD589
AD592
140
R
S
R6
220
Q1
2N3906
CMOS
OUTPUT
TTL
OUTPUT
(1 LOAD)
1A/k
Figure 8. Two-Wire Temperature-to-Frequency Converter
相關PDF資料 |
PDF描述 |
|---|---|
| AD7740YRM | IC CONVERTER V TO FREQ 8-MSOP |
| ADM1070ARTZ-REEL7 | IC CTRLR HOTSWAP -48V SOT23-6 |
| ADM1073ARU-REEL | IC CTRLR HOTSWAP -48V 14TSSOP |
| ADM4210-2AUJZ-RL7 | IC CTLR HOTSWAP LV TSOT23-6 |
| ADVFC32SH | IC CONV V/F F/V MONO TO100-10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD654JNZ/+ | 功能描述:IC CONV VOLT-FREQ 500KHZ 8DIP RoHS:是 類別:集成電路 (IC) >> PMIC - V/F 和 F/V 轉換器 系列:- 標準包裝:1 系列:- 類型:頻率至電壓 頻率 - 最大:10kHz 全量程:- 線性:±0.3% 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:Digi-Reel® 其它名稱:LM2917MX-8/NOPBDKR |
| AD654JR | 功能描述:IC V-F CONVERTER MONO 8-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - V/F 和 F/V 轉換器 系列:- 標準包裝:1 系列:- 類型:頻率至電壓 頻率 - 最大:10kHz 全量程:- 線性:±0.3% 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:Digi-Reel® 其它名稱:LM2917MX-8/NOPBDKR |
| AD654JR-REEL | 功能描述:IC V-F CONV MONO 500KHZ 8-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - V/F 和 F/V 轉換器 系列:- 標準包裝:1 系列:- 類型:頻率至電壓 頻率 - 最大:10kHz 全量程:- 線性:±0.3% 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:Digi-Reel® 其它名稱:LM2917MX-8/NOPBDKR |
| AD654JR-REEL7 | 功能描述:IC V-F CONVERTER MONO 8-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - V/F 和 F/V 轉換器 系列:- 標準包裝:1 系列:- 類型:頻率至電壓 頻率 - 最大:10kHz 全量程:- 線性:±0.3% 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:Digi-Reel® 其它名稱:LM2917MX-8/NOPBDKR |
| AD654JRZ | 功能描述:IC V-F CONVERTER MONO 8-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - V/F 和 F/V 轉換器 系列:- 標準包裝:1 系列:- 類型:頻率至電壓 頻率 - 最大:10kHz 全量程:- 線性:±0.3% 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:Digi-Reel® 其它名稱:LM2917MX-8/NOPBDKR |
發布緊急采購，3分鐘左右您將得到回復。