- 您現在的位置：買賣IC網 > PDF目錄375234 > AD598 (Analog Devices, Inc.) LVDT Signal Conditioner(線性可變差分變壓器信號調節器) PDF資料下載
參數資料
| 型號： | AD598 |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | LVDT Signal Conditioner(線性可變差分變壓器信號調節器) |
| 中文描述： | LVDT信號調節器（線性可變差分變壓器信號調節器） |
| 文件頁數： | 8/16頁 |
| 文件大?。?/td> | 565K |
| 代理商： | AD598 |
AD598
REV. A
–8–
13. Load current through R
L
returns to the junction of R5 and
R6, and flows back to V
PS
. Under maximum load condi-
tions, make sure the voltage drop across R5 is met as
defined in Step 12.
As a final check on the power supply voltages, verify that the
peak values of V
A
and V
B
are at least 2.5 volts less than the
voltages at +V
S
and –V
S
.
14. C5 is a bypass capacitor in the range of 0.1
μ
F to 1
μ
F.
EXC 1
EXC 2
LEV 1
LEV 2
FREQ 1
FREQ 2
B1 FILT
B2 FILT
OFFSET 1
OFFSET 2
SIG REF
SIG OUT
FEEDBACK
OUT FILT
A1 FILT
A2 FILT
R1
C2
AD598
C3
R2
C4
LVDT
SCHAEVITZ E100
R3
R4
0.1
μ
F
6.8
μ
F
SIGNAL
REFERENCE
30V
+
–V
S
R
L
V
OUT
+V
S
1
2
3
4
5
6
7
8
9
10
11
12
13
14
16
15
17
18
19
20
R5
R6
C5
C1
15nF
V
B
V
B
V
A
V
A
V
ps
Figure 12. Interconnection Diagram for Single
Supply Operation
Gain Phase Characteristics
To use an LVDT in a closed loop mechanical servo application,
it is necessary to know the dynamic characteristics of the trans-
ducer and interface elements. The transducer itself is very quick
to respond once the core is moved. The dynamics arise prima-
rily from the interface electronics. Figures 13, 14 and 15 show
the frequency response of the AD598 LVDT Signal Condi-
tioner. Note that Figures 14 and 15 are basically the same; the
difference is frequency range covered. Figure 14 shows a wider
range of mechanical input frequencies at the expense of accu-
racy. Figure 15 shows a more limited frequency range with en-
hanced accuracy. The figures are transfer functions with the
input to be considered as a sinusoidally varying mechanical posi-
tion and the output as the voltage from the AD598; the units of
the transfer function are volts per inch. The value of C2, C3 and
C4, from Figure 7, are all equal and designated as a parameter
in the figures. The response is approximately that of two real
poles. However, there is appreciable excess phase at higher fre-
quencies. An additional pole of filtering can be introduced with
a shunt capacitor across R2, (see Figure 7); this will also in-
crease phase lag.
When selecting values of C2, C3 and C4 to set the bandwidth of
the system, a trade-off is involved. There is ripple on the “dc”
position output voltage, and the magnitude is determined by the
filter capacitors. Generally, smaller capacitors will give higher
system bandwidth and larger ripple. Figures 16 and 17 show the
magnitude of ripple as a function of C2, C3 and C4, again all
equal in value. Note also a shunt capacitor across R2 shown as a
parameter (see Figure 7). The value of R2 used was 81 k
with
a Schaevitz E100 LVDT.
Figure 13. Gain and Phase Characteristics vs. Frequency
(0 kHz–10 kHz)
Figure 14. Gain and Phase Characteristics vs. Frequency
(0 kHz–50 kHz)
相關PDF資料 |
PDF描述 |
|---|---|
| AD600ARZ1 | Dual, Low Noise, Wideband Variable Gain Amplifiers |
| AD600ARZ-R7 | Dual, Low Noise, Wideband Variable Gain Amplifiers |
| AD600ARZ-RL | Dual, Low Noise, Wideband Variable Gain Amplifiers |
| AD600JNZ | Dual, Low Noise, Wideband Variable Gain Amplifiers |
| AD600JRZ1 | Dual, Low Noise, Wideband Variable Gain Amplifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD598A | 制造商:AD 制造商全稱:Analog Devices 功能描述:LVDT Signal Conditioner |
| AD598AD | 功能描述:IC LVDT SIGNAL COND 20-CDIP RoHS:否 類別:集成電路 (IC) >> 接口 - 傳感器和探測器接口 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:74 系列:- 類型:觸控式傳感器 輸入類型:數字 輸出類型:數字 接口:JTAG，串行 電流 - 電源:100µA 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:管件 |
| AD598AD | 制造商:Analog Devices 功能描述:SEMICONDUCTORS LINEAR |
| AD598J | 制造商:AD 制造商全稱:Analog Devices 功能描述:LVDT Signal Conditioner |
| AD598JR | 功能描述:IC LVDT SGNL COND OSC/REF 20SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 傳感器和探測器接口 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:74 系列:- 類型:觸控式傳感器 輸入類型:數字 輸出類型:數字 接口:JTAG，串行 電流 - 電源:100µA 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。